Two kinds of earthquakes, interplate and intraplate, occur in the world. Interplate earthquakes occur at the plate boundaries and are common. Intraplate earthquakes occur within the stable continental land mass and are less common. Fatality models have been developed by a number of different research groups in the last decades to estimate losses in these types of events. This is a relatively new research area, with the added problem that a fatal event only occurs every fortnight or so, so that the data collection process is long term. This research study has two objectives; the first is to update the Generalized Poissonian distribution parameters for the period 2000 to 2009. The second is to establish the statistical properties of the set of fatal earthquakes for the world, for the interplate region, and intraplate region in the last decade and for the twentieth century. This work has not been previously completed and represents a potential insight into the cost effectiveness of current earthquake mitigation schemes. The key hypothesis is that fatal interplate earthquakes occur at a higher rate than fatal intraplate events. The results of the two analyses show that there is an increase in the average number of earthquakes and the average number of deaths caused by these earthquakes for this decade, indicating this decade has proved to be worse when compared to the earlier recorded earthquake period data. There was a total of 202 recorded fatal events in the period of 2000 to 2009. The interplate earthquakes proved to cause more fatalities compared to intraplate earthquakes during the past decade. The difference at the five percent confidence level is significant.

Northeast Japan experienced an approximately constant, compressional deformation during the last 5 million years resulting from the steady subduction of the Pacific plate. Because the direction of the maximum compression axis is approximately perpendicular to the strike of the island arc, 2-D finite-element modeling can be used to examine the deformation over time of the island-arc lithosphere. The model geometry is based on geophysical and geological data, and each model run requires an assumed rheology and interplate coupling. Novel to our modeling is the ability to include erosion/deposition loading and the creation of strike-slip faults, based on a dynamically-applied fracture criterion. The criterion for acceptability is how well a model matches observed present-day topography, gravity, and seismicity patterns. Results given below are for models that satisfy this criterion. The long-term effective elastic thickness is 10 km in the inner arc, increasing to about 50 km near the trench. The effective elastic thickness in the inner arc is therefore much smaller than the about 30 km short-term elastic thickness estimated from seismological data. The viscosity of the lower crust is on the order of 1022 Pa s or less. The strength of interplate coupling off Sanriku is about two to four times greater than off Miyagi, and there is about twice as strong a coupling at greater depths. The relative strength of coupling correlates well with the observed interplate seismicity. Hence the inferred weaker coupling off Miyagi indicates a lack of seismogenic potential -- a low probability for large earthquakes in that region, not just a long return cycle. The same modeling procedure was also applied to southwest Japan. The viscosity of the lower crust is not more than 1021 Pa s, and the elas tic thickness is about 10 km. The calculated strength of interplate coupling for southwest Japan is about 1.5 times greater than for the off-Sanriku region in northeast Japan, which correlates well with the fact that there have been great (M>8) earthquakes in the Nankai Trough region, but none that large in the off-Sanriku region. / Ph. D.

No description available.

The earth was shown in the last century to have a surface layer composed of large plates. Plate tectonics is the study of the movement and stresses in the individual plates that make up the complete surface of the world's sphere. Two types of earthquakes are observed in the surface plates, interplate and intraplate earthquakes, which are classified, based on the location of the origin of an earthquake either between two plates or within the plate respectively. Limited work has been completed on the definition of the boundary region between the plates from which interplate earthquakes originate, other than the recent work on the Mid Atlantic Ridge, defined at two degrees and the subsequent work to look at the applicability of this degree based definition. Others suggested an alternative view of a constant width for the interplate region in recent work at Texas A&M University. The objective of the paper is to determine whether the assumption of a linear width of the region along the tectonic plate boundaries to classify earthquakes as interplate and intraplate earthquakes using accepted statistical criteria provides a better fit to the data than the constant degree definition. There are three types of interplate boundaries defined by the relative movement of the two plates to each other, which further complicates this study. The study used a nonrandom analysis of regions of the different types of boundary to compare the rate and decay of the intraplate earthquakes from a notional centerline for the known boundaries. The study used GIS software and EXCEL for the statistical analysis component of the research work. The results show that a constant width definition provides a number of advantages in determining the relative definition of interplate and intraplate earthquakes when compared to the constant degree definition developed for work on the Mid Atlantic Ridge. Further research is suggested on a randomly selected set of study sites to improve the reliability and quality of the statistical work for each type of the boundary of the tectonic plates.