Microbial biosensor systems (MBS) are useful for analyte detection owing to their low cost, sensitivity, and selectivity for bioavailable analytes. Due to typically poor shelf-life and sensitivity to external conditions, there are few reports of MBS technology applied to simple analytical devices. The effectiveness of air-drying MBS in natural polymers was investigated as a novel preservation technique. Two colorimetric Escherichia coli MBS, a tetracycline-inducible reporter and an arsenate-inducible reporter, were dried on various substrates yielding novel MBS platforms. In proof-of-concept experiments performed in 96-well microplates, both systems demonstrated responsivity after air-drying in low concentrations of pullulan. However, the MBS were unresponsive following brief storage of 1 week. To improve the preservation of MBS, sensing strips were created by air-drying concentrated acacia gum-based MBS suspensions onto paper. Cells dried on these strips demonstrated responsivity upon solubilization in various tube-based assays. MBS sensing strip responsivity was demonstrated following storage for 6 weeks at 4 °C. Tetracycline-responsive sensing strips also performed well in assays using spiked lake water samples. Air-drying in natural polymers was an effective MBS preservation technique, and allowed for the creation of “mix and read” style assays which were simple, equipment-free and ready-to-use. / Thesis / Master of Science (MSc)

Whole cell biosensors have been extensively used for monitoring toxicity and contamination of compounds in environmental biology and microbial ecology. However, their application in the pharmaceutical and cosmetics industries for preservative efficacy testing (PET) has been limited. According to several pharmacopoeias, preservatives should be tested for microbial activity using traditional viable count techniques; the use of whole cell microbial biosensors potentially provides an alternative, fast, and efficient method. The aim of the study was to construct and develop whole cell microbial biosensors with Pseudomonas aeruginosa ATCC 9027. Constitutive promoters: PlysS, Pspc, Ptat, Plpp and PldcC and the lux-cassette were inserted into plasmid pME4510 and transformed into P. aeruginosa ATCC 9027 cells to produce bioluminescent strains. Plasmids were found to be maintained stably (~50 copies per cell) throughout the growth and death cycle. The novel bioluminescent strains were validated in accordance with the pharmacopoeia using bioluminescence detection and quantification followed by comparison with the traditional plate counting method. The bioluminescent method was found to be accurate, precise and equivalent at a range of 103 – 107 CFU/mL, as compared with plate counting. Recovery of bacterial cells was quantified using bioluminescence; this method proved to be accurate with percentage recoveries between 70-130% for all bioluminescent strains. The method was also more precise (relative standard deviation less than 15%) than the traditional plate counting method or the ATP bioluminescent method. Therefore, the bioluminescent constructs passed/exceeded pharmacopoeial specified criteria for range, limit of detection, accuracy, precision and equivalence. Physiology of the validated bioluminescent strains was studied by assessing the growth and death patterns using constitutive gene expression linked with bacterial replication. Promoter strengths were evaluated at various stages of the growth and death pattern and related to promoter sequences. PlysS, Ptat and Plpp were relatively strong promoters whilst PldcC and Pspc were relatively weak promoters. Relative promoter strength decreased in the order of Plpp>Ptat>PlysS>PldcC>Pspc during the exponential phase whilst Ptat was stronger than Plpp during the stationary phase of growth. Plpp had its highest level of expression during the exponential phase, while Ptat had relatively stable lux expression during the stationary phase. Correlations between relative bioluminescence and CFU at 24 hours were greater than 0.9 indicating a strong relationship for all bioluminescent strains. Reduction in correlation coefficients to approximately 0.6 between relative bioluminescence and CFU and between relative fluorescence and CFU beyond 24 hours indicated that a certain proportion of cells were viable but non-culturable. Tat-pME-lux showed steady bioluminescence compared to CFU count (R>0.9) throughout 28 days of growth. Equivalence analysis showed no significant difference between the bioluminescence and plate count method throughout 28 days of growth for all five bioluminescent strains. Applicability of these novel bioluminescent strains was evaluated for preservative efficacy tests (PET) using bacterial replication and bioluminescence as a measure of constitutive gene expression. PET using benzalkonium chloride and benzyl alcohol showed no significant difference between the bioluminescent method and the plate count method. Good correlations between bioluminescence, CFU count and fluorescence were obtained for benzalkonium chloride (BKC) concentrations (R>0.9) between 0.0003% and 0.0025% against strains lysR25, lppR4 and tatH5. Similarly, good correlations (R>0.9) between the three parameters were obtained for benzyl alcohol (BA) concentrations between 0.125% and 2% against strains lysR25, lppR4 and tatH5. The bioluminescent method and traditional plate counting method were equivalent for concentrations of BKC (0.0003 - 0.02%) and BA (0.25 - 2%) during preservative efficacy tests. These bioluminescent constructs therefore are good candidates for selection for preservative efficacy testing. The bioluminescent method and traditional plate counting method were also found to be equivalent for construct tatH5 at a concentration of 0.125% BA. PET testing with BKC and BA showed that tatH5-pMElux (R>0.9) had consistently high correlation coefficients between CFU and relative bioluminescence. Together with the results from growth and death kinetics, where tatH5 showed the greatest constitutive expression, it can be concluded that P. aeruginosa ATCC 9027 tatH5-pMElux is the best construct for testing various antimicrobial agents. This study has shown that according to the pharmacopoeial requirements, the bioluminescent method is more accurate, precise and equivalent to the traditional plate counting method and therefore can be utilised instead of the traditional plate counting method for the purpose of preservative efficacy testing.

