This study seeks to identify naturally occurring differences in the turbulent environment at a variety of field sites near the Skidaway Institute of Oceanography, in Wassaw Sound and surrounding bodies of water. The sites have previously been used to study predator-prey interactions. Velocity time records were recorded using acoustic Doppler velocimetry (ADV) probes at six sites on four days, with a total of 14 data sets. Differential estimate phase filtering was employed to identify erroneous velocity measurements. Less than 3% of the total samples were identified for any given data set with the exception of three sets that contained nonphysical banded bursts. Set mean velocity statistics were largely unaffected by phase filtration, while turbulent kinetic energy (TKE) was reduced in magnitude. Because the sites were exposed to waves, wave contributions to TKE and Reynolds shear stress were computed. Power spectral densities (PSDs) were computed for each velocity burst, and the contributions from wave-related and turbulent fluctuations were isolated. Wave components of TKE and Reynolds shear stress were computed. Wave contributions to turbulent characteristics for most sets were between 10-20% of the total value. Wave contributions to TKE were consistent but wave contributions to Reynolds shear stresses were irregular. Burst-average velocity statistics, TKE, Reynolds shear stress, and turbulence intensity (TI) were computed for each set. Large variability in turbulent characteristics was observed both temporally and spatially. Tidal influences were apparent as turbulent characteristics often reached absolute maximum values during the incoming or outgoing tides. No consistent trends were observed in relationships between the sites. The findings of the study emphasize the importance of applying data filtration to raw ADV data, suggest an order of magnitude of wave contributions in a particular tidal ecosystem, and demonstrate the inherent variability of turbulent characteristics. The study also illustrates the importance of considering multiple turbulence parameters for a give site, due to the lack of observed relationships between TKE, TI, and Reynolds shear stress. Further work is needed to determine if other parameters that are relevant from a flow characterization standpoint are also important ecologically.

The ability of typical utility meters and advanced meters including sub-circuit metering to disaggregate residential electric loads and determine what appliances a homeowner is using at a given time in investigated. The basics of residential electricity systems, instrumentation options, and characteristics of selected residential loads are presented. This information informs a discussion on present and future disaggregation algorithms. The conclusions highlight the importance of reactive power and current harmonics in determining power consumed and identifying modern electrical devices, and raise concerns related to the ability of typical 15 minute interval utility smart meters to disaggregate loads. / text

No description available.

Utility companies (electricity, gas, and water suppliers), governments, and researchers recognize an urgent need to deploy communication-based systems to automate data collection from smart meters and sensors, known as Smart Metering Infrastructure (SMI) or Automatic Meter Reading (AMR). A smart metering system is envisaged to bring tremendous benefits to customers, utilities, and governments. The advantages include reducing peak demand for energy, supporting the time-of-use concept for billing, enabling customers to make informed decisions, and performing effective load management, to name a few. A key element in an SMI is communications between meters and utility servers. However, the mass deployment of metering devices in the grid calls for studying the scalability of communication protocols. SMI is characterized by the deployment of a large number of small Internet Protocol (IP) devices sending small packets at a low rate to a central server. Although the individual devices generate data at a low rate, the collective traffic produced is significant and is disruptive to network communication functionality. This research work focuses on the scalability of the transport layer functionalities. The TCP congestion control mechanism, in particular, would be ineffective for the traffic of smart meters because a large volume of data comes from a large number of individual sources. This situation makes the TCP congestion control mechanism unable to lower the transmission rate even when congestion occurs. The consequences are a high loss rate for metered data and degraded throughput for competing traffic in the smart metering network. To enhance the performance of TCP in a smart metering infrastructure (SMI), we introduce a novel TCP-based scheme, called Split- and Aggregated-TCP (SA-TCP). This scheme is based on the idea of upgrading intermediate devices in SMI (known in the industry as regional collectors) to offer the service of aggregating the TCP connections. An SA-TCP aggregator collects data packets from the smart meters of its region over separate TCP connections; then it reliably forwards the data over another TCP connection to the utility server. The proposed split and aggregated scheme provides a better response to traffic conditions and, most importantly, makes the TCP congestion control and flow control mechanisms effective. Supported by extensive ns-2 simulations, we show the effectiveness of the SA-TCP approach to mitigating the problems in terms of the throughput and packet loss rate performance metrics. A full mathematical model of SA-TCP is provided. The model is highly accurate and flexible in predicting the behaviour of the two stages, separately and combined, of the SA-TCP scheme in terms of throughput, packet loss rate and end-to-end delay. Considering the two stages of the scheme, the modelling approach uses Markovian models to represent smart meters in the first stage and SA-TCP aggregators in the second. Then, the approach studies the interaction of smart meters and SA-TCP aggregators with the network by means of standard queuing models. The ns-2 simulations validate the math model results. A comprehensive performance analysis of the SA-TCP scheme is performed. It studies the impact of varying various parameters on the scheme, including the impact of network link capacity, buffering capacity of those RCs that act as SA-TCP aggregators, propagation delay between the meters and the utility server, and finally, the number of SA-TCP aggregators. The performance results show that adjusting those parameters makes it possible to further enhance congestion control in SMI. Therefore, this thesis also formulates an optimization model to achieve better TCP performance and ensures satisfactory performance results, such as a minimal loss rate and acceptable end-to-end delay. The optimization model also considers minimizing the SA-TCP scheme deployment cost by balancing the number of SA-TCP aggregators and the link bandwidth, while still satisfying performance requirements.

<p>This thesis examined a pre-paid water metering pilot project which was implemented in Klipheuwel , Cape Town, South Africa in 2001. It was anticipated that the implementation of pre-paid water meters would help improve the management of water service delivery in the Cape Metropolitan Area. However, just four years after its implementation the project has collapsed.</p>

Thesis (Ocean E)--Massachusetts Institute of Technology, Dept. of Ocean Engineering, 1979. / Supervised by Ole Secher Madsen and William D. Grant. Includes bibliographical references (leaves 142-144).

The theme of this thesis is a "Testing of reflective systems for distance measuring." Within the work was created reflective device of aluminum sheet and reflective foil. This device was tested with another reflective device that operates on the same principle. The aim of this study was to test devices under different climatic conditions. Standard deviations of the measured values and the values of additive constants for each total station and reflective devices were evaluated. In conclusion, it was suggested the use of these devices in geodetic work under land adjustment.

Made available in DSpace on 2014-10-09T12:28:09Z (GMT). No. of bitstreams: 0 / Made available in DSpace on 2014-10-09T14:01:44Z (GMT). No. of bitstreams: 0 / Dissertacao (Mestrado) / IPEN/D / Instituto de Pesquisas Energeticas e Nucleares - IPEN-CNEN/SP

Made available in DSpace on 2014-10-09T12:52:39Z (GMT). No. of bitstreams: 0 / Made available in DSpace on 2014-10-09T14:02:17Z (GMT). No. of bitstreams: 0 / Dissertação (Mestrado) / IPEN/D / Instituto de Pesquisas Energéticas e Nucleares - IPEN-CNEN/SP

Made available in DSpace on 2014-10-09T12:33:08Z (GMT). No. of bitstreams: 0 / Made available in DSpace on 2014-10-09T14:06:21Z (GMT). No. of bitstreams: 0 / Dissertacao (Mestrado) / IPEN/D / Instituto de Pesquisas Energeticas e Nucleares - IPEN-CNEN/SP