Organic materials exhibiting second-order non-linear optical (NLO) properties are a key to the development of advanced electro-optic (EO) modulators used in fiber-optic communications system. This work addresses the fabrication and characterization of organic materials with NLO properties using a self-assembly approach by alternately dipping a charged substrate into positively and negatively charged polymers to build up layer-by-layer (LbL) films. The effect of solution pH on the formation of LbL films fabricated using the polycation poly(allylamine hydrochloride) (PAH) and the polyanion poly{1-[p-(3–-carboxy-4–-hydroxyphenylazo)benzenesulfonamido]-1,2-ethandiyl} (PCBS) was studied using a quartz crystal microbalance with dissipation (QCM-D) monitoring, ellipsometry, absorbance, and second harmonic generation (SHG) measurements. PCBS has an azo-benzene chromophore side group that, when sufficiently oriented, results in measurable SHG. Films of PAH/PCBS fabricated at neutral pH where both PAH and PCBS are highly charged led to thin bilayers, ~1 nm, with a 1:1 molar ratio of PCBS:PAH. This molar ratio was found to be important for long-range polar ordering of PCBS in these films. Increasing the rate of convection was found to reduce the time required for complete adsorption of the polyion. This can have a significant impact on fabrication of films with high bilayer numbers. A variation of the above technique, which involves adsorbing one of the constituents electrostatically and another covalently, was studied using PAH and a reactive dye, Procion Brown (PB), which has a significantly higher hyperpolarizability than PCBS. It was found that a high pH, ~10.5, was important for achieving covalent attachment of the PB to the underlying PAH films. This resulted in much higher SHG intensities compared to when PB was deposited pH at 8.5-9.5 where the attachment of PB was due to a combination of electrostatic and covalent interactions. QCM-D results for PAH/PB films revealed the presence of a high percentage of unreacted amine groups in the underlying PAH film. A rate constant value for PB attachment step to the underlying PAH was also calculated. To enhance the SHG intensity of these films, silver nanoprisms were synthesized and deposited onto films using physisorption. An enhancement in the SHG intensity was observed for both PAH/PCBS and PAH/PB films. / Ph. D.

This dissertation demonstrates the feasibility of using novel electrostatic self-assembly (ESA) methods to fabricate linear and nonlinear optical thin films and components. The ESA process involves the layer-by-layer alternate adsorption of anionic and cationic complexes from aqueous solutions. Selection of the molecules in each layer, their orientation at the molecular level, and the order in which the layers are assembled determine the film's bulk optical, electronic, magnetic, thermal, mechanical and other properties. In this work, the capability of nanoscale control over film optical properties allowed the fabrication of complicated refractive index profiles required for linear optical interference filters. The inherent ordered nature of ESA films yielded extremely stable noncentrosymmetric thin films for second-order nonlinear optical applications. The ESA technique offers numerous advantages over conventional thin film fabrication methods and offers great potential in commercial applications such as reflectance and AR filters, EO waveguides and modulators and other optoelectronic devices. The structure of each monolayer in ESA films is dependent on the processing parameters, producing subsequent variations in bulk film properties both intentionally and incidentally. As this method is still in its infancy, variations in ESA processing methods, including process automation, are considered first in this document. These results allowed carefully controlled refractive index experiments and the synthesis of both step and graded index structures, several microns thick. Dielectric stack, Rugate, and antireflection optical interference filters were designed, synthesized and demonstrated. c(2) films of both commercially available polymer dyes and novel polymers designed specifically for the ESA process were demonstrated using second harmonic generation. UV/vis spectroscopy, ellipsometry and atomic force microscopy analysis are presented. / Ph. D.

