Nowadays, when environmental concerns are becoming increasingly important are there great interest in natural materials and recyclability. The possibility of reusing materials with maintained mechanical properties are essential for sustainability. Today produced approximately 90,000 tons of natural fiber reinforced composites in Europe of those are 40,000 tons compression molded of which the automotive industry uses 95%. Natural fiber reinforced composites is recyclable and therefore interesting in many applications. Also, natural fiber reinforced composites is inexpensive, light in weight and shows decent mechanical properties which makes them attractive to manufactures. However, the problem with natural fiber reinforced composites is the poor adhesion between fiber and matrix, the sensitivity of humidity and their low thermal stability. Those problems could be overcome by addition of compatibilizer and reactive filler. This study will examine the technical requirement in order to develop a sustainable and recyclable biocomposite. It investigates the composition of matrix (polypropylene), fiber (flax), compatibilizer (maleic anhydride grafted polypropylene) and reactive filler (CaO) in order to obtain various combinations of stiffness, strength and processability. The two main methods used for preparing samples were compounding and injection molding. Results shows that 20 wt% flax was the optimal fiber content and that maleic anhydride grafted polypropylene is a very good compatibilizer by enhancing the strength significant. Surprisingly was the strength impaired due to the addition of CaO. The composition of 20 wt% flax, 1 wt% maleic anhydride grafted polypropylene and 79 wt% polypropylene is the technically most favorable composition.

The current generation of Glass Ionomer Cements (GICs) have many advantageous properties over other dental restorative materials but lack the compressive strength of these other materials. The aim of this project is to increase the compressive strength of conventional Glass Poly-Vinyl-Phosphonate cement by inclusion of reactive sub-micron filler particles. The setting characteristics, chemical reactivity and cement strength have been found using oscillating rheology, infrared spectrometry, nuclear magnetic spectrometry, transmission electron microscopy, potentiometer analysis, laser diffractometry and mechanical analysis. The addition of sub-micron filler particles in direct weight by weight replacement of aluminosilicate glass of a control material has increased the ultimate compressive strength of the new cement from 206MPa (control) to 250MPa after 365 days of aging. The strength of the new filler enhanced cements were comparable with the control material after 3 hours. The setting chemistry of the filler enhanced cements follows the same order as the control cement but at a decelerated rate. Theoretical modelling found that a large volume of sub-micron filler could fit into interstitial spacing in formed cement however the alteration of the aluminosilicate glass to polyelectrolyte ratio has been found to drastically alter the cement setting time. The use of cubic and polyhedral shaped filler particles as supposed to spherical particles may increase the cement strength further as greater packing densities are achieved. The formulation of a Glass Ionomer Cement with increased compressive strength may find use as a posterior restorative or as a better material for restoration of lesions and cavity liners.