Voiced communication plays a fundamental role in society. Voice research seeks to improve understanding of the fundamental physics governing voice production, with the eventual goal of improving methods to diagnose and treat voice disorders. For this thesis, three different aspects of voice production research were studied. First, porcine vocal fold medial surface geometry was determined, and the three-dimensional geometric distortion induced by freezing the larynx, especially in the region of the vocal folds, was quantified. It was found that porcine vocal folds are qualitatively geometrically similar to canine and human vocal folds, as well as commonly used models, and that freezing of tissue in the larynx causes distortion of around 5%. Second, a setup of multiple high-resolution cameras and a stereo-endoscopy system simultaneously recorded positions on the superior surface of synthetic, self-oscillating vocal fold models to estimate the error in the measurement of the three-dimensional location by the stereo-endoscopy system. The error was found to be low in the transverse plane, whereas the error was relatively large in the inferior-superior direction, suggesting that the stereo-endoscope is applicable for in vivo measurements of absolute distances of the glottis in the transverse plane such as glottal length, width, and area. Third, a function for strain-varying Poisson's ratio for silicone was developed from experimental data. It is anticipated that the findings herein can aid voice researchers as they study voice production, leading to improved voice care.

The voice is the primary mode of communication for humans. Because the voice is so important, voice disorders tend to severely diminish quality of life. A better understanding of the physics of voice production can help to improve treatment of voice disorders. For this thesis research a self-oscillating synthetic vocal fold model was developed, compared with previous synthetic vocal fold models, and used to explore the physical effects of augmentation injections on vibration dynamics. The research was conducted in two stages. First, four vocal fold models were evaluated by quantifying onset pressure, frequency, maximum glottal gap, flow rate, and medial surface motion. The newly developed model, differentiated from the other models by the inclusion of more layers, adjusted geometry, and an extremely soft superficial lamina propria layer, was included in this study. One of the models, created using MRI-derived geometry, had the most defined mucosal wave. The newly-developed model had the lowest onset pressure, flow rate, and smallest maximum glottal width, and the model motion compared very well with published excised human larynx data. Second, the new model was altered to simulate bowing by decreasing the volume of the body layer relative to that of a normal, unbowed model. Two models with varying degrees of bowing were created and tested while paired with normal models. Pre- and post-injection data (onset pressure, vibration frequency, glottal flow rate, open quotient, and high-speed image sequences) were recorded and compared. General pre- to post-injection trends included decreased onset pressure, glottal flow rate, and open quotient, and increased vibration frequency. Additionally, there was a decrease in mucosal wave velocity and an increase in phase angle. The thesis results are anticipated to aid in better understanding the physical effects of augmentation injections, with the ultimate goal of obtaining more consistent surgical outcomes, and also to contribute to the advancement of voice research through the development of the new synthetic model.