Despote the indisputable advantages of fine-pitch components, is need to calculate with a few trouble during production, especially increased requirements for accuracy of mounting and solder printing. In this work I’m concerned with problems of solder printing for these components and evaluation using SPC. For the evaluation I used 3D paste inspection based on laser scanning of the surface. The output of this work is to describe the principles of solder printing and elaborating of GR&R, SPC analysis and histograms of solder printing for some outputs. I focused in my master thesis on motive design change of problematic components and economic evaluation of the adjustments.

The aim of this master´s thesis is to analyze core losses of a small induction motor. Analyzed values are obtained from laboratory measurements, software analysis and 2D finite element method simulation. The theoretical part of this thesis consists of two parts. The analysis of the higher spatial harmonics presents in the induction motor and the analysis of core losses of the motor. Practical part consists of laboratory measurements according to ČSN. Measured values are used to calculate individual losses. The next part consists of creating a model for software analysis (Maxwell RMxprt). The generated model is converted into a 2D simulation environment (Maxwell 2D), where it is adapted to obtain values from the examined parts (rotor and stator teeth and rotor cage). Results of simulations at different loads are compared and analyzed from the point of view of higher harmonics.