Superconductor-Insulator-Superconductor (SIS) mixers are now used regularly in sub- millimetre astronomical receivers. They have already achieved sensitivity approaching the quantum limit at frequencies below the superconducting gap of niobium (~680 GHz). Above that, the mixer performance is compromised by losses, unless materials with higher superconducting gap are employed in conjunction with the niobium tunnel junction. In this thesis, we present the development of 700 GHz niobium SIS mixers, employing a unilateral finline taper on a thin Silicon-On-Insulator (SOI) substrate. These mixers are broadband with full on-chip planar circuit integration, and require only a very simple mixer block. They were designed using rigorous 3-D electromagnetic simulator (HFSS), in conjunction with a quantum mixing software package (SuperMix), and have demonstrated good performance with the best noise temperature measured at 143 K. Our mixer devices were fed by multiple flare angle smooth-walled horns, which are easy to fabricated, yet retain the high performance of corrugated horns. The radiation patterns measured from 600–740 GHz have shown good beam circularity, low sidelobe and cross-polarization levels. In this thesis, we also present SIS mixer designs with balanced and sideband separ- ating capability. These mixers employ back-to-back finline tapers, so that the RF and local oscillator (LO) signals can be injected separately without a beam splitter. We have fabricated and tested the performance of the balanced mixers, and analysed their performance thoroughly. We have also investigated a new method of generating LO signals by beating the tones of two infrared lasers. Using the current 16-pixel 350 GHz SIS receiver, HARP-B, we have observed the ¹²CO J=3→2 emission lines from two nearby galaxies. An important result we found is that the ¹²CO J=3→2 correlates strongly with the 8 μm Polycyclic Aromatic Hydrocarbon emission.

The IRMA III infrared radiometer is a passive atmospheric water vapor detector designed for use with interferometric submillimeter arrays as a method of phase correction. The IRMA III instrument employs a distributed, multi-tasking software control system permitting precise fine-grained control at remote locations over a low-bandwidth network connection. IRMA's software is divided among three processors tasked with performing three primary functions: command interpretation, data collection and motor control of IRMA's Alt-Az mount. IRMA's hardware control and communication functionality is based on compact, low cost, energy efficient Rabbit 2000 microcontroller modules, selected to meet IRMA's limited space and power requirements. IRMA accepts scripts defined in a custom, high level control language as its method of control, which the operator can write or dynamically generated by a separate GUI front-end program. / xi, 193 leaves : ill. ; 28 cm.

Our group has developed a 20 μm passive atmospheric water vapour monitor. The Infrared Radiometer for Millimetre Astronomy (IRMA) has been commissioned and deployed for site testing for the Thirty Meter Telescope (TMT) and the Giant Magellan Telescope (GMT). Measuring precipitable water vapour (PWV) requires both a sophisticated atmospheric model (BTRAM) and an instrument (IRMA). Atmospheric models depend on atmospheric profiles. Most profiles are generic in nature, representing only a latitude in some cases. Site-specific atmospheric profiles are required to accurately simulate the atmosphere above any location on Earth. These profiles can be created from publicly available archives of radiosonde data, that offer nearly global coverage. Having created a site-specific profile and model, it is necessary to determine the PWV sensitivity to the input parameter uncertainties used in the model. The instrument must also be properly calibrated. In this thesis, I describe the radiometric calibration of the IRMA instrument, and the creation and analysis of site-specific atmospheric models for use with the IRMA instrument in its capacity as an atmospheric water vapour monitor for site testing. / xii, 135 leaves : ill. ; 28 cm. --

The Infrared Radiometer for Millimetre Astronomy (IRMA) is a passive atmospheric water vapour monitor developed at the University of Lethbridge. It is a compact, robust, and autonomous instrument, which is capable of being operated remotely. The latest model is based on a PC/104 running an AMD 133 MHz SC520 processor, which allows for more flexible control of the unit. The modifications and upgrades to the software required for the transition to this new platform are discussed in this thesis. In addition to software optimisation, a new calibration method has been developed as the unit has become better understood. This method has been verified through test campaigns carried out in Lethbridge and Chile. The results of these tests are included in this thesis. / xii, 141 leaves : ill. (some col.) ; 28 cm. --