Includes bibliographical references (p. 154-160).

Thesis (M.S. in materials science and engineering)--Washington State University. / Includes bibliographical references.

Thesis (Ph. D.)--University of Hong Kong, 2010. / Includes bibliographical references (leaves 270-275). Also available in print.

Thesis (Ph. D.)--University of Hong Kong, 2010. / Includes bibliographical references (leaves 270-275). Also available online.

This diploma thesis deals with the structural analysis of semiconductor nanowires by transmission electron microscopy. The construction of microscope is introduced together with its basic imaging modes and with the function of each construction element in these modes. In the experimental part the results of analysis of several germnaium nanowires are discussed, with emphasis on their crystallographic structure and orientation.

We conclusively explain the different lasing mode energies in ZnO nano- and microcavities observed by us and reported in literature. The limited penetration depth of usually used excitation lasers results in an inhomogeneous spatial gain region depending on the structure size and geometry. Hence, weakly or even nonexcited areas remain present after excitation, where modes are instantaneously suppressed by excitonic absorption. We compare the effects for ZnO microwires, nanowires, and tetrapod-like structures at room temperature and demonstrate that the corresponding mode selective effect is most pronounced for whispering-gallery modes in microwires with a hexagonal cross section. Furthermore, the absorptive lasing mode suppression will be demonstrated by correlating the spot size of the excitation laser and the lasing mode characteristic of a single ZnO nanowire.

Electron Backscatter Diffraction (EBSD) is a well-developed technique used to perform quantitative microstructure analysis in the Scanning Electron Microscope (SEM); however, it has not been widely applied towards studying nanostructures. This work focuses on the use and limitations of EBSD in the characterization of Au nanoparticles on an MgAl2O4 substrate. Samples under investigation are prepared by depositing a thin film of Au on an MgAl2O4 substrate, and then finally heated in a furnace to induce dewetting and cluster formation. The challenges of obtaining crystallographic information from nanoparticles using EBSD are qualitatively and quantitatively described through an evaluation of the quality of the diffraction pattern at various locations of the primary electron beam on the nanoparticle. It is determined that for a high quality Electron Backscatter Diffraction Pattern (EBSP), the production of diffracted backscattered electrons travelling towards the detector must be high and the depth of the source point must be low. The top of the nanoparticle, where the local geometry of the system is similar to the geometry of a macroscopically flat sample, is found to produce diffraction patterns of the highest quality. On the other hand, reversed-contrast EBSPs are observed when the beam is positioned near the bottom of the nanoparticle. In addition, crystallographic information for each individual nanoparticle is gathered using EBSD. Each individual AuNP is observed to be single crystalline. Finally, the complete ensemble of crystalline orientations for individual nanoparticles is then compared to the global averaged crystallinity of the sample, as measured by X-ray diffraction. These results show that EBSD promises to be a powerful and robust technique in the characterization of nanoparticles. / Thesis / Master of Applied Science (MASc)