We report on the spatial and temporal signaling properties of a yeast pheromone-based cell communication and amplifier system. It utilizes the Saccharomyces cerevisiae mating response pathway and relies on diffusion of the pheromone α–factor as key signaling molecule between two cell types. One cell type represents the α–factor secreting sensor part and the other the reporter part emitting fluorescence upon activation. Although multi-cellular signaling systems promise higher specificity and modularity, the complex interaction of the cells makes prediction of sensor performance difficult. To test the maximum distance and response time between sensor and reporter cells, the two cell types were spatially separated in defined compartments of agarose hydrogel (5 ´ 5 mm) and reconnected by diffusion of the yeast pheromone. Different ratios of sensor to reporter cells were tested to evaluate the minimum amount of sensor cells required for signal transduction. Even the smallest ratio, one α–factor-secreting cell to twenty reporter cells, generated a distinct fluorescence signal. When using a 1:1 ratio, the secreted pheromone induced fluorescence in a distance of up to four millimeters after six hours. We conclude from both our experimental results and a mathematical diffusion model that in our approach: (1) the maximum dimension of separated compartments should not exceed five millimeters in gradient direction; and (2) the time-limiting step is not diffusion of the signaling molecule but production of the reporter protein.

We report on the spatial and temporal signaling properties of a yeast pheromone-based cell communication and amplifier system. It utilizes the Saccharomyces cerevisiae mating response pathway and relies on diffusion of the pheromone α–factor as key signaling molecule between two cell types. One cell type represents the α–factor secreting sensor part and the other the reporter part emitting fluorescence upon activation. Although multi-cellular signaling systems promise higher specificity and modularity, the complex interaction of the cells makes prediction of sensor performance difficult. To test the maximum distance and response time between sensor and reporter cells, the two cell types were spatially separated in defined compartments of agarose hydrogel (5 ´ 5 mm) and reconnected by diffusion of the yeast pheromone. Different ratios of sensor to reporter cells were tested to evaluate the minimum amount of sensor cells required for signal transduction. Even the smallest ratio, one α–factor-secreting cell to twenty reporter cells, generated a distinct fluorescence signal. When using a 1:1 ratio, the secreted pheromone induced fluorescence in a distance of up to four millimeters after six hours. We conclude from both our experimental results and a mathematical diffusion model that in our approach: (1) the maximum dimension of separated compartments should not exceed five millimeters in gradient direction; and (2) the time-limiting step is not diffusion of the signaling molecule but production of the reporter protein.