The thesis presents an experimental investigation of combustion performance and emissions of waste cooking oil (WCO) based biodiesel. To evaluate the comparative performance of biodiesel and diesel, combustions tests were conducted using Continuous Combustion rig (CCR) and Land Rover VM diesel engine. Firstly, physical properties of WCO biodiesel and diesel samples were measured in the laboratory. Elemental analysis of WCO biodiesel showed that there are differences between the functional groups in diesel and biodiesel which lead to major differences in the combustion characteristics of the two fuel types. It was found that biodiesel had 10% lower carbon content, almost no sulphur content for biodiesel and up to 12% more oxygen content compared with diesel. This explains the lower caloric value for WCO biodiesel (up to l8 %) compared with diesel. However, higher oxygen content and double bounds in WCO biodiesel increase its susceptibility to oxidation. The CCR test results showed an increase in combustion gas temperature with the increases in biodiesel blend ratio in diesel. This was due to a faster reaction rate for biodiesel than that of diesel leading to a faster brakeage of the hydrocarbon chain to release more heat. The engine tests were performed to measure the torque and emissions for different engine speeds and loads. In general a decrease in engine torque with up to 9% for biodiesel was observed, which was due to the lower calorific value of biodiesel compared with that of diesel. The brake specific fuel consumption (BSFC) increased as the biodiesel blend ratio in diesel increases due a greater mass of fuel being injected at a given injection pressure, compared with diesel. Using WCO blends ratio up to 75% in diesel showed a reduction in exhaust emission compared with diesel, however, at the cost of increased fuel consumption. A common conclusion can be drawn in favour of the WCO biodiesel as being a greener alternative to petro-diesel when used in blend with diesel. However, due to large variations in the biomass used for biodiesel production could lead to variations in physical and chemical properties between biodiesel produced from different biomass. Therefore more stringent standards need to be imposed for biodiesel quality in order to diminish the effect of variation in physicochemical properties on engine performance and emissions. The future work in developing standard test procedures for establishing fuel properties and limits/targets would be beneficial in using a large amount of waste cooking oil in the production of biodiesel, thus contributing to reduction in CO2 and waste minimisation.

Neste estudo amostras coletadas de pinturas rupestres foram analisadas para identificação do material utilizado; análises da sua interação e de processos eventuais de degradação, além de atribuições quanto à sua origem, foram também feitas através da espectroscopia Raman. Pigmentos encontrados em pinturas rupestres em Minas Gerais foram identificados, junto a produtos de degradação microbiológica. A partir dos resultados, foi feita uma caracterização da transformação de desidratação do pigmento amarelo de goetita (α-FeOOH) a hematita (α-Fe2O3) por espectroscopia Raman na tentativa de contextualizá-la no problema da origem da hematita encontrada nas representações. Foram identificados os pigmentos calcita (CaCO3) para o branco, carvão vegetal para o preto, goetita (α-FeOOH) para o amarelo e hematita (α-Fe2O3) para o vermelho, que constituem basicamente a paleta de cores desse período. Produtos de degradação microbiológica foram identificados por espectroscopia Raman e no infravermelho por ATR como sendo whewellita (CaC2O4.H2O) e weddelita(CaC2O4.2H2O). A transformação topotática de goetita a hematita por aquecimento foi acompanhada por espectroscopia Raman in situ e ex-situ e infravermelho, na tentativa de caracterizar o processo quanto às fases formadas, possíveis marcadores, de maneira a complementar resultados da literatura que utilizaram outras técnicas, como difração de raio-X (XRD) e microscopia eletrônica de transmissão (TEM). Esse estudo foi realizado na tentativa de determinar a existência de possível manipulação térmica desses materiais como sugerido em trabalhos anteriores. Em particular, nos espectros Raman, o comportamento diferenciado da banda em torno de 660 cm-1 e a maior largura das bandas de uma maneira geral, presentes na chamada hematita desordenada, perfil que as amostras naturais coletadas apresentam, são marcadores do efeito de temperatura, uma vez que parecem estar ligados mais estreitamente ao deslocamento catiônico dos íons Fe do que ao rearranjo da gaiola octaédrica de oxigênios ao redor destes, durante a transição a partir de goetita. Esse comportamento dos espectros Raman é confirmado pelos padrões dos difratogramas de raio-X. Concluiu-se que esse desordenamento, entretanto, não é causado somente pela temperatura e, dessa forma, não pode ser usado para atestar inequivocamente como sendo resultado de processamento dos materiais (goetita). / This dissertation reports the investigation carried out on samples collected from rupestrian paintings, aiming at the identification of materials used, their interaction and degradation. The technique of choice was Raman microscopy as it is a non-destructive tool, which provides the spatial resolution necessary for the study of heterogeneous samples. Pigments were identified together with products of microbiological degradation. Thermal convertion of goethite (yellow) to hematite (red) was followed by Raman spectroscopy in a tentative to address the issue of the provenance of red pigments (natural hematite or heated goethite) found in the paintings. White pigments were identified as calcite (CaCO3), whereas charcoal was used as black, goethite (α-FeOOH) as yellow and hematite (α-Fe2O3) as red. These pigments are usually found in rock art palletes. Degradation products from microbiological activity were identified by Raman microscopy and ATR infrared spectroscopy as being whewellite (CaC2O4.H2O) and weddelite (CaC2O4.2H2O). The topotatic transition from goethite to hematite was followed by in situ and ex-situ Raman and infrared spectroscopy, regarding the characterization of the phases formed, possible markers, aiming to complement the previous results reported in the literature using other techniques such as X-ray diffractometry (XRD) and transmission eletron microscopy (TEM). The main goal of the study of temperature effect on the Raman spectrum of goethite was to determine whether hematite was used as found in nature or was obtained by goethite heating as suggested in previous investigations. Particularly, the behavior of the 660 cm-1 band and a larger linewidth for bands in the spectrum, present in the disordered hematite and in the red pigments analysed, are markers of the thermal processing. These features seem to be related to the movement of iron ions and to the rearrangment of the octahedrical cage formed by oxygen atoms around them. Such conclusions are in agreement with X-ray data. Unfortunately, temperature is not the only factor to cause such structural disorder and, hence, it cannot be used as an unequivocal marker of thermal processing.

