1 |
slowly released, persulfate, methyl tertiary-butyl ether(MTBE), benzene, in-situ oxidative wallKuo, Yu-chia 25 August 2009 (has links)
Contamination of soil/groundwater supplies by gasoline and other petroleum-derived hydrocarbons released from underground storage tanks (USTs) is a serious and widespread environmental problem. Corrosion, ground movement, and poor sealing can cause leaks in tanks and associated piping. Petroleum hydrocarbons contain methyl tertiary-butyl ether (MTBE) (a fuel oxygenate), benzene, toluene, ethylbenzene, and xylene isomers (BTEX), the major components of gasoline, which are hazardous substances regulated by many nations.The objective of this proposed study is to assess the potential of using a passive in situ oxidation barrier system. This passive active barrier system has advantages over conventional systems including less maintenance, cost-effectiveness, no above-ground facilities, no groundwater pumping and reinjection, and groundwater remediation in situ. The oxidation barrier system included a persulfate-releasing barrier, which contains persulfate-releasing materials. The slow-released persulfate would oxidize MTBE and benzene in aquifer. The persulfate-releasing materials would release persulfate when contacts with groundwater, thus oxidizes the MTBE and benzene. In the first part of this study, bench scale experiment was also performed to produce the persulfate-releasing materials high persulfate-releasing rate. The components of the persulfate-releasing materials and optimal concentrations of those components were determined in this study. Results indicate that the highest persulfate releasing rate can be obtained when the mass ratio of cement/sand/water was 1.4/0/0.7. Result obtained from the persulfate-releasing materials test and bench-scale were used for the design and operation of the following column experiments. Results from the column experiment indicate that approximately 98% of MTBE and 99% of benzene could be removed during the early persulfate-releasing stage. Results also reveal that the produced oxidation byproducts of MTBE, tert-butyl formate (TBF) and tert-butyl alcohol (TBA), can also be produce an acetone. Results from this study suggest that extra Fe(II) would cause the decrease in oxidation rates due to the reaction of sulfate with Fe(II). Results show that the parameters, which would affect the oxidation rate include persulfate concentration, oxidant reduction potential (ORP), conductivity, sulfate concentration, and contaminant concentration. The proposed treatment scheme would be expected to provide a more cost-effective alternative to remediate MTBE and other petroleum-hydrocarbon contaminated aquifers. Knowledge obtained from this study will aid in designing a persulfate oxidation system for site remediation.
|
Page generated in 0.0471 seconds