1 |
Two-Dimensional Analysis of Water-Filled Geomembrane Tubes Used as Temporary Flood-Fighting DevicesHuong, Tung Chun 24 February 2001 (has links)
A water-filled geomembrane tube is considered for the purpose of temporary flood protection. With proper design, this tube can be a cheap and efficient breakwater, temporary levee, or cofferdam. This thesis considers a single tube resting on clay and sand foundations.
A finite difference program, FLAC, is used in the numerical analyses. The tube is assumed to be infinitely long, and it is modeled two-dimensionally. Beam elements are used to model the tube. The tube is inflated with water. The hydrostatic pressure in the tube is converted to point loads and applied at the beam nodes in the direction perpendicular to the chord connecting two adjacent nodes.
Two of FLAC's built-in soil models are used: elastic and Mohr-Coulomb. The Mohr-Coulomb model is used in all the cases except the preliminary analyses, in which the elastic soil model is used. The Mohr-Coulomb soil model is able to model the soil's nonlinear stress-strain and path-dependent deformation behavior.
A tube without external water is placed on clay with various shear strengths to study how the clay consistency affects the height and the stresses in the tube. A tube with external water on one side is placed on medium dense sand. A wooden block is placed on the side opposite the floodwater. Three types of block geometry and two sizes are studied. The floodwater level is increased until the system fails. Three failure modes, rolling, sliding, and piping, are studied. The effect of pore pressure on these failure modes is examined. The influence of a filter placed under part of the tube and block is also investigated.
The tube's tensile forces, shear forces, moments, and settlements are included. Soil stresses and pore pressures at the soil-tube interfaces are computed. The cross-section of the tube at various external water levels, and the pore pressures in the soil, are calculated. These results are compared with experimental results that were obtained by graduate students in geotechnical engineering at Virginia Tech. / Master of Science
|
2 |
Two-Dimensional Vibrations of Inflated Geosynthetic Tubes Resting on a Rigid or Deformable FoundationCotton, Stephen Andrew 02 June 2003 (has links)
Geosynthetic tubes have the potential to replace the traditional flood protection device of sandbagging. These tubes are manufactured with many individual designs and configurations. A small number of studies have been conducted on the geosynthetic tubes as water barriers. Within these studies, none have discussed the dynamics of unanchored geosynthetic tubes.
A two-dimensional equilibrium and vibration analysis of a freestanding geosynthetic tube is executed. Air and water are the two internal materials investigated. Three foundation variations are considered: rigid, Winkler, and Pasternak. Mathematica 4.2 was employed to solve the nonlinear equilibrium and dynamic equations, incorporating boundary conditions by use of a shooting method.
General assumptions are made that involve the geotextile material and supporting surface. The geosynthetic material is assumed to act like an inextensible membrane and bending resistance is neglected. Friction between the tube and rigid supporting surface is neglected. Added features of viscous damping and added mass of the water were applied to the rigid foundation study of the vibrations about the freestanding equilibrium configuration.
Results from the equilibrium and dynamic analysis include circumferential tension, contact length, equilibrium and vibration shapes, tube settlement, and natural frequencies. Natural frequencies for the first four mode shapes were computed. Future models may incorporate the frequencies or combinations of the frequencies found here and develop dynamic loading simulations. / Master of Science
|
Page generated in 0.042 seconds