No description available.

At present, electronic devices depend upon electric charge to transfer and record information. However, such devices are approaching a scaling limit due to Joule heating. Spintronics offers a solution by exploiting the spin rather than the charge of the electron, since the propagation of spin current can in principle occur without dissipation. Immediate applications lie in magnetic random access memory and novel media for hard disk recording. Within this thesis, the Magneto-optical Kerr effect (MOKE) has been used to measure the static and dynamic magnetic properties of a number of different thin film samples that are of interest for spintronic applications. A femtosecond laser has been used to perform time-resolved MOKE (TRMOKE) and time resolved reflectivity (TRR) measurements simultaneously, which probe the spin and charge dynamics respectively. Measurements have been performed upon a continuous thin film of CrO2 that is known to be half-metallic in bulk form, and a series of YIG/Cu/Ni81Fe19 based structures that are expected to exhibit the spin Seebeck effect (SSE). Chemical vapour deposition (CVD) was used to fabricate the continuous CrO2 thin film on a (100)-oriented TiO2 substrate. Precessional magnetisation dynamics were studied by means of the TRMOKE technique. The dependence of the precession frequency and the effective damping parameter upon the static applied magnetic field were investigated. The precession frequency exhibited a minimum at the hard axis saturation field as expected. However precession was also observed for fields greater than the hard axis saturation value, perhaps suggesting the presence of a twisted magnetic state within the film. TRMOKE and TRR measurements were performed upon the YIG/Cu/Ni81Fe19 based structures for different values of the pump fluence and applied magnetic field. For fixed pump fluence and varying applied field, the frequency of precession is well described by a numerical solution of the Landau-Lifshitz equation for the Ni81Fe19 (permalloy, Py) layer. The frequency, amplitude, damping, phase and chirp of the precessional oscillations was extracted from measurements made with a field of 3 kOe applied at 2.8° from the normal to the sample plane, in a configuration designed to maximise any spin transfer torque (STT) generated by the SSE. The oscillation parameters extracted for trilayer samples and a Py reference sample were found to be very similar. Features indicative of STT predicted by simulations were not observed. This suggests that either the YIG/Cu interface was unable to efficiently transmit spin current within the samples studied here, or else that the STT generated by means of the SSE is too small to be of practical use.

In recent years, Spin Seebeck effect (SSE) emerges as one of the efficient and easiest ways to generate pure spin current for spintronics devices. In this dissertation, we have systematically studied the SSE and related phenomena like spin Hall magneto-resistance (SMR), anomalous Nernst effect (ANE) in functional magnetic oxides for both fundamental understanding of their origins and practical ways to apply into technological devices. The research has been performed on three different systems of topical interest: (i) Y3Fe5O12 (YIG)/Pt and YIG/C60/Pt, (ii) CoFe2O4 (CFO)/Pt and CFO/C60/Pt, and (iii) Nd0.6Sr0.4MnO3 (NSMO). In case of the YIG/Pt structure, we have achieved a new consensus regarding the temperature dependence of the longitudinal SSE (LSSE). For the first time, we have demonstrated the temperature dependence of LSSE in association with the magnetocrystalline anisotropy (HK) and surface perpendicular magnetic anisotropy field (HKS) of YIG in the same YIG/Pt system. We show that on lowering temperature, the sharp drop in LSSE signal (VLSSE) and the sudden increases in HK and HKS at ~175 K are associated with the spin reorientation due to single ion anisotropy of Fe2+ ions. The VLSSE peak at ~75 K is attributed to the HKS and MS (saturation magnetization) whose peaks also occur at the same temperature. The effects of surface and bulk magnetic anisotropies are corroborated with those of thermally excited magnon number and magnon propagation length to satisfactorily explain the temperature dependence of LSSE in the Pt/YIG system. As a new way to reduce conductivity mismatch, promote spin transport, and tune the spin mixing conductance (G) at the YIG/Pt interface, we have deposited an organic semiconductor (OSC), C60, between ferrimagnetic material (FM) and Pt. Transverse susceptibility study on YIG/C60/Pt has shown that the deposition of C60 has reduced HKS at the surface of YIG significantly, due to the hybridization between the dz2 orbital in Fe and C atoms, leading to the overall increase in spin moments and G and consequently the LSSE. Upon lowering temperature from 300 K, we have observed an exponential increase in LSSE at low temperature (a ~800% increment at 150 K) in this system, which is attributed to the exponential increase in the spin diffusion length of C60 at low temperature. On the other hand, similar experiments on CoