Structural Health Monitoring (SHM) is a means of identifying damage from the structural response to environmental loads. Real-time SHM offers rapid assessment of structural safety by owners and civil defense authorities enabling more optimal response to major events. This research presents an real-time, convex, integral-based SHM methods for seismic events that use only acceleration measurements and infrequently measured displacements, and a non-linear baseline model including hysteretic dynamics and permanent deformation. The method thus identifies time-varying pre-yield and post-yield stiffness, elastic and plastic components of displacement and final residual displacement. For a linear baseline model it identifies only timevarying stiffness. Thus, the algorithm identifies all key measures of structural damage affecting the immediate safety or use of the structure, and the long-term cost of repair and retrofit. The algorithm is tested with simulated and measured El Centro earthquake response data from a four storey non-linear steel frame structure and simulated data from a two storey non-linear hybrid rocking structure. The steel frame and rocking structures exhibit contrasting dynamic response and are thus used to highlight the impact of baseline model selection in SHM. In simulation, the algorithm identifies stiffness to within 3.5% with 90% confidence, and permanent displacement to within 7.5% with 90% confidence. Using measured data for the frame structure, the algorithm identifies final residual deformation to within 1.5% and identifies realistic stiffness values in comparison to values predicted from pushover analysis. For the rocking structure, the algorithm accurately identifies the different regimes of motion and linear stiffness comparable to estimates from previous research. Overall, the method is seen to be accurate, effective and realtime capable, with the non-linear baseline model more accurately identifying damage in both of the disparate structures examined.

In this study, dynamic response of Akk&ouml / pr&uuml / Dam under earthquake motions is analyzed and the permanent displacements are evaluated. Initially, the critical slip surface of the dam and the corresponding yield acceleration are determined by using the computer program SLOPE. Then, by employing the finite element program SAP2000, static analyses are performed to obtain the mean effective stresses which are used in the determination of dynamic material properties of the dam. Four different scenario earthquakes having a magnitude of 7 are used in the dynamic analyses. Two of those scenarios are taken from European Strong Motion Database and the others are generated by XS artificial earthquake generation program prepared by Erdik (1992). Dynamic analyses of the dam are carried out by the finite element program TELDYN. Permanent displacements of the critical slip surface are calculated by utilizing the Newmark method. Consequently, for an earthquake having a magnitude of M=7 and a peak ground acceleration of 0.20g, the maximum permanent displacement of the dam is found to be 15.90 cm. Furthermore, the permanent displacements of the dam are calculated under base motions having different peak ground acceleration values and it is observed that the rate of increase in the amount of permanent displacements is greater than the increase in the amount of peak ground accelerations.

This study is an evaluation on the seismic behavior of the Nahrain Dam, which is located in Khorasan province in the central part of Iran. The finite element method is used for the dynamic analysis of the dam. Using a slope stability computer program, the critical slip surface near the crest of the dam and the yield acceleration corresponding to this slip surface are determined. Static analysis was completed by using the finite element computer program SAP90 and SAP2000 in order to determine the stress conditions within the body of the dam prior to earthquake. The stresses obtained from this analysis were used in the assessment of the dynamic material properties of the dam. Two near by actual earthquakes were modified and used as input motions of different magnitudes. At the next step, the harvested data was used as input data for the program TELDYN to perform dynamic analysis. Permanent displacements under the scenario base motions were calculated by using the Newmark&rsquo / s method.