For any communication, the conveyed information must be carried by some physical system. If this system is a quantum system rather than a classical one, its behavior will be governed by the laws of quantum mechanics. Hence, the properties of quantum mechanics, such as superpositions and entanglement, are accessible, opening up new possibilities for transferring information. The exploration of these possibilities constitutes the field of quantum communication. The key ingredient in quantum communication is the qubit, a bit that can be in any superposition of 0 and 1, and that is carried by a quantum state. One possible physical realization of these quantum states is to use single photons. Hence, to explore the possibilities of optical quantum communication, photonic quantum states must be generated, transmitted, characterized, and detected with high precision. This thesis begins with the first of these steps: the implementation of single-photon sources generating photonic qubits. The sources are based on photon-pair generation in nonlinear crystals, and designed to be compatible with fiber optical communication systems. To ensure such a compatibility and to create a high-quality source, a theoretical analysis is made, optimizing the coupling of the photons into optical fibers. Based on the theoretical analysis, a heralded single-photon source and a two-crystal source of entangled photons-pairs are experimentally implemented. The source of entangled photons is further developed into a compact source with a narrow bandwidth compatible with standard telecommunication wavelength-division multiplexers, and even further developed to a more stable one-crystal source. The sources are to be used for quantum communication in general and quantum cryptography in particular. Specifically, a heralded single-photon source is implemented and then used for a full test of a decoy-state quantum cryptography protocol. / QC 20100914

Non-classical light sources are a fundamental building block of quantum photonic technologies. As these photonic technologies require higher numbers of sources and more specific source properties, it becomes increasingly important to characterize and manipulate these sources effectively. This thesis consists of three main projects, all relating to non-classical sources of light. First, we present a method for the rapid measurement of the joint spectral intensity of fiber-based photon pair sources. This method extends the concept of Stimulated Emission Tomography, using a chirped, broadband seed beam to stimulate the four wave mixing interaction. The use of the broadband seed, generated through supercontinuum generation, allows for measurements on the few second timescale and requires only a single pump laser to achieve high resolution joint spectra. In the second project, we use this characterization tool to test a variety of different fiber-based photon pair sources. We use three different modification approaches (bending, squeezing, and tapering) to induce changes in the joint spectral properties of the photon pair sources. We show that each of these modifications has some impact on the joint spectra measured. The resulting joint spectra are very complex, highlighting the importance of performing measurements rather than relying on calculations alone. Lastly, we demonstrate a fast switch for the manipulation of single photons. The switch uses the optical Kerr effect to rotate the polarization state of single photons at ultrafast timescales. The implementation of this switch is experimentally straightforward, using a commercial, single mode fiber as the Kerr medium and nJ level pump powers. We operate at an 80 MHz repetition rate and measure 97% switching efficiency, picosecond level switching speed, and approximately 800:1 signal to noise ratio from the operation.