The synthesis of the sodium salt of heptakis (2, 3-di-O-acetyl-6-O-sulfo)-β-cyclodextrin was modified to increase the isomeric purity to 98.5%. This salt was used to obtain the organic-solvent-soluble, single-isomer, charged tetrabutylammonium salt of heptakis (2, 3-di-O-acetyl-6-O-sulfo)-β-cyclodextrin. Its isomeric purity was higher than 99%, as determined by CE, and its structure was confirmed by NMR and ESI-MS analysis. The hydrophobic single-isomer cyclodextrin was utilized to separate the enantiomers of weak base analytes in aprotic media by capillary electrophoresis. The effective mobilities and separation selectivities follow trends observed with negatively charged cyclodextrins in amphiprotic solvents. The properties of the dissolved cyclodextrin are altered by its counter ion, thereby affecting the separations of enantiomers. The aprotic media allow the modification of the separation selectivity, since the binding strength of the enantiomers to the cyclodextrin is intermediate between that reported in aqueous and methanolic buffers.

The synthesis of the sodium salt of heptakis (2, 3-di-O-acetyl-6-O-sulfo)-β-cyclodextrin was modified to increase the isomeric purity to 98.5%. This salt was used to obtain the organic-solvent-soluble, single-isomer, charged tetrabutylammonium salt of heptakis (2, 3-di-O-acetyl-6-O-sulfo)-β-cyclodextrin. Its isomeric purity was higher than 99%, as determined by CE, and its structure was confirmed by NMR and ESI-MS analysis. The hydrophobic single-isomer cyclodextrin was utilized to separate the enantiomers of weak base analytes in aprotic media by capillary electrophoresis. The effective mobilities and separation selectivities follow trends observed with negatively charged cyclodextrins in amphiprotic solvents. The properties of the dissolved cyclodextrin are altered by its counter ion, thereby affecting the separations of enantiomers. The aprotic media allow the modification of the separation selectivity, since the binding strength of the enantiomers to the cyclodextrin is intermediate between that reported in aqueous and methanolic buffers.

Liquid crystals are widely used in electronics, medicine and other fields. Analytical separations are important in the development of new liquid crystals to control the purity of synthesized substances. The sample analysis is important for detection of impurities formed during synthesis and for determination of chiral purity of the substance. Liquid crystal-forming substances cannot be separated by capillary zone electrophoresis due to the absence of readily ionizable groups. Electrokinetic chromatography is a method in which a suitable surfactant is added to the background electrolyte. The uncharged substances then interact with the electrically charged surfactant to obtain an effective charge. Separation can occur if they interact differently with the added surfactant. Another problem complicating the analysis is the very low solubility of analytes in water. Separations in this work were therefore carried out under non-aqueous conditions in acetonitrile. However, under these conditions a poor repeatability of the migration times of the substances was observed. Therefore, capillaries with differently coated inner walls were used in subsequent measurements. Surface modification should improve the repeatability of migration times. Several types of capillary coating have been tested. Dynamic coating...

<p>Three chiral selectors (diketogulonic acid, benzoxycarbonylglycylproline and ketopinic acid) have been introduced for enantioseparation of pharmacologically active amines in non-aqueous capillary electrophoresis. The use of organic solvents, instead of aqueous buffers in the background electrolyte facilitated ion-pair formation between the analytes and the chiral selectors. The enantioresolution was strongly affected by the choice of selector and organic solvent but also depended on the other electrolytes. The most important parameter for the enantioresolution, apart from the choice of chiral selector, was the direction and magnitude of the electro-osmosis. Thus, covalently coated capillaries were used to suppress and to reverse this flow. Furthermore, the alkali metal hydroxide added to the background electrolyte had a great influence on the electro-osmosis. Exchanging LiOH for NaOH, was found to decrease the electro-osmotic flow. Interestingly, the flow was altered from cathodic to anodic, with KOH, RbOH or CsOH added to the ethanolic BGE. The occurrence of a reversed electro-osmosis had a great positive effect on the enantioresolution. An appropriate choice of solvent and electrolytes promoted also fast chiral separations, e.g., the enantiomers of isoprenaline were resolved within one minute. </p><p>The capillary electrophoresis systems developed within this work were applied for enantiomeric purity determinations of different pharmaceutical forms of drug products. A detection limit of 0.033 % was achieved for <i>1S,2R</i>-ephedrine, the enantiomeric impurity in Efedrin®, when diketogulonic acid was used as the selector. </p><p>By using the pre-concentration technique, transient isotachophoresis, the peak efficiency was enhanced for the enantiomers of timolol. This facilitated the introduction of a higher concentration of the sample into the capillary electrophoretic system containing ketopinic acid as the selector, and lowered the detection limit from 2.5 % to 0.2 % for the enantiomeric impurity <i>R</i>-timolol compared with injection without transient isotachophoresis.</p><p>The volatility of the non-aqueous media in capillary electrophoresis facilitated the hyphenation to mass spectrometry. The partial filling technique ensured that the selector did not contaminate the mass spectrometer, and the separated enantiomers of e.g., pronethalol were detected in the selector-free zone. </p>

