No description available.

Submarine power production installations use the power of the ocean to generate renewable energy for the population to use. To bring this electricity back to land, use of electrical cables is required. The choice of cable will affect both the quality of received power and the security of the transmission line. To find the inductance and capacitance of these submarine transmission lines, a study of the electric and magnetic fields that are produced due to the power flow on these cables must be performed. The armor that is used to protect the cable from underwater hazards is significant in determining the cable losses and finding the equivalent inductance and capacitance. Finding the inductance and capacitance of the submarine cable will allow for the determination of the two port parameters of the cable. These parameters will allow for the analysis of the transient and steady state performance of the cable.

Experimental studies were undertaken to improve the radiation dose response and ease of manufacture of polymer gel dosimeters that use N-isopropyl acrylamide (NIPAM) as the monomer. An alternative carageenan gelling agent was tested in place of gelatin. Although the carageenan did reduce the gelling time for the dosimeter solution, the dose response of the dosimeters was unsatisfactory. An alternative antioxidant system, ascorbic acid and Cu2+, was investigated with the aim of reducing the toxicity of dosimeter materials and providing opportunities for commercial production of prepackaged dosimeter kits. Unfortunately, the new antioxidant was ineffective for the NIPAM-based dosimeters that were studied. Three cosolvents, glycerol, N-propanol and isopropanol, were used to increase the solubility of N,N’-methylene-bisacrylamide (Bis) crosslinker in polymer gel dosimeter recipes that use NIPAM. These cosolvents enabled the manufacture of polymer gel dosimeters with higher levels of dissolved crosslinker than was previously possible. Preliminary results using x-ray computed tomography to read the resulting gels are very promising, due to enhancements in dose sensitivity. Dosimeters with high N,N’-methylene-bisacrylamide content that used isopropanol or glycerol as cosolvents had good optical clarity prior to irradiation, but did not produce reliable optical CT results for non-uniformly-irradiated gels. Further experiments and recipe optimization are required to determine whether gels with cosolvents and high levels of N,N’-methylene bisacrylamide can be used effectively for verifying spatially non-uniform dose distributions using x-ray computed tomography. A mathematical model that includes inhibition of NIPAM-Bis polymerization was developed and the inhibition effects of MEHQ and oxygen in polymer gel dosimeters were simulated. Kinetic parameters were obtained from the literature and were estimated using experimental data obtained by our research group. Good agreement was obtained between model predictions and experimental data with and without oxygen contamination. Simulation results indicate that MEHQ has little influence on the duration of the inhibition period and the rate of polymerization when no oxygen contamination is present, so that removal of MEHQ from dosimeter recipes is not required. Effective oxygen removal is very important to achieve reliable dosimeter results. / Thesis (Master, Chemical Engineering) -- Queen's University, 2008-12-16 15:59:14.034

No description available.

No description available.

Yeasts form an important part of many ecosystems and significantly contribute to biodiversity. However, yeast biodiversity in the North West Province remains largely unexplored. The aim of this study was to determine the diversity and characteristics of yeasts from water sources in the North West Province, South Africa. Samples were collected over a two year period and included three rivers, a spruit and an inland lake. Temperature, pH, and electrical conductivity (EC) were measured on site using a multi-probe. Nitrate (NO3-N), nitrite (NO2-N) and phosphate (PO42-) levels were determined in the laboratory using Hatch kits and equipment. The pH ranged from 7.2 to 9.2. Elevated EC levels (36-70 mS) were detected especially at the Harts River and Barberspan (38-165 mS) sites. Physico-chemical parameter levels were higher during the cold dry sampling period compared to the warm rainy sampling period. Levels and diversity of yeasts were determined using the membrane filtration method. The highest level of yeasts was detected in the Mooi River and Schoonspruit during 2010 and 2011 sampling periods. Pigmented and non-pigmented yeasts were enumerated from all samples. Over the two year period the highest number of pigmented yeasts was detected in the Schoonspruit samples. In some cases there were significant (P<0.05) differences between pigmented and non-pigmented yeast levels among the sites. The diazonium blue B (DBB) test was carried out to distinguish between ascomycetous and basidiomycetous yeasts. These isolates were then identified using the API ID 32C system. Yeasts isolates were identified as belonging to the following genera: Candida, Cryptococcus, Pichia, Rhodotorula and Zygosaccharomyces. In addition using 26S rRNA gene sequencing Aureobasidium spp., Clavispora spp., Cystofilobasidium spp., Hanseniaspora spp., Meyerozyma spp., Sporidiobolus spp., and Wickerhamomyces spp.were also identified. The diversity and abundance of yeasts in the water sources demonstrated that opportunistic pathogens were present. This was supported by results that indicated some isolates could grow at 37°C and higher. In conclusion, our results provide preliminary information on the distribution and diversity of yeasts in water sources of the North West Province, South Africa. / Thesis (MSc (Environmental Sciences))--North-West University, Potchefstroom Campus, 2013.

