A novel method for determination of tetrabromobisphenol-A (TBBPA), was developed using gas chromatography-negative ion chemical ionization-mass spectrom- etry (GC-NCI-MS). Samples of municipal wastewater treatment plant (WWTP) influent were analyzed for TBBPA. Levels ranged from 1 to 41 ng/L, with an average of 20 ± 14 ng/L. Matrix effects were shown to be 30 ± 17 % in the influent and -30 ± 11 % in membrane permeate. The method limit of quantitation was 0.1 ng/L TBBPA. Sorption of TBBPA to fresh mixed-liquor suspended solids (MLSS) from a membrane bioreactor (MBR) were studied. In a kinetic study, sorption was found to be essentially complete after 12 hours of exposure to MLSS. Log Koc and log Kd were measured at 4.7 ± 0.8 and 1.9 ± 0.8 respectively (n = 22). These values were much higher than modelled estimates based on Kow (p ≥ 0.05), and higher than modelled estimates based on Kow and pKa (p ≥ 0.05). Data was successfully modelled using the Freundlich isotherm, having a Kf value of 8.5 and an n value of 1.7. TBBPA adsorbed to borosilicate glassware, with a wall-loss coefficient (Kw) of 0.15 ± 0.1 (n ≥ 3). TBBPA levels in WWTP influent varied from 13 to 29 ng/L while effluent concentrations varied from 0 to 2.2 ng/L over the same period. Three pilot-scale membrane bioreactors (MBRs) removed less TBBPA during the same time period, though MBR removal was also significant (p ≥ 0.05). Increasing MBR sludge residence time (SRT) increased removal at the 86 % confidence interval (p = 0.14). A nitrifying MABR was shown to remove TBBPA significantly when spiked with ammonia and TBBPA (p ≥ 0.05), showing that nitrifying bacteria can degrade TBBPA. An MABR hollow fibre was found to adsorb TBBPA. Various soluble microbial products (SMP) were studied from MBRs fed munici- pal influent. Using current measurement practices, SMP were shown to be sensitive to matrix effects. Use of the standard addition technique (SA) can compensate for this. Measurements using SA showed SMP degrades rapidly during storage in the fridge and due to freezing. SA was also used to compare commonly used SMP extraction techniques, and showed that extraction method influences recovery.

Aerobic (AeMBRs) and Anaerobic Membrane Bioreactors (AnMBRs) are an essential part of the advanced wastewater treatment options, which offer advantages in terms of higher effluent discharge and smaller footprints over the traditional wastewater treatment. This study evaluates the performance of (AnMBRs) by analyzing the cumulative effect of eleven physico-chemical parameters from the data obtained from the studies conducted from year 2000 onwards. Effect of various parameters such as Solid Retention Time (SRT), Hydraulic Retention Time (HRT), Mixed Liquor Suspended Solids (MLSS), influent Chemical Oxygen Demand (COD), Organic Loading Rate (OLR), influent COD, and temperature on the COD removal, methane production and membrane fouling were evaluated. Spearman’s correlation analysis was performed to investigate the impact of environmental and operational parameters on membrane fouling, COD reduction, EPS/SMP and methane production and explain the results. It should be noted that the literature used has all needed variables; incomplete data sets were removed for the regression analysis, in this case, the fouling rate may be estimated. Of these variables, the fouling rate was significantly correlated only with flux (r = 0.291, p =

Particles and macromolecular components, including biopolymers (protein and carbohydrate), are viewed as the main foulants in the complex feed submerged membrane filtration systems such as membrane bioreactor (MBR). This work focused on two aspects of fouling in complex fluids: 1- Assessing fouling propensity and mechanisms for various model solutions. 2- Using of two specific solutions modelling biomass found in MBR for a better understanding of the fouling mechanisms in submerged MBR processes. Filtrations were carried out with 0.22 ??m PVDF hollow fibre membrane. Alginate was used as a model for polysaccharide, bovine serum albumin (BSA) as a model for protein, (un)washed yeast and bentonite were representing suspended solid contents. According to the data obtained during this study the fouling propensity of each model solution was classified as follow in a decreasing order: Alginate &gt unwashed yeast &gt washed yeast &gt BSA &gt bentonite for one-component solutions; and Alginate-washed yeast &gt Alginate-BSA &gt Alginate-bentonite &gt Alginate-unwashed yeast for two-component solutions. Introducing the alginate increased the reversible fouling (except BSA). Passive adsorption had a significant effect on fouling of alginate even before the beginning of the filtration. Washed yeast and a mixture of washed yeast + BSA were then used as model solutions to simulate the activated sludge found in MBR. The concentration of washed yeast and BSA used in this study were calculated in order for the characterisations of the two model solution to match (in terms of biopolymer contents) those of MBR biomasses reported in the literature. By rinsing, backwashing and chemical cleaning of the membrane, three fouling layers of upper, intermediate and lower were defined respectively. Results obtained from the analysis of the biopolymers found in the cleaning solutions allow a better understanding of the fouling mechanisms occurring for the two model solutions used in this study: for washed yeast, the lower layer and for washed yeast + BSA , the upper and intermediate layers were found to have relatively high biopolymeric composition. This was explained by higher concentration of solids on the membrane surface and by higher biopolymer interactions when washed yeast was mixed with BSA.

