Corrosion of steel tendons is a major problem for post-tensioned concrete, especially because corrosion of the steel strands is often hard to detect inside grouted ducts. Non-metallic tendons can serve as an alternative material to steel for post-tensioning applications. Carbon fiber reinforced polymer (CFRP), given its higher strength and elastic modulus, as well as excellent durability and fatigue strength, is the most practical option for post-tensioning applications. The primary objective of this research project was to assess the feasibility of the use of innovative carbon fiber reinforced polymer (CFRP) tendons and to develop guidelines for CFRP in post-tensioned bridge applications, including segmental bridges and pier caps. An experimental investigation and a numerical simulation were conducted to compare the performance of a scaled segmental bridge model, post-tensioned with two types of carbon fiber strands and steel strands. The model was tested at different prestress levels and at different loading configurations. While the study confirms feasibility of both types of carbon fiber strands for segmental bridge applications, and their similar serviceability behavior, strands with higher elastic modulus could improve structural performance and minimize displacements beyond service loads. As the second component of the project, a side-by-side comparison of two types of carbon fiber strands against steel strands was conducted in a scaled pier cap model. Two different strand arrangements were used for post-tensioning, with eight and six strands, respectively representing an over-design and a slight under-design relative to the factored demand. The model was tested under service and factored loads. The investigation confirmed the feasibility of using carbon fiber strands in unbonded post-tensioning of pier caps. Considering both serviceability and overload conditions, the general performance of the pier cap model was deemed acceptable using either type of carbon fiber strands and quite comparable to that of steel strands. In another component of this research, creep stress tests were conducted with carbon fiber composite cable (CFCC). The anchorages for all the specimens were prepared using a commercially available expansive grout. Specimens withstood 95% of the guaranteed capacity provided by the manufacturer for a period of five months, without any sign of rupture.

The influence of the recommended LRFD Guidelines for the seismic design of highway bridges in Virginia was investigated by analyzing two existing bridges. The first bridge has prestressed concrete girders and is located in the Richmond area. The second bridge has steel girders and is located in the Bristol area. The analysis procedure for both bridges is similar. First the material and section properties were calculated. Then the bridge was modeled in RISA 3D. Live and dead load were imposed on the bridge to calculate the cracked section properties of the bridge. The period of vibration of the bridge was also calculated. After the soil class of the bridge was determined, the design response spectrum curve of the bridge was drawn. The spectral acceleration obtained from the design spectrum curve was used to calculate the equivalent earthquake loads, which were applied to the superstructure of the bridge to obtain the earthquake load effects. Live and dead loads were also applied to get the live and dead load effects. The combined effects of the dead, live and earthquake loads were compared to the interaction diagram of the columns and moment strength of the columns. The details of the bridge design were also checked with the corresponding seismic design requirement.A parametric study was performed to explore the effects of different column heights and superstructure heights in different parts of Virginia. The column longitudinal reinforcing was increased to satisfy the bridge axial loads and moments that are not within the column interaction diagram. / Master of Science