Les interrupteurs moléculaires sont des composés capables de commuterréversiblement entre deux ou plusieurs états stables en réponse à un stimulusextérieur. Lʼobjectif de la thèse est la conception dʼinterrupteurs moléculairesprésentant des contrastes optiques non-linéaires (ONL) et la mise évidence desparamètres structuraux et électroniques menant à dʼimportants contrastes depremière hyperpolarisabilité (β) via une approche multidisciplinaire qui combine lasynthèse de nouveaux composés, la caractérisation de leurs réponses optiqueslinéaires et non-linéaires par spectroscopie dʼabsorption UV-visible et par diffusionhyper-Rayleigh et lʼutilisation des méthodes de la chimie théorique afin de prédire etdʼinterpréter les propriétés moléculaires. Ces phénomènes de commutationsréversibles et les changements de propriétés qui les accompagnent présentent denombreux intérêts, tant technologiques comme lʼélaboration dʼordinateursmoléculaires quʼau niveau des organismes vivants où de nombreuses fonctionsbiologiques sont basées sur un phénomène de commutation. Les principaux résultatsde nos travaux se situent au niveau de lʼinterprétation des réponses ONL et de leurscontrastes en fonction de la nature, de la position et du caractère donneur/accepteurdes substituants présents sur le squelette des interrupteurs moléculaires. / Molecular switches are compounds presenting the ability to commutereversibly between two or more states in response to external stimuli. The goal of thework is the design of molecular switches exhibiting contrasts of their second-ordernonlinear optical (NLO) properties and the highlight of the structural and electronicparameters leading to large contrasts of first hyperpolarizability (β) via amultidisciplinary approach combining the synthesis of new compounds, thecharacterization of their linear (by UV-Visible absorption spectroscopy) and nonlinearoptical properties (by hyper Rayleigh scattering), and the theoretical simulations inorder to predict and interpret molecular properties. These reversible switchingprocesses and the resulting variations of molecular properties have many interests intechnological area such as the development of molecular computers or in lifesciences since many biological functions are based on commutation mechanisms.The major results of our investigations are the interpretation of the NLO responsesand contrasts as a function of the nature, the positioning, and the donor/acceptorcharacter of the substituents.

This thesis deals with the investigation of the first hyperpolarizabilities (β) of a large number of molecules linked to other molecules either covalently or noncovalently. Chapter 1 gives a brief introduction to supramolecular chemistry and Nonlinear Optics (NLO). A survey of literature pertinent to noncovalently interacting supramolecular assembly and their NLO properties as well as NLO properties of oligomeric systems has been presented. The scope of the present investigation has been described at the end of the chapter. Chapter 2 discusses all the methods used in carrying out this thesis work. The first hyperpolarizabilities (β) of all the compounds have been measured by the hyper Rayleigh scattering (HRS) technique; the experimental details of which are written in this chapter. Various spectroscopic techniques such as NMR, IR, UV-Vis, etc. that were used in the investigation have been presented. The subsequent chapters 3-5 deal with the actual results obtained in this work. In chapter 3 first hyperpolarizabilities of o-, m-, and p-aminobenzoic acids and their oligomers viz., dimer, trimer and tetramer (covalently linked) have been studied. The compounds are synthesized and characterized by various spectroscopic methods and their β values have been measured by HRS. The hyperpolarizability increases in going from the monomer to the dimer but decreases subsequently from the dimer to the trimer to the tetramer. This unexpected trend in β has been attributed to the formation of molecular aggregates in the trimers and tetramers. Further evidences of aggregation come from the results of1H NMR spectroscopy and conductivity measurements. In chapter 4, synthesis, characterization and HRS investigation to probe the formation, dissociation and binding constants of hydrogen bonded supramolecular complexes (noncovalent interaction) formed in solution between 6-amino-2-(pivaloylamino)pyridine and ferrocene functionalized barbituric acid and 5-methoxy-N,N′-bis(6-amino-2-pyridinyl)-1,3-benzenedicarboxamide and ferrocenyl barbituric acid have been described. From the HRS data the stoichiometry of the supramolecular complexes has been determined and compared to that from the NMR data. Some of the complex stoichiometries that are measured by HRS have not been seen in the NMR data and vice versa. The results have been rationalized in terms of the strengths and weaknesses of various spectroscopic methods as applied to this problem. Many fold increase in the β value has been realized in the supramolecular complex formation process. Depolarized HRS experiments have been carried out to obtain structural information on the complexes. In the last chapter the synthesis, characterization and measurements on the first hyperpolarizabilities of unsubstituted tetraphenylporphyrin and its metallated complexes have been presented. Synthesis of supramolecular complexes of ferrocenyl barbituric acid with functionalized porphyrin compounds has been carried out although the amount of the final complex was insufficient for HRS measurements. This chapter ends with a perspective for the future work in the direction.