Particles and macromolecular components, including biopolymers (protein and carbohydrate), are viewed as the main foulants in the complex feed submerged membrane filtration systems such as membrane bioreactor (MBR). This work focused on two aspects of fouling in complex fluids: 1- Assessing fouling propensity and mechanisms for various model solutions. 2- Using of two specific solutions modelling biomass found in MBR for a better understanding of the fouling mechanisms in submerged MBR processes. Filtrations were carried out with 0.22 ??m PVDF hollow fibre membrane. Alginate was used as a model for polysaccharide, bovine serum albumin (BSA) as a model for protein, (un)washed yeast and bentonite were representing suspended solid contents. According to the data obtained during this study the fouling propensity of each model solution was classified as follow in a decreasing order: Alginate &gt unwashed yeast &gt washed yeast &gt BSA &gt bentonite for one-component solutions; and Alginate-washed yeast &gt Alginate-BSA &gt Alginate-bentonite &gt Alginate-unwashed yeast for two-component solutions. Introducing the alginate increased the reversible fouling (except BSA). Passive adsorption had a significant effect on fouling of alginate even before the beginning of the filtration. Washed yeast and a mixture of washed yeast + BSA were then used as model solutions to simulate the activated sludge found in MBR. The concentration of washed yeast and BSA used in this study were calculated in order for the characterisations of the two model solution to match (in terms of biopolymer contents) those of MBR biomasses reported in the literature. By rinsing, backwashing and chemical cleaning of the membrane, three fouling layers of upper, intermediate and lower were defined respectively. Results obtained from the analysis of the biopolymers found in the cleaning solutions allow a better understanding of the fouling mechanisms occurring for the two model solutions used in this study: for washed yeast, the lower layer and for washed yeast + BSA , the upper and intermediate layers were found to have relatively high biopolymeric composition. This was explained by higher concentration of solids on the membrane surface and by higher biopolymer interactions when washed yeast was mixed with BSA.

El reactor anaerobio de membranas sumergidas (SAnMBR) está considerado como tecnología candidata para mejorar la sostenibilidad en el sector de la depuración de aguas residuales, ampliando la aplicabilidad de la biotecnología anaerobia al tratamiento de aguas residuales de baja carga (v.g. agua residual urbana) o a condiciones medioambientales extremas (v.g. bajas temperaturas de operación). Esta tecnología alternativa de tratamiento de aguas residuales es más sostenible que las tecnologías aerobias actuales ya que el agua residual se transforma en una fuente renovable de energía y nutrientes, proporcionando además un recurso de agua reutilizable. SAnMBR no sólo presenta las principales ventajas de los reactores de membranas (i.e. efluente de alta calidad, y pocas necesidades de espacio), sino que también presenta las principales ventajas de los procesos anaerobios. En este sentido, la tecnología SAnMBR presenta una baja producción de fangos debido a la baja tasa de crecimiento de los microorganismos implicados en la degradación de la materia orgánica, presenta una baja demanda energética debido a la ausencia de aireación, y permite la generación de metano, el cual representa una fuente de energía renovable que mejora el balance energético neto del sistema. Cabe destacar el potencial de recuperación de nutrientes del agua residual bien cuando el efluente es destinado a irrigación directamente, o bien cuando debe ser tratado previamente mediante tecnologías de recuperación de nutrientes. El objetivo principal de esta tesis doctoral es evaluar la viabilidad de la tecnología SAnMBR como núcleo en el tratamiento de aguas residuales urbanas a temperatura ambiente. Por lo tanto, esta tesis se centra en las siguientes tareas: (1) implementación, calibración y puesta en marcha del sistema de instrumentación, control y automatización requerido; (2) identificación de los parámetros de operación clave que afectan al proceso de filtración; (3) modelación y simulación del proceso de filtración; y (4) desarrollo de estrategias de control para la optimización del proceso de filtración minimizando los costes de operación. En este trabajo de investigación se propone un sistema de instrumentación, control y automatización para SAnMBR, el cual fue esencial para alcanzar un comportamiento adecuado y estable del sistema frente a posibles perturbaciones. El comportamiento de las membranas fue comparable a sistemas MBR aerobios a escala industrial. Tras más de dos años de operación ininterrumpida, no se detectaron problemas significativos asociados al ensuciamiento irreversible de las membranas, incluso operando a elevadas concentraciones de sólidos en el licor mezcla (valores de hasta 25 g·L-1 ). En este trabajo se presenta un modelo de filtración (basado en el modelo de resistencias en serie) que permitió simular de forma adecuada el proceso de filtración. Por otra parte, se propone un control supervisor basado en un sistema experto que consiguió reducir el consumo energético asociado a la limpieza física de las membranas, un bajo porcentaje de tiempo destinado a la limpieza física respecto al total de operación, y, en general, un menor coste operacional del proceso de filtración. Esta tesis doctoral está integrada en un proyecto nacional de investigación, subvencionado por el Ministerio de Ciencia e Innovación (MICINN), con título ¿Modelación de la aplicación de la tecnología de membranas para la valorización energética de la materia orgánica del agua residual y la minimización de los fangos producidos¿ (MICINN, proyecto CTM2008-06809- C02-01/02). Para obtener resultados representativos que puedan ser extrapolados a plantas reales, esta tesis doctoral se ha llevado a cabo utilizando un sistema SAnMBR que incorpora módulos comerciales de membrana de fibra hueca. Además, esta planta es alimentada con el efluente del pre-tratamiento de la EDAR del Barranco del Carraixet (Valencia, España). / Robles Martínez, Á. (2013). Modelling, simulation and control of the filtration process in a submerged anaerobic membrane bioreactor treating urban wastewater [Tesis doctoral]. Editorial Universitat Politècnica de València. https://doi.org/10.4995/Thesis/10251/34102 / TESIS / Premios Extraordinarios de tesis doctorales