No description available.

In science and technology there is a steadily increased demand of new materials and new materials production processes since they create new application areas as well as improved production technology and economy. This thesis includes development and studies of a chemical vapour deposition (CVD) process for growth of thin films of the metastable material copper nitride, Cu3N, which is a semiconductor and decomposes at around 300 oC. The combination of these properties opens for a variety of applications ranging from solar cells to sensor and information technology. The CVD process developed is based on a metal-organic compound copper hexafluoroacetylacetonate, Cu(hfac)2 , ammonia and water and was working at about 300 oC and  5 Torr. It was found that a small amount of water in the vapour increased the growth rate considerably and that the phase content, film texture, chemical composition and morphology were strongly dependent on the deposition conditions. In-situ oxygen doping during the CVD of Cu3N to an amount of 9 atomic % could also be accomplished by increasing the water concentration in the vapour. Oxygen doping increases the band gap of the material as well as the electrical resistivity and changes the stability. The crystal structure of Cu3N is very open and contains several sites which can be used for doping. Different spectroscopic techniques like X-ray photoelectron spectroscopy, Raman spectroscopy and near edge X-ray absorption fine structure spectroscopy were used to identify the oxygen doping site(s) in Cu3N. Besides the properties, the oxygen doping also affected the morphology and texture of the films. By combining thin layers of different materials several properties can be optimized at the same time. It has been demonstrated in this thesis that multilayers, composed of alternating Cu3N and Cu2O layers, i.e. a metastable and a stable material, could be grown by CVD technique. However, the stacking sequence affected the texture, morphology and chemical composition. The interfaces between the different layers were sharp and no signs of decomposition of the initially deposited metastable Cu3N layer could be detected.

Existing growth methods produce single-walled carbon nanotubes (SWCNTs) with a range of structures and electronic properties, but many potential applications require pure nanotube samples. Density gradient ultracentrifugation (DGU) has recently emerged as a technique for sorting as-grown mixtures of single-walled nanotubes into their distinct ( n,m ) structural forms, but this approach has been limited to samples containing only a small number of nanotube structures, and has often required repeated DGU processing. For the first time, it has been shown that the use of tailored nonlinear density gradient ultracentrifugation (NDGU) can significantly improve DGU separations. This new sorting process readily separated highly polydisperse samples of SWCNTs grown by the HiPco method in a single step to give fractions enriched in any of ten different ( n,m ) species. In addition, minor variants of the method allowed separation of the minor-image isomers (enantiomers) of seven ( n,m ) species. Optimization of this new approach was aided by the development of instrumentation that spectroscopically mapped nanotube contents inside undisturbed centrifuge tubes. Besides, sorted nanotube samples enabled the discovery of novel oxygen-doped SWCNTs with remarkable photophysical properties. Modified nanotube samples were produced using mild oxidation of SWCNTs with ozone followed by a photochemical conversion step that induced well-defined changes in emissive properties. As demonstrated for a set of ten separated SWCNT ( n,m ) structures, chemically altered nanotubes possess slightly lower band gap energies with correspondingly longer photoluminescence wavelengths. Treated samples showed distinct, structure-specific near-infrared fluorescence at wavelengths 10 to 15% longer than the pristine semiconducting SWCNTs. Quantum chemical modeling suggests that dopant sites harvest light energy absorbed in undoped nanotube regions by trapping mobile excitons. The oxygen-doped SWCNTs are much easier to detect and image in biological specimen than pristine SWCNTs because they give stronger near-IR emission and do not absorb at the shifted emission wavelength. This novel modification of SWCNT properties may lead to new optical and electronic applications, as it provides a way to change optical band gaps in whole nanotubes or in selected sections.