Des recherches très importantes ont été dédiées à l'étude des composés ferroélectriques de type bronze de tungstène quadratique (TTB). Cette thèse concerne la synthèse et la caractérisation de 7 matériaux TTB de formule générale A6M2M'8O30 (A = Sr2+, Ba2+ ou Pb2+, M = Ti4+, Zr4+ ou HF4+; M' = Nb5+ ou Ta5+). Ces composés cristallins de grande taille ∼100 nm ont été synthétisés sous forme de poudre. Les moyennes expérimentales : diffractions des rayons X, spectroscopie Raman, la microscopie électronique MEB et MET, l'optique non linéaire ONL, ont permis d'établir des relations étroites entre structure et propriétés physiques. Les susceptibilités optiques non linéaires de 2eme et 3eme ordres, χ(2), χ(3) de chaque composés ont été déterminées et les valeurs résultantes du χ(3) ne montrent pas les mêmes caractéristiques que χ(2), car le signal de THG est moins dépendant de structure que SHG qui requiert un milieu non-centrosymétrique. Le décalage fréquentiel (Δσ) des modes de vibrations entre les structures à base de strontium(Sr) et celles à base de Barium(Ba) a été constaté afin d'identifier les signatures propres de ces composés. L'interprétation de ces poudres n'était pas facile car les pics sont très délicats. Nos mesures expérimentales montrent clairement que les positions des pics peuvent être modifiées par le changement cationique au sein des matériaux, plus la maille cristalline est rigide, plus on a des pics plus discernables. La différence est nettement visible là ou l'émission est autour de 808 cm-1 pour la structure (Sr), alors que pour le (Br) elle est autour de 780cm-1. Nous attribuons ce Δσ (28cm-1) à la transition de groupe de symétrie spatiale de Pba2 vers P4bm. L'ensemble des résultats décrits dans ce travail ont montrés la grande variété des paramètres sur lesquels il est possible d'agir afin d'optimiser les compositions en vue d'une application spécifique. / Recently, very significant research has been devoted to the study of ferroelectric compounds of tetragonal tungsten bronze (TTB). This thesis deals with the synthesis and characterization of 7 TTB's material with general formula A6M2M'8O30 (A = Sr2+, Ba2+ or Pb2+, M = Ti4+, Zr4+ or HF4+, M '= Nb5+ or Ta5+). These crystalline compounds of large size ~ 100 nm were synthesized in powder form. The experimental Technics: X-ray diffraction, Raman spectroscopy, scanning electron microscopy SEM and TEM and nonlinear optics NLO, allowed us to establish close relationships between structure and physical properties. The nonlinear 2nd and 3rd order optical susceptibility χ(2), χ(3) of all compounds were determined and the resulting values of χ(3) did not show the same characteristics as measures of χ(2) because the THG signal is less dependent on the structure where SHG signal requires a non-centro-symmetric medium. The frequency shift between the vibration modes of structures containing strontium (Sr) and those based on Barium (Ba) has been detailed to identify signatures of these specific compounds. The interpretation of these powders wasn't that easy as these peaks are very delicate but our experimental results clearly show that the positions of the peaks can be modified by the change in cation materials, as long as the crystal lattice is more rigid, more we get discernible Raman modes. This difference is clearly visible where the emission is around 808 cm-1 for the structure Sr, whereas the Br it is centered around 780cm-1. We attribute these Δσ (28cm-1) to the transition of spatial symmetry group from Pba2 to P4bm. Results showed the wide variety of settings in which it is possible to act in order to optimize the compositions for a specific application.