Laser-induced breakdown spectroscopy (LIBS) is a fast analytical method, but can also be complicated. This spectroscopic method is used to provide a qualitative and quantitative analysis of a sample. The analysis is carried out by capturing the emission radiation of the generated plasma. The accuracy and stability of the measurement is affected by several parameters, such as stability of the laser, physical and chemical properties of the sample, its homogeneity and others, that can not always be eliminated. For this reason other methods are being added to the LIBS experiment that could improve the quality of this analysis. This diploma thesis is focused on a research of the literature on the standardization of laser-induced plasma signal and the possibility of using an acoustic signal for this purpose. For this reason , it is necessary to perform basic experiments and to verify if the acoustic signal correlates with the emission signal. If these signals correlate together, it would be possible to use the acoustic signal for standardization og the LIBS data, which would improve the accuracy of the analysis. In the theoretical part at the beginning other spectroscopic methods are summarised. Then the work is focused on the description of the LIBS method, possible ways of the analysis, standardization of emission signals and its review in the literature. The experimental part is aimed at the study of the acoustic signal that was performed in the framework of this study. At the beginning, there are introduced results of the basic measurements on steel and brass samples. These results were important for an optimization of the experiment. The following section shows the results obtained from the measurements of the acoustic signal on the samples with the same chemical composition but different hardness. At the end the correlation between the acoustic and emission signals is discussed.

High-resolution Thomson scattering system on the COMPASS tokamak provides electron temperature and density profiles in the central and edge plasma region. The spatial resolution in the edge plasma region is optimized for edge transport barrier studies. Formation of characteristic edge profiles (pedestals) is observed during high-confinement mode, i.e. the core electron temperature and density are raised up by the value of pedestal height. Both the electron and density pedestals are well-fitted by a modified hyperbolic tangent (mtanh) function, a five parameter model giving important parameters such as pedestal height and width, necessary for further analysis of the physics behind the transport barrier formation. A fitting technique of the full radial profiles of electron temperature, density and pressure during H-mode is also described. Using the fitting, electron temperature and density on top of pedestal are statistically processed to find a possible threshold for various H-mode regimes.

The work concerns in modern surface treatment, such as cold plasma. The main aim of this work was to find out the effect of plasma treatment on the surface of wood applied before glue treatment which is influential in final quality of glueing. The work compares the firmness of glued joint of solid wood-fibre slab -- HDF and locust tree on groups of samples of treated and non-treated surface in different plasma discharges. The first part of the work comprises a summary of knowledge in the plasma field and glueing and it attempts to establish a general overview of present development in research in the field of examined issue. The second part of the work deals with method of performed experiment according to the researched norms. Results of the work have proven that plasma preparatory treatment influences the firmness of glueing and at a certain type of use of plasma discharge we can improve the quality of glued joint.

This master thesis deals with examination of the parameters of low temperature plasma which is used for the deposition of thin layer of ITO. The method which is used in this thesis is the probe diagnostics. This thesis is divided into two parts. The first is the theoretical part, in which the basic parameters of low temperature plasma, principles of the probe diagnostics, and theories for this method are explained. The second part is the practical part, which presents the results of the measurement depending on changes in conditions of deposition.

Electromagnetic waves are crucial for energy transfer in the nearly collision- less plasma of the Earth's inner magnetosphere. The waves in the frequency range 1-8 kHz whose visualisation in the form of frequency-time spectrograms reveals a harmonic frequency modulation of the wave intensity are called magnetospheric line radiation (MLR). Waves characterized by a nearly periodic time modulation of the wave intensity observed at frequencies between about 0.5 and 4 kHz are called quasiperiodic (QP) emissions. Although both types of the events were re- peatedly observed by ground-based instruments and low-altitude satellites, their origin remains still unclear. Between 2004 and 2010 these wave events were me- asured by the DEMETER spacecraft (almost Sun-synchronous orbit, altitude of about 700 km). This thesis presents a systematic study of the properties of the observed events, a comparison of the observations by the spacecraft and ground- based instruments, and an investigation of a relation to solar wind parameters.

The diploma thesis is focused on the study of low-temperature plasma by methods of computational physics, namely particle modelling. The solution focuses on the time- effective execution of simulations, which is concerned, among the other things, with the use of parallelization techniques aimed at maximize shortening of the calculation time. The Langmuir probe was chosen as the most common representative of the probe diagnostics. The main goal of this work was to observe plasma interaction with the embedded solid. Current research on plasma modelling intensively explores dynamic phenomena such as wave propagation or turbulence and instability. For this reason, much of the work is devoted to the dynamics in electropositive and electronegative plasma.

Submitted work concerns with the theoretical and practical requirements for an automatic characterization of samples by means of Laser-Induced Breakdown Spectroscopy (LIBS). Theoretical aspects of laser-matter interaction, plasma expansion, and plasma emission are described theoretically within this work. The description of the plasma emission is enhanced with the spectral detection systems and statistical properties of the plasma. The principle of the automatic characterization is based on the multivariate data analysis theoretical background, which presents recent trend and fundamental approach for automatic spectra analysis in LIBS. Theoretical knowledge is manifested in six applications, which are presented as a comment to published manuscripts. These publications push the frontiers of automatic spectra processing in LIBS.

The aim of the submitted work is a comparison of methods of quantitative analysis used in laser-induced breakdown spectroscopy (LIBS). The principles of LIBS method are explained at first, followed by a research of the most often used methods of quantitative analysis. The next part provides their description enabling a better comprehension and an eventual use of the methods in practice. Finally, the chosen methods are used to process data from the real experiment and the results are compared.

In this work I present a study dedicated to the penetration of whistler- mode waves to the ionosphere. An algorithm of automatic detection of whist- lers in spectrograms computed from the data measured on the DEMETER sa- tellite is described. A method of causative lightning detected by the EUCLID lightning detection network assignment to a detected whistlers is described. Results of statistical study dedicated to relationship between the detected whistlers and assigned causative lightning. Based on the proccessing of data from 364 passes of the DEMETER satellite over monitored area is shown, that mean whistler amplitude decreases with distance between the causative lightning, increses with causative lightning current and in the evening is ap- proximately three times higher than in the morning. A study dedicated to subprotonospheric whistlers is presented. We found, that subprotonospheric whistler causative lightnings currents are very high compared to that of usual 0+ whistlers.

The ball-pen probe is a unique probe recently developed at the Institite of Plasma Physics in Prague. It has been designed for direct measurement of plasma potential at the CASTOR tokamak. Nowadays, it is used routinely at several tokamaks in Europe, and the first tests in low-temperature plasma have also already been performed. The aims of the thesis are primarily experimental. A ball-pen probe has been constructed from available materials, which is suitable for systematic measurements of radial profiles in the low-temperature plasma of a cylindrical magnetron. By means of comparison to other diagnostics, it was proved that ball- pen probe is able to directly measure plasma potential in a certain range of plasma parameters even though its current-voltage characteristic is not symmetric, which is in contradiction with the simplified theory for ball-pen probe. Powered by TCPDF (www.tcpdf.org)