A numerical case study of a multistage compressor with relative supersonic rotors is presented. The purpose of the investigation was to determine the flow instability mechanism of the UEET compressor and its relation to the rotor shock structure in the relative velocity reference frame. The computational study was conducted with the NASA code ADPAC , utilizing the mixing-plane assumption for the boundary condition between adjacent, relatively-rotating blade rows. A steady, five-blade-row, numerical simulation using the Baldwin-Lomax turbulence model was performed, creating several constant speed lines. The results are presented, highlighting the role shock structure plays in the stability of the compressor. The shock structure in the downstream rotor isolates the upstream rotor from the exit conditions until the shock detaches from the leading edge. At this point the shock structure in the upstream rotor moves, changing the conditions for the downstream rotor. This continues with increasing pressure at the exit until the shock in the upstream rotor detaches from the leading edge. This event causes an instantaneous drop in the mass flow rate, initiating positive incident separation on the suction side of stator-two. / Master of Science

"A flow control method for minimizing losses in a highly loaded compressor blade was analyzed. Passive and active flow control experiments with vortex generator jets were conducted on a seven blade linear compressor cascade to demonstrate the potential application of passive flow control on a highly loaded blade. Passive flow control vortex generator jets use the pressure distribution generated by air flow over the blade profile to drive jets from the pressure side to the suction side. Active flow control was analyzed by pressuring the blade plenum with an auxiliary compressor unit. Active flow control decreased profile losses by approximately 37 % while passive flow control had negligible impact on the profile loss of a highly loaded blade. Passive flow control was able to achieve a jet velocity ratio, jet velocity to upstream velocity, of 0.525. The success of active flow control with a velocity ratio of 0.9 suggests there is potential for passive flow control to be effective. The research presented in this thesis is motivated by the potential savings in the applications of passive flow control in gas turbine axial compressors by increasing the aerodynamic load of each stage. Increased stage loading that is properly controlled can reduce the number of stages required to achieve the desired pressure compression ratio."