Thesis (Ph.D.)--Massachusetts Institute of Technology, Dept. of Physics, 1981. / MICROFICHE COPY AVAILABLE IN ARCHIVES AND SCIENCE. / Vita. / Includes bibliographical references. / by Paolo Rava. / Ph.D.

Thesis (M. S.)--Electrical and Computer Engineering, Georgia Institute of Technology, 2009. / Committee Chair: Gregory Durgin; Committee Member: Andrew Peterson; Committee Member: Bernard Kippelen.

Thesis. 1976. Ph.D.--Massachusetts Institute of Technology. Dept. of Aeronautics and Astronautics. / Microfiche copy available in Archives and Barker. / Vita. / Includes bibliographical references. / by Roderick A. Hyde. / Ph.D.

Thesis (Ph. D.)--University of Wisconsin--Madison, 1965. / Typescript. Vita. Description based on print version record. Includes bibliographical references.

MSc (Physics) / Department of Physics / Currently the dye sensitized solar cells have attracted more attention due to their low cost, transparency and flexibility. These types of solar cells use the dye molecule adsorbed on TiO2 semiconductor in Nano architecture with the role of absorbing photons, in recent research attempts are being made to shifts the absorption spectral of TiO2 to visible and near infrared–region of solar spectrum to achieve maximum photo absorption which yields to an increase in the efficiency of the dye sensitized solar cells. In the current study, density functional theory (DFT) was used to model two croconate dyes (CR1 and CR2), one with an electron donating methyl group (CR1) and the other with an electron –withdrawing caboxyl group (CR2). The geometric, electronic and optical properties of these dyes were compared. The adsorption behaviour of the two dyes on (010 and 100) anatase TiO2 surfaces were investigated in this study by employing first principle calculation based on DFT using a plane-wave pseudo potential method. The generalized gradient approximation (GGA) was used in the scheme of Perdew-Burke Ernzerhof to describe the exchange -correlation function as implemented in the CASTEP package in Material Studio of BIOVIA. The adsorption results shows a spontaneous electron injection followed by efficient regeneration of the oxidized dye molecules by the electrolyte and strong binding ability of CR2 to the TiO2 surface, but also shows a comparable binding strength of CR1. The results of this study will help in the design of high efficient dye for DSSCs. / NRF

The objective of this research is to determine if it is possible to reduce the number of organic solar cells required to power a load using a DC to DC converter thereby reducing the cost of the organic solar array system. An organic solar power system designer may choose an organic implementation of a DC to DC converter to go along with the organic solar cell array. Common DC to DC converters include the buck converter, boost converter, buck/boost converter, and Cuk converter, all of which are not good candidates for organic implementation due to their use of inductors. Organic inductors are relatively more lossy than organic capacitors. So, an inductor-less DC to DC converter, such as the Dickson charge pump, would be a better candidate for organic implementation. Solar cells connected in an array configuration usually do not perform up to their full potential due to current and voltage mismatches between solar cells. These mismatches can be related to each solar cell's circuit model parameters such as the photon current density, diode ideality factor, diode reverse saturation current density, parallel resistance, and series resistance. This research varies these circuit model parameters as dependent variables, and observes the loads and power levels that make the Dickson charge pump a feasible option. The results show that current mismatch does produce an opportunity to use a DC to DC converter to save the use of a few solar cells. However, the Dickson charge pump was found to be infeasible due to an input voltage requirement that could not be met using the tested organic solar cells.