Spelling suggestions: "subject:"outliers rejection""
1 |
Performance Enhancement of Bearing Navigation to Known Radio Beacons / Prestandaförbättring av navigering efter bäring mot kända radiofyrarErkstam, Erik, Tjernqvist, Emil January 2012 (has links)
This master thesis investigates the performance of a car navigation system using lateral accelerometers, yaw rate and bearings relative three known radio beacons. Accelerometer, gyroscope and position data has been collected by an IMU combined with a GPS receiver, where the IMU was installed in the approximate motion center of a car. The bearing measurements are simulated using GPS data and the measurement noise model is derived from an experiment where the direction of arrival to one transmitter was estimated by an antenna array and the signal processing algorithm MUSIC. The measurements are fused in a multi-rate extended Kalman filter which assumes that all measurement noise is Gaussian distributed. This is not the case for the bearing measurement noise which contains outliers and therefore is modelled as a Gaussian uniform noise mixture. Different methods to deal with this have been investigated where the main focus is on the principle to use the Kalman filter’s innovation for each bearing measurement as an indication of its quality and discarding measurements with a quality above a certain threshold.
|
2 |
Motion Conflict Detection and Resolution in Visual-Inertial Localization AlgorithmWisely Babu, Benzun 30 July 2018 (has links)
In this dissertation, we have focused on conflicts that occur due to disagreeing motions in multi-modal localization algorithms. In spite of the recent achievements in robust localization by means of multi-sensor fusion, these algorithms are not applicable to all environments. This is primarily attributed to the following fundamental assumptions: (i) the environment is predominantly stationary, (ii) only ego-motion of the sensor platform exists, and (iii) multiple sensors are always in agreement with each other regarding the observed motion. Recently, studies have shown how to relax the static environment assumption using outlier rejection techniques and dynamic object segmentation. Additionally, to handle non ego-motion, approaches that extend the localization algorithm to multi-body tracking have been studied. However, there has been no attention given to the conditions where multiple sensors contradict each other with regard to the motions observed.
Vision based localization has become an attractive approach for both indoor and outdoor applications due to the large information bandwidth provided by images and reduced cost of the cameras used. In order to improve the robustness and overcome the limitations of vision, an Inertial Measurement Unit (IMU) may be used. Even though visual-inertial localization has better accuracy and improved robustness due to the complementary nature of camera and IMU sensor, they are affected by disagreements in motion observations. We term such dynamic situations as environments with motion conflictbecause these are caused when multiple different but self- consistent motions are observed by different sensors. Tightly coupled visual inertial fusion approaches that disregard such challenging situations exhibit drift that can lead to catastrophic errors.
We have provided a probabilistic model for motion conflict. Additionally, a novel algorithm to detect and resolve motion conflicts is also presented. Our method to detect motion conflicts is based on per-frame positional estimate discrepancy and per- landmark reprojection errors. Motion conflicts were resolved by eliminating inconsistent IMU and landmark measurements. Finally, a Motion Conflict aware Visual Inertial Odometry (MC- VIO) algorithm that combined both detection and resolution of motion conflict was implemented. Both quantitative and qualitative evaluation of MC-VIO on visually and inertially challenging datasets were obtained. Experimental results indicated that MC-VIO algorithm reduced the absolute trajectory error by 70% and the relative pose error by 34% in scenes with motion conflict, in comparison to the reference VIO algorithm. Motion conflict detection and resolution enables the application of visual inertial localization algorithms to real dynamic environments. This paves the way for articulate object tracking in robotics. It may also find numerous applications in active long term augmented reality.
|
3 |
Omnidirectional Vision for an Autonomous Surface VehicleGong, Xiaojin 07 February 2009 (has links)
Due to the wide field of view, omnidirectional cameras have been extensively used in many applications, including surveillance and autonomous navigation. In order to implement a fully autonomous system, one of the essential problems is construction of an accurate, dynamic environment model. In Computer Vision this is called structure from stereo or motion (SFSM). The work in this dissertation addresses omnidirectional vision based SFSM for the navigation of an autonomous surface vehicle (ASV), and implements a vision system capable of locating stationary obstacles and detecting moving objects in real time.
The environments where the ASV navigates are complex and fully of noise, system performance hence is a primary concern. In this dissertation, we thoroughly investigate the performance of range estimation for our omnidirectional vision system, regarding to different omnidirectional stereo configurations and considering kinds of noise, for instance, disturbances in calibration, stereo configuration, and image processing. The result of performance analysis is very important for our applications, which not only impacts the ASV's navigation, also guides the development of our omnidirectional stereo vision system.
