>Magister Scientiae - MSc / Coal combustion accounts for over 40 % of the world's energy production and this figure is projected to increase with increasing human population and industrialization. The combustion of coal leads to the generation of waste products such as fly ash (FA), brine from water treatment, bottom ash, slag, flue gas desulphurization products (FGD) and gas emissions such as N20, and C02. The emissions contribute to air pollution and global warming, while FA, brines, and FGD are possible soil and water pollutants. In order to minimize the environmental impact of coal combustion, mitigation of the effects of coal burning processes such as the waste products (FA, brine, bottom ash, slag and FGD) and gas emissions is required. This study investigated utilization of the Secunda FA (class F) and reverse osmosis (RO) Tutuka brine to sequester C02 in an attempt to make coal power production more environmentally sustainable. It was hypothesized that South African FA and brine could sequester C02 through mineral carbonation. A statistical approach was undertaken to optimize the % CaC03 formed from FAlbrine/C02 interaction with input parameters of temperature, pressure, particle size and solid/liquid ratio (S/L) being varied. The ranges adopted for the input parameters were: temperature of 30°C or 90 °C; pressure of 1 Mpa or 4 Mpa; four particle sizes namely bulk ash, > 150 11m, < 20 11m and 20 urn- 150 11m particle size range; S/L ratios ofO.1, 0.5 or 1. The FA! brine dispersions were carbonated in a high pressure reactor varying the above mentioned input parameters. The fresh Secunda FA of various size fractions was characterized morphologically using scanning electron microscopy, chemically using X-ray fluorescence and mineralogically using qualitative X-ray diffraction. The carbonated solid residues on the other hand were characterized using quantitative X-ray diffraction, scanning electron microscopy, thermal gravimetic analysis and Chittick tests. The raw brine from Tutuka together with the carbonation leachates were characterized using inductively coupled mass spectrometry and ion chromatography. Total acid digestion was carried out to evaluate the differences in the total elemental content in both the fresh ash and the carbonated solid residues. The results suggested that South African FA from Secunda belongs to class F based on the CaO content as well as the total alumina, silica and ferric oxide content, while the RO brine from Tutuka were classified as NaS04 waters. Mineral carbonation occurred and ranged between 2.75 % and 6.5 % of CaC03 depending on the input parameters. Two polymorphs of CaC03 were identified in the carbonated residues i.e. calcite and aragonite. The carbonated ash/brine leachates were cleaner with respect to major and trace element concentration compared to raw brine thus the carbonation process could be used to improve the quality of brines generated in the power industry. Removal of the major elements from brine was as follows Ca-74.8 %, Na- 28.7 %, Mg- 98 %, K- 82.9 %, S04- 20.8 %. Hundred percent removal was observed for traces of Fe, Al, Mn, Cu, Zn, Pb, Ni, As, Ti, Sr, Se, Si and N03. However Mo, V, B, and Cl concentrations increased by 72.5 %, 94 %,48.2 % and 7.2 % respectively after carbonation at 90°C, 4 Mpa, S/L ratio of 1 using the bulk ash. The parameters found to be of most significance in the carbonation process were the main effects of temperature, particle size and S/L ratio while the interactions of temperature and particle size as well as the interaction of temperature with S/L ratio were also found to be significant. The statistical approach led to a clear understanding of the effect of each input parameter as well as the ansmg interactions. The conditions of 90°C, 4 Mpa, using bulk ash at a S/L ratio of 1 resulted in the highest yield of % CaC03 with a value of 6.5 %. Theoretically one ton of Secunda FA containing 9.2 % of CaO could sequester 0.083 tons of C02. With the optimized protocol developed in this study bearing in mind that the carbonation efficiency is 75.54%, 1 ton of Secunda FA could sequester 0.062 tons of CO2. This translates to 0.65 % of CO2 produced annually at Secunda plant being sequestered in the FAlbrine dispersions. In other words, 16 tons of FA are required to sequester a ton of C02 annually. It was also observed that carbonation using brine resulted in higher carbonation efficiency than carbonation using water as the Ca2+ component in the brine contributed towards the Ca 2+concentration.

Yes / In order to improve the performance of the reverse osmosis (RO) desalination plant powered by photovoltaic (PV), two cooling systems were proposed in this study to cool the PV and preheating the RO feed water as well. In the cooling design (1), the cooling fluid flows in direct contact with the back surface of the PV through channels of half circular cross-sections. While in the design (2), it flows through channels of squar cross-sections fixed on the PV back surface. Two nano-fluids were also tested as cooling fluid: H2O/CuO and H2O/Al2O3, in addition to distilled water for the purpose of comparison. The effect of changing the weight concentration of the nano-fluid (0.05, 0.1, and 0.15%) on the PV performance was also investigated. The results showed that the PV integrated with the cooling design (1) achieves better performance compared to design (2) at all studied cooling fluids. The improvements in the electric efficiency of the PV integrated with design (1) reached 39.5, 34.8 and 27.3 % when CuO and Al2O3 nano-fluids and distilled water were used as cooling fluid, respectively, compared to the uncooled PV. Based on the obtained experimental results, the PV integrated with design (1) was selected to power the RO with H2O/CuO nano-fluid of weight concentration 0.15% and flow rate 0.15 kg/s being used as the coolant. The RO powered by the improved PV was tested at different salinities of brackish water when the preheating technique was implemented. The results showed that the proposed PV-RO desalination system produces 366 l/day when brackish water of salinity 3000 ppm was used.