Three chiral selectors (diketogulonic acid, benzoxycarbonylglycylproline and ketopinic acid) have been introduced for enantioseparation of pharmacologically active amines in non-aqueous capillary electrophoresis. The use of organic solvents, instead of aqueous buffers in the background electrolyte facilitated ion-pair formation between the analytes and the chiral selectors. The enantioresolution was strongly affected by the choice of selector and organic solvent but also depended on the other electrolytes. The most important parameter for the enantioresolution, apart from the choice of chiral selector, was the direction and magnitude of the electro-osmosis. Thus, covalently coated capillaries were used to suppress and to reverse this flow. Furthermore, the alkali metal hydroxide added to the background electrolyte had a great influence on the electro-osmosis. Exchanging LiOH for NaOH, was found to decrease the electro-osmotic flow. Interestingly, the flow was altered from cathodic to anodic, with KOH, RbOH or CsOH added to the ethanolic BGE. The occurrence of a reversed electro-osmosis had a great positive effect on the enantioresolution. An appropriate choice of solvent and electrolytes promoted also fast chiral separations, e.g., the enantiomers of isoprenaline were resolved within one minute. The capillary electrophoresis systems developed within this work were applied for enantiomeric purity determinations of different pharmaceutical forms of drug products. A detection limit of 0.033 % was achieved for 1S,2R-ephedrine, the enantiomeric impurity in Efedrin®, when diketogulonic acid was used as the selector. By using the pre-concentration technique, transient isotachophoresis, the peak efficiency was enhanced for the enantiomers of timolol. This facilitated the introduction of a higher concentration of the sample into the capillary electrophoretic system containing ketopinic acid as the selector, and lowered the detection limit from 2.5 % to 0.2 % for the enantiomeric impurity R-timolol compared with injection without transient isotachophoresis. The volatility of the non-aqueous media in capillary electrophoresis facilitated the hyphenation to mass spectrometry. The partial filling technique ensured that the selector did not contaminate the mass spectrometer, and the separated enantiomers of e.g., pronethalol were detected in the selector-free zone.

Different multiple-injection methodologies and the partial filling technique (PFT) have been utilized for separation of pharmaceuticals by capillary elec-trophoresis. In multiple-injection capillary zone electrophoresis (MICZE), the samples and all standards, used for construction of the calibration curve, are analyzed within a single run. Four different modes of MICZE have been described by means of equations, which were experimentally verified. The developed equations facilitate the transfer from conventional single-injection CZE to one or more of these MICZE-modes, depending on the selectivity between the analyte and the injection marker. The applicability of two of these modes was then demonstrated by quantification of buserelin and salbutamol, re-spectively in commercially available pharmaceutical products. The content of buserelin in an injection solution was determined to 0.94 mg/ml, which only deviated slightly from the declared concentration (1 mg/ml). An alter-native mode of MICZE, offering a higher number of sequential sample injec-tions, was then utilized for single-run determination of salbutamol in 15 tab-lets, with a labelled content of 8 mg. The average content of the tablets was determined to 7.8 mg, with an intra-tablet variation of 3 % or less. Moreover, UV- and mass-spectrometric detection of enantiomeric amines, resolved by non-aqueous capillary electrophoresis (NACE), was demon-strated. Separation of enantiomeric amines was achieved using the chiral selector (-)-2,3:4,6-di-O-isopropylidene-2-keto-L-gulonic acid, (-)-DIKGA. Introduction of the non-volatile (-)-DIKGA into the mass-spectrometer was avoided by using the PFT, where the capillary is only partially filled with electrolyte containing the chiral selector.