A pattern-reconfigurable, low-profile, efficient, electrically small, near-field resonant parasitic (NFRP), Huygens source antenna is presented. The design incorporates both electric and magnetic NFRP elements. The electric ones are made reconfigurable by the inclusion of a set of p-i-n diodes. By arranging these electric and magnetic NFRP elements properly, a set of three Huygens sources are attained, each covering a 120 degrees sector. Pattern reconfigurability is obtained by switching the diodes on or off; it encompasses the entire 360 degrees azimuth range. A prototype was fabricated and tested. The numerical and experimental studies are in good agreement. The experimental results indicate that in each of its instantaneous states at f(0) = 1.564 GHz, the antenna provides uniform peak realized gains, front-toback ratios, and radiation efficiencies, respectively, as high as 3.55 dBi, 17.5 dB, and 84.9%, even though it is electrically small: ka = 0.92, and low profile: 0.05 lambda(0).

Research on multiple antenna systems has been a hot topic in recent years due to the demands for higher transmission rate and more reliable link in rich scattering environment in wireless communications. Using multiple antennas at both the transmitter side and the receiver side increases the channel capacity without additional frequency spectrum and transmitted power. However, due to the limited space at the size-limited terminal devices, the most critical problem in designing multiple antennas is the severe mutual coupling among them. The aim of this thesis is to provide compact, decoupled and efficient multiple antenna designs for terminal devices. At the same time, we propose a simple and cost effective method in multiple antenna measurement. All these efforts contribute to the development of terminal devices for the fourth generation wireless communication. The background and theory of multiple antenna systems are introduced first, in which three operating schemes of multiple antenna systems are discussed. Critical factors influencing the performance of multiple antenna systems are also analyzed in details. To design efficient multiple antenna systems in compact terminals, several decoupling methods, including defected ground plane, current localization, orthogonal polarization and decoupling networks, are proposed. The working mechanism and design procedure of each method are introduced, and their effectiveness is compared. Those methods can be applied to most of the terminal antennas, reducing the mutual coupling by at least 6dB. In some special cases, especially for low frequency bands below 1GHz, the chassis of the device itself radiates like an antenna, which complicates the antenna decoupling. Thus, we extend the general decoupling methods to the cases when the chassis is excited. Based on the characteristic mode analysis, three different solutions are provided, i.e., optimizing antenna locations, localizing antenna currents and creating orthogonal modes. These methods are applied to mobile phones, providing a more reliable link and a higher transmission rate, which are evaluated by diversity gain and channel capacity, respectively. In order to measure the performance of multiple antenna systems, it is necessary to obtain the correlation coefficients. However, the traditional measurement technique, which requires the phase and polarization information of the radiation patterns, is very expensive and time consuming. In this thesis, a more practical and convenient method is proposed. Fairly good accuracy is achieved when it is applied to various kinds of antennas. To design a compact and efficient multiple antenna system, besides the reduction of mutual coupling, the performance of each single antenna is also important. The techniques for antenna reconfiguration are demonstrated. Frequency and pattern reconfigurable antennas are constructed, providing more flexibility to multiple antenna systems. / QC 20120604