The main objective of this thesis is to understand molecular crystallization as a multistep process with or without polymeric additives, including transient liquid-liquid phase separation, nanocrystal nucleation within the dense phase, and subsequent nanocrystal self-assembly or self-organization in sequence. The thesis starts with a quaternary model system, containing DL-Glutamic acid (Glu), polyethyleneimine (PEI), water, and EtOH, for the understanding of multistep precipitation of Glu with PEI as an additive. The experiments were performed by mixing Glu-PEI aqueous solution with a non-solvent EtOH. First, the phase diagram of the quaternary system is determined, obtaining precipitate, coacervates, or homogeneous mixtures by varying Glu/PEI w/w and water/EtOH v/v. Coacervation is observed to occur over a wide range of Glu/PEI with various volumes. The composition of coacervates is conveniently characterized by nuclear magnetic resonance spectroscopy. The observed coacervates are thermodynamically stable phases rich in solute, which is different from metastable polymer-induced liquid precursors. The combination of atomic force microscopy, small angle scattering, and ξ-potential measurements confirms the coexistence of monomers and Glu/PEI complexes and the aggregation of complexes in Glu-PEI-water systems. This suggests that there might be a direct structural transformation between the Glu-PEI complexes in aqueous solution and the metastable liquid precursors in a water-EtOH mixture. The multistep mechanism of Glu precipitation with PEI as an additive is investigated thereafter. The combination of stopped flow and small angle scattering demonstrates that the initially formed liquid precursors pass through an alteration of growth and coalescence. Combined with results from optical microscopy and scanning electron microscopy, the nucleation of nanoplatelets happens within each liquid precursor droplet, and nanoplatelets reorient themselves and self-organize into a radial orientation in the crystalline microspheres. The recipe was then extended to the precipitation of organics in other oppositely charged amino acid-polyelectrolyte systems. After the success in preparing hierarchical microspheres in solution, the similar recipe can be extended to the preparation of patterned thin films on substrate. By dipping a quaternary DL-Lys·HCl (Lys)–polyacrylic acid (PAA)–water–EtOH dispersion on a hydrophilic slide, the fast evaporation process of the volatile solvent EtOH is responsible for the homogeneous nucleation of NPs. Then, the following complete evaporation causes the mesocrystallization of a continuous spherulitic thin film along the receding line of the liquid, which again transforms into a mesocrystalline thin film. Furthermore, annealing is used to optimize the property of mesocrystalline thin films. As evaporation is a non-equilibrium process, it can be used to tune the kinetics of crystallization. Therefore, hierarchical or periodical thin films are obtainable by starting the evaporation from microspheres recrystallization, obtaining mesocrystalline thin films with 4 hierarchy levels. The results reveal that evaporation provides an easy but effective way for the formation of patterned structures via the positioning of NPs after their fast nucleation, resulting in different kinds of patterns by controlling the concentration of NPs, solvent evaporation rate, and other physical forces. Non-classical crystallization is not limited to crystallizations with polymeric additives. We also observed the nucleation and growth of a new molecular layer on the growing DL-Glu·H2O crystals from a supersaturated mother liquor by using an in-situ atomic force microscopy (AFM), where the nucleation and growth of a molecular layer proceed via amorphous nanoparticle (NP) attachment and relaxation process before the observation of the growth of a newly formed molecular layer. NP attachment to the crystal surface is too fast to observe by using in-situ AFM. The height shrinkage of NPs, combined to the structural transformation from 3D amorphous NPs to 2D crystalline layer, is observed during the relaxation process. The nucleation and growth of a newly formed molecular layer from NP relaxation is contradictory to the classical nucleation theory, which hypothesizes that nuclei show the same crystallographic properties as a bulk crystal. The formation of a molecular layer by NP attachment and relaxation rather than attachment of single molecules provides a different picture from the currently held classical nucleation and growth theory regarding the growth of single crystals from solution. / Das Hauptziel dieser Arbeit ist das Verständnis der molekularen Kristallisation, sowohl mit als auch ohne polymere Additive, als einen mehrstufigen Prozess. Dieser beinhaltet eine transiente flüssig-flüssig Phasentrennung, die Nukleation von Nanokristallen in der dichten flüssigen Precursor-Phase so wie eine anschließende nanokristalline Selbstorganisation. Die Arbeit beginnt mit Untersuchungen an einem quaternären Modelsystem bestehend aus DL-Glutamat (Glu), Polyethylenimin (PEI), Wasser und Ethanol. Das Phasendiagramm dieses quaternären Systems wird durch Variation der Glu/PEI w/w und Wasser/EtOH v/v Verhältnisse bestimmt, wobei Präzpitat aus polymerinduzierten flüssigen Precursor, Koazervate oder homogene Mischungen erhalten werden Das thermodynamisch stabile Koazervat kann als Referenz für das Verständnis von flüssigen Precursorn angesehen werden, welche in der Natur metastabil und transient sind. Der mehrstufige Mechanismus der Glu-Präzipitation mit PEI als Additiv wird dann mittels Neutronen Kleinwinkelstreuung untersucht. Dies zeigt, dass die ursprünglich gebildeten flüssigen Precursor noch vor der Nukleation von Nanokristallen einen