In the study the influence of different dental technical tools on the surface temperature and phase composition of fixed dental prostheses (FDPs) made of yttria-partially stabilized zirconia polycrystals (3Y-/4Y-/5Y-PSZ) was investigated. FDPs were fabricated by using computer-aided manufacturing (CAM). The FDPs were treated with a contra-angle handpiece equipped with different burs and polishers. The resulting surface temperatures were measured with a thermographic camera, and the resulting phase transformations were investigated by X-ray diffraction and quantified by Rietveld refinement. Processing with burs resulted in no phase transformation, but a preferred orientation shift. Using coarse polisher induced a phase transformation to the rhombohedral phase, while fine polishers produced no relevant phase transformations and no preferred orientation shift. Compared to the monoclinic phase (ca. 9% theoretical volume increase), which is associated with low-temperature degradation (LTD), the rhombohedral phase is much more voluminous (ca. 15% theoretical volume increase) and distorted and, therefore, has a greater degradation potential.

The rapid growth in additive manufacturing technologies have brought various optimization techniques and methodologies to improve each phase that needs to be integrated and analyzed on system level to optimize the system performance. The challenges and limitations of each phase affect the system when integrated as a whole - creating a complex manufacturing environment that needs to be critically examined and managed. To have a better management of complex, emergent, and uncertain manufacturing system from design to recycling phase, a new way of thinking based on more holistic approach is necessary. In this paper, the system of systems paradigm (SoS) is introduced to treat additive manufacturing system as a whole and to present some SoS approaches that are based on holistic thinking. This paper provides a conceptual knowledge of SoS approach using systems principles, laws and approach emphasizing the characteristics and attributes of complex manufacturing system to the AM domain.

This PhD project investigated the ramifications of air-cured and nitrogen-cured manufacturing processes during silicone hydrogel contact lens manufacture in terms of lens surface characterisation and clinical performance. A one-hour contralateral clinical study was conducted for ten subjects to compare the clinical performance of the two study lenses. The main clinical findings were reduced levels of subjective performance, reduced surface wettability and increased deposition. Contact angle analysis showed the air-cured lenses had consistently higher advancing and receding contact angle measurements, in comparison with the nitrogen-cured lens. Chemical analysis of the study lens surfaces in the dehydrated state, by x-ray photoelectron spectroscopy (XPS) and time-of-flight mass spectrometry (ToF-SIMS), showed no difference due to surface segregation of the silicone components. Analysis of frozen lenses limited surface segregation and showed a higher concentration of silicone polymer components and lower concentration of hydrophilic polymer components at the surface of the air-cured lens, in comparison with the nitrogen-cured lens. Scanning electron microscope (SEM) imaging showed the nitrogen-cured lens to have a surface typical of a hydrogel material, whereas the air-cured lens had regions of apparent phase separation. In addition, atomic force microscopy (AFM) showed the air-cured lens to have a rougher surface associated with greater adherence of contaminants (often observed in materials with reduced polymer cross-linking). In conclusion, clinical assessment of the study lenses confirmed the inferior performance of the air-cured lens. Surface analysis suggested that the non-wetting regions on the air-cured lenses were associated with elevated level of silicone components, reduced polymer cross-linking and polymer phase separation.