Yeasts form an important part of many ecosystems and significantly contribute to biodiversity. However, yeast biodiversity in the North West Province remains largely unexplored. The aim of this study was to determine the diversity and characteristics of yeasts from water sources in the North West Province, South Africa. Samples were collected over a two year period and included three rivers, a spruit and an inland lake. Temperature, pH, and electrical conductivity (EC) were measured on site using a multi-probe. Nitrate (NO3-N), nitrite (NO2-N) and phosphate (PO42-) levels were determined in the laboratory using Hatch kits and equipment. The pH ranged from 7.2 to 9.2. Elevated EC levels (36-70 mS) were detected especially at the Harts River and Barberspan (38-165 mS) sites. Physico-chemical parameter levels were higher during the cold dry sampling period compared to the warm rainy sampling period. Levels and diversity of yeasts were determined using the membrane filtration method. The highest level of yeasts was detected in the Mooi River and Schoonspruit during 2010 and 2011 sampling periods. Pigmented and non-pigmented yeasts were enumerated from all samples. Over the two year period the highest number of pigmented yeasts was detected in the Schoonspruit samples. In some cases there were significant (P<0.05) differences between pigmented and non-pigmented yeast levels among the sites. The diazonium blue B (DBB) test was carried out to distinguish between ascomycetous and basidiomycetous yeasts. These isolates were then identified using the API ID 32C system. Yeasts isolates were identified as belonging to the following genera: Candida, Cryptococcus, Pichia, Rhodotorula and Zygosaccharomyces. In addition using 26S rRNA gene sequencing Aureobasidium spp., Clavispora spp., Cystofilobasidium spp., Hanseniaspora spp., Meyerozyma spp., Sporidiobolus spp., and Wickerhamomyces spp.were also identified. The diversity and abundance of yeasts in the water sources demonstrated that opportunistic pathogens were present. This was supported by results that indicated some isolates could grow at 37°C and higher. In conclusion, our results provide preliminary information on the distribution and diversity of yeasts in water sources of the North West Province, South Africa. / Thesis (MSc (Environmental Sciences))--North-West University, Potchefstroom Campus, 2013.

Users of current Digital Photogrammetric Systems (DPS) can now rapidly generate dense Digital Elevation Models (DEMs) with a minimal amount of training. This procedure is controlled through a set of strategy parameters embedded in the software. Previous research into the effect of these parameters on the resulting DEMs produc'ed mixed results, with some researchers finding that significant changes to the DEM can be made through manipulation of the parameters whilst others suggested that they have little effect. This thesis builds upon this early work to develop two systems that provide assistance for novice users. The first technique optimises the parameters with respect to DEM accuracy and takes the form of an expert system and compares the output from the DEM with a knowledge base to prescribe an improved set of parameters. The results suggest that the system works and can produce improvements in the accuracy of a DEM. It was found that in certain circumstances, changes to the parameters can have a significant effect on the resulting DEM, but this change does not occur across the entire DEM. The second aspect of the thesis details the development of a completely new approach that automatically detects low accuracy areas of the DEM and presents this information graphically. This is an important development since, as documented in the current literature, few quality control procedures are offered to users. The user can use this information to assist in the manual checking and editing of the final DEM, thus speeding up the workflow and improving the accuracy of the output. The results of tests (using the ERDAS Imagine OrthoMAX software) on a wide variety of imagery are presented and show that the technique reliably detects areas of a DEM with high errors. More significantly, the technique has also been tested on two other DPSs (Zeiss Phodis TS and VirtuoZo) and it was found that it worked well for the Zeiss system but could not be applied to the VirtuoZo software. This demonstrates that the research is not limited to the users of one software package and is of interest to the wider photogrammetric community.

Proefschrift Universiteit van Amsterdam. / Met lit. opg. - Met samenvatting in het Nederlands.

Proefschrift Universiteit van Amsterdam. / Met lit.opg. en samenvatting in het Nederlands.