Wechsel von Wachstum und Koaleszenz durchlaufen. Die Ergebnisse aus optischer- und Eletronenmikroskopie zeigen, dass sowohl die flüssigen Precursor Superstrukturen ausbilden als auch, dass die Nukleation von Nanoplättchen in jedem einzelnen Precursor Tropfen von statten geht. Dies geschieht noch bevor sich die Nanoplättchen selbst in einer radialen Orientierung ausrichten. Diese Studie liefert die Kinetik der Präzipitation von organischen Stoffen in Gegenwart von polymeren Additiven. Eine ähnliche Vorgehensweise wie für die Herstellung von Mikrokügelchen kann für die Darstellung von gemusterten Filmen angewandt werden. Die homogene Nukleation von Nanopartikeln (NPs) findet während der Verdampfung einer quarternären DL-Lys·HCl-Polyacrylsäure-Wasser-Ethanol Dispersion auf einer hydrophilen Oberfläche statt. Die darauffolgende vollständige Verdampfung löst die Mesokristallisation eines kontinuierlichen sphärolithischen dünnen Films aus, welcher sich wiederum in einen mesokristallinen dünnen Film umwandelt. Mesokristalline Filme mit 4 Hierarchiestufen bzw. auch periodische Filme werden durch die Verdampfung der Mikrokügelchen-Dispersion erhalten. Die Ergebnisse zeigen, dass die Verdampfung eine einfache aber effektive Methode zur Herstellung von verschieden gemusterten hierarchischen Filmen darstellt. Nicht-klassische Kristallisation wird auch in der Abwesenheit von polymeren Additiven beobachtet. Wir verfolgen mittels Rasterkraftmikroskop (AFM) die Nukleation und das Wachstum einer neuen molekularen Schicht auf wachsenden DL-Glu·H2O Kristallen aus übersättigter Mutterlauge. Die Bildung einer neuen molekularen Schicht verläuft durch die Anlagerung von amorphen Nanopartikeln. Das Schrumpfen der NPs zusammen mit der strukturellen Änderung von dreidimensionalen NPs zu 2D Schichten wird während dieses Relaxationsprozesses beobachtet. Schließlich kommt es zu der Ausbildung einer neuen molekularen Schicht. Die Bildung einer molekularen Schicht durch die Anlagerung von Nanopartikeln aus der Lösung und die darauffolgende Relaxation liefert ein abweichendes Bild zu der bisher gängigen klassischen Theorie des Kristallwachstums.

Self-assembly of nanoparticles is a promising route to form complex, nanostructured materials with functional properties. Nanoparticle assemblies characterized by a crystallographic alignment of the nanoparticles on the atomic scale, i.e. mesocrystals, are commonly found in nature with outstanding functional and mechanical properties. This thesis aims to investigate and understand the formation mechanisms of mesocrystals formed by self-assembling iron oxide nanocubes. We have used the thermal decomposition method to synthesize monodisperse, oleate-capped iron oxide nanocubes with average edge lengths between 7 nm and 12 nm and studied the evaporation-induced self-assembly in dilute toluene-based nanocube dispersions. The influence of packing constraints on the alignment of the nanocubes in nanofluidic containers has been investigated with small and wide angle X-ray scattering (SAXS and WAXS, respectively). We found that the nanocubes preferentially orient one of their {100} faces with the confining channel wall and display mesocrystalline alignment irrespective of the channel widths.  We manipulated the solvent evaporation rate of drop-cast dispersions on fluorosilane-functionalized silica substrates in a custom-designed cell. The growth stages of the assembly process were investigated using light microscopy and quartz crystal microbalance with dissipation monitoring (QCM-D). We found that particle transport phenomena, e.g. the coffee ring effect and Marangoni flow, result in complex-shaped arrays near the three-phase contact line of a drying colloidal drop when the nitrogen flow rate is high. Diffusion-driven nanoparticle assembly into large mesocrystals with a well-defined morphology dominates at much lower nitrogen flow rates. Analysis of the time-resolved video microscopy data was used to quantify the mesocrystal growth and establish a particle diffusion-based, three-dimensional growth model. The dissipation obtained from the QCM-D signal reached its maximum value when the microscopy-observed lateral growth of the mesocrystals ceased, which we address to the fluid-like behavior of the mesocrystals and their weak binding to the substrate. Analysis of electron microscopy images and diffraction patterns showed that the formed arrays display significant nanoparticle ordering, regardless of the distinctive formation process.  We followed the two-stage formation mechanism of mesocrystals in levitating colloidal drops with real-time SAXS. Modelling of the SAXS data with the square-well potential together with calculations of van der Waals interactions suggests that the nanocubes initially form disordered clusters, which quickly transform into an ordered phase. / <p>At the time of the doctoral defense, the following papers were unpublished and had a status as follows: Paper 4: Manuscript. Paper 5: Manuscript.</p>

Clean air is an indispensable prerequisite for human health. The capture of small toxic molecules requires the development of advanced materials for air filtration. Two-dimensional nanomaterials offer highly accessible surface areas but for real-world applications their assembly into well-defined hierarchical mesostructures is essential. DUT-134(Cu) ([Cu2(dttc)2]n, dttc=dithieno[3,2-b : 2′,3′-d]thiophene-2,6-dicarboxylate]) is a metal–organic framework forming platelet-shaped particles, that can be organized into complex structures, such as millimeter large free-standing layers (carpets) and tubes. The structured material demonstrates enhanced accessibility of open metal sites and significantly enhanced H2S adsorption capacity in gas filtering tests compared with traditional bulk analogues.