Another big challenge is to deal with noisy image data attained from riverine environments. In our vision system, a four-step image processing procedure is designed: feature detection, feature tracking, motion detection, and outlier rejection. The choice of point-wise features and outlier rejection based method makes motion detection and stationary obstacle detection efficient. Long run outdoor experiments are conducted in real time and show the effectiveness of the system. / Ph. D.
|
4 |
Cooperative Navigation of Autonomous Vehicles in Challenging EnvironmentsForsgren, Brendon Peter 18 September 2023 (has links) (PDF)
As the capabilities of autonomous systems have increased so has interest in utilizing teams of autonomous systems to accomplish tasks more efficiently. This dissertation takes steps toward enabling the cooperation of unmanned systems in scenarios that are challenging, such as GPS-denied or perceptually aliased environments. This work begins by developing a cooperative navigation framework that is scalable in the number of agents, robust against communication latency or dropout, and requires little a priori information. Additionally, this framework is designed to be easily adopted by existing single-agent systems with minimal changes to existing software and software architectures. All systems in the framework are validated through Monte Carlo simulations. The second part of this dissertation focuses on making cooperative navigation robust in challenging environments. This work first focuses on enabling a more robust version of pose graph SLAM, called cycle-based pose graph optimization, to be run in real-time by implementing and validating an algorithm to incrementally approximate a minimum cycle basis. A new algorithm is proposed that is tailored to multi-agent systems by approximating the cycle basis of two graphs that have been joined. These algorithms are validated through extensive simulation and hardware experiments. The last part of this dissertation focuses on scenarios where perceptual aliasing and incorrect or unknown data association are present. This work presents a unification of the framework of consistency maximization, and extends the concept of pairwise consistency to group consistency. This work shows that by using group consistency, low-degree-of-freedom measurements can be rejected in high-outlier regimes if the measurements do not fit the distribution of other measurements. The efficacy of this method is verified extensively using both simulation and hardware experiments.
|
5 |
Robust Optimization for Simultaneous Localization and Mapping / Robuste Optimierung für simultane Lokalisierung und KartierungSünderhauf, Niko 25 April 2012 (has links) (PDF)
SLAM (Simultaneous Localization And Mapping) has been a very active and almost ubiquitous problem in the field of mobile and autonomous robotics for over two decades. For many years, filter-based methods have dominated the SLAM literature, but a change of paradigms could be observed recently.
Current state of the art solutions of the SLAM problem are based on efficient sparse least squares optimization techniques. However, it is commonly known that least squares methods are by default not robust against outliers. In SLAM, such outliers arise mostly from data association errors like false positive loop closures. Since the optimizers in current SLAM systems are not robust against outliers, they have to rely heavily on certain preprocessing steps to prevent or reject all data association errors. Especially false positive loop closures will lead to catastrophically wrong solutions with current solvers. The problem is commonly accepted in the literature, but no concise solution has been proposed so far.
The main focus of this work is to develop a novel formulation of the optimization-based SLAM problem that is robust against such outliers. The developed approach allows the back-end part of the SLAM system to change parts of the topological structure of the problem\'s factor graph representation during the optimization process. The back-end can thereby discard individual constraints and converge towards correct solutions even in the presence of many false positive loop closures. This largely increases the overall robustness of the SLAM system and closes a gap between the sensor-driven front-end and the back-end optimizers. The approach is evaluated on both large scale synthetic and real-world datasets.
This work furthermore shows that the developed approach is versatile and can be applied beyond SLAM, in other domains where least squares optimization problems are solved and outliers have to be expected. This is successfully demonstrated in the domain of GPS-based vehicle localization in urban areas where multipath satellite observations often impede high-precision position estimates.
|
6 |
Robust Optimization for Simultaneous Localization and MappingSünderhauf, Niko 19 April 2012 (has links)
SLAM (Simultaneous Localization And Mapping) has been a very active and almost ubiquitous problem in the field of mobile and autonomous robotics for over two decades. For many years, filter-based methods have dominated the SLAM literature, but a change of paradigms could be observed recently.
Current state of the art solutions of the SLAM problem are based on efficient sparse least squares optimization techniques. However, it is commonly known that least squares methods are by default not robust against outliers. In SLAM, such outliers arise mostly from data association errors like false positive loop closures. Since the optimizers in current SLAM systems are not robust against outliers, they have to rely heavily on certain preprocessing steps to prevent or reject all data association errors. Especially false positive loop closures will lead to catastrophically wrong solutions with current solvers. The problem is commonly accepted in the literature, but no concise solution has been proposed so far.
The main focus of this work is to develop a novel formulation of the optimization-based SLAM problem that is robust against such outliers. The developed approach allows the back-end part of the SLAM system to change parts of the topological structure of the problem\'s factor graph representation during the optimization process. The back-end can thereby discard individual constraints and converge towards correct solutions even in the presence of many false positive loop closures. This largely increases the overall robustness of the SLAM system and closes a gap between the sensor-driven front-end and the back-end optimizers. The approach is evaluated on both large scale synthetic and real-world datasets.
This work furthermore shows that the developed approach is versatile and can be applied beyond SLAM, in other domains where least squares optimization problems are solved and outliers have to be expected. This is successfully demonstrated in the domain of GPS-based vehicle localization in urban areas where multipath satellite observations often impede high-precision position estimates.
|
Page generated in 0.0893 seconds