Neste estudo amostras coletadas de pinturas rupestres foram analisadas para identificação do material utilizado; análises da sua interação e de processos eventuais de degradação, além de atribuições quanto à sua origem, foram também feitas através da espectroscopia Raman. Pigmentos encontrados em pinturas rupestres em Minas Gerais foram identificados, junto a produtos de degradação microbiológica. A partir dos resultados, foi feita uma caracterização da transformação de desidratação do pigmento amarelo de goetita (α-FeOOH) a hematita (α-Fe2O3) por espectroscopia Raman na tentativa de contextualizá-la no problema da origem da hematita encontrada nas representações. Foram identificados os pigmentos calcita (CaCO3) para o branco, carvão vegetal para o preto, goetita (α-FeOOH) para o amarelo e hematita (α-Fe2O3) para o vermelho, que constituem basicamente a paleta de cores desse período. Produtos de degradação microbiológica foram identificados por espectroscopia Raman e no infravermelho por ATR como sendo whewellita (CaC2O4.H2O) e weddelita(CaC2O4.2H2O). A transformação topotática de goetita a hematita por aquecimento foi acompanhada por espectroscopia Raman in situ e ex-situ e infravermelho, na tentativa de caracterizar o processo quanto às fases formadas, possíveis marcadores, de maneira a complementar resultados da literatura que utilizaram outras técnicas, como difração de raio-X (XRD) e microscopia eletrônica de transmissão (TEM). Esse estudo foi realizado na tentativa de determinar a existência de possível manipulação térmica desses materiais como sugerido em trabalhos anteriores. Em particular, nos espectros Raman, o comportamento diferenciado da banda em torno de 660 cm-1 e a maior largura das bandas de uma maneira geral, presentes na chamada hematita desordenada, perfil que as amostras naturais coletadas apresentam, são marcadores do efeito de temperatura, uma vez que parecem estar ligados mais estreitamente ao deslocamento catiônico dos íons Fe do que ao rearranjo da gaiola octaédrica de oxigênios ao redor destes, durante a transição a partir de goetita. Esse comportamento dos espectros Raman é confirmado pelos padrões dos difratogramas de raio-X. Concluiu-se que esse desordenamento, entretanto, não é causado somente pela temperatura e, dessa forma, não pode ser usado para atestar inequivocamente como sendo resultado de processamento dos materiais (goetita). / This dissertation reports the investigation carried out on samples collected from rupestrian paintings, aiming at the identification of materials used, their interaction and degradation. The technique of choice was Raman microscopy as it is a non-destructive tool, which provides the spatial resolution necessary for the study of heterogeneous samples. Pigments were identified together with products of microbiological degradation. Thermal convertion of goethite (yellow) to hematite (red) was followed by Raman spectroscopy in a tentative to address the issue of the provenance of red pigments (natural hematite or heated goethite) found in the paintings. White pigments were identified as calcite (CaCO3), whereas charcoal was used as black, goethite (α-FeOOH) as yellow and hematite (α-Fe2O3) as red. These pigments are usually found in rock art palletes. Degradation products from microbiological activity were identified by Raman microscopy and ATR infrared spectroscopy as being whewellite (CaC2O4.H2O) and weddelite (CaC2O4.2H2O). The topotatic transition from goethite to hematite was followed by in situ and ex-situ Raman and infrared spectroscopy, regarding the characterization of the phases formed, possible markers, aiming to complement the previous results reported in the literature using other techniques such as X-ray diffractometry (XRD) and transmission eletron microscopy (TEM). The main goal of the study of temperature effect on the Raman spectrum of goethite was to determine whether hematite was used as found in nature or was obtained by goethite heating as suggested in previous investigations. Particularly, the behavior of the 660 cm-1 band and a larger linewidth for bands in the spectrum, present in the disordered hematite and in the red pigments analysed, are markers of the thermal processing. These features seem to be related to the movement of iron ions and to the rearrangment of the octahedrical cage formed by oxygen atoms around them. Such conclusions are in agreement with X-ray data. Unfortunately, temperature is not the only factor to cause such structural disorder and, hence, it cannot be used as an unequivocal marker of thermal processing.