The thesis deals the preliminary draft of the small two-seat helicopter with a piston engine. The aim of the thesis is not to propose a helicopter across the extent of the problems. Therefore we have chosen only selected issues which can be managed in the range of work. The introduction is focused on defining the general requirements imposed on proposed helicopter, formulating the basic conceptual and structural design according to the building regulation the relevant category. These ranges create a based assumption for right evaluation of the statistical analysis of the helicopters of the same or very near parameters category. Subsequently, there were defined the basic parameters of the proposed helicopter which make possible to solve the performance characteristics in the vertical and backward flight. The work is also focused on design of the rotor head of main rotor for the proposed helicopter, the definition of load acting on the rotor head, waving analysis and calculation of centrifugal forces acting on the main rotor blades. The design of the rotor head and also the helicopter as a whole will be graphically processed in the program Dassault Systemes Catia.

Extensive disturbance rejection methods have been established for time-invariant systems. However, the development of these techniques has not focused on application to time-periodic systems in particular until recently. The filtered-X LMS algorithm is regarded as the best disturbance rejection technique for aperiodic systems by many, as has been proven in the acoustics industry for rejecting unwanted noise. Since this is essentially a feedforward approach, we might expect its performance to be good with respect to time-periodic systems in which the disturbance frequency is already known. The work presented in this thesis is an investigation of the performance of the filtered-X LMS algorithm for disturbance rejection in time-periodic systems. Two cases are examined: a generalized linear, time-periodic system and the helicopter rotor blade in forward flight. Results for the generalized system show that the filtered-X LMS algorithm does converge for time-periodic disturbance inputs and can produce very small errors. For the helicopter rotor blade system the algorithm is shown to produce very small errors, with a 96%, or 14 dB, reduction in error from the open-loop system. The filtered-X LMS disturbance rejection technique is shown to provide a successful means of rejecting timeperiodic disturbances for time-periodic systems. / Master of Science

New helicopter rotor designs are desired that offer increased efficiency, reduced vibration, and reduced noise. This problem is multidisciplinary, requiring knowledge of structural dynamics, aerodynamics, and aeroacoustics. Rotor optimization requires achieving multiple, often conflicting objectives. There is no longer a single optimum but rather an optimal trade-off space, the Pareto Frontier. Rotor Designers in industry need methods that allow the most accurate simulation tools available to search for Pareto designs. Computer simulation and optimization of rotors have been advanced by the development of "comprehensive" rotorcraft analysis tools. These tools perform aeroelastic analysis using Computational Structural Dynamics (CSD). Though useful in optimization, these tools lack built-in high fidelity aerodynamic models. The most accurate rotor simulations utilize Computational Fluid Dynamics (CFD) coupled to the CSD of a comprehensive code, but are generally considered too time consuming where numerous simulations are required like rotor optimization. An approach is needed where high fidelity CFD/CSD simulation can be routinely used in design optimization. This thesis documents the development of physics based rotor simulation frameworks. A low fidelity model uses a comprehensive code with simplified aerodynamics. A high fidelity model uses a parallel processor capable CFD/CSD methodology. Both frameworks include an aeroacoustic simulation for prediction of noise. A synergistic process is developed that uses both frameworks together to build approximate models of important high fidelity metrics as functions of certain design variables. To test this process, a 4-bladed hingeless rotor model is used as a baseline. The design variables investigated include tip geometry and spanwise twist. Approximation models are built for high fidelity metrics related to rotor efficiency and vibration. Optimization using the approximation models found the designs having maximum rotor efficiency and minimum vibration. Various Pareto generation methods are used to find frontier designs between these two anchor designs. The Pareto anchors are tested in the high fidelity simulation and shown to be good designs, providing evidence that the process has merit. Ultimately, this process can be utilized by industry rotor designers with their existing tools to bring high fidelity analysis into the preliminary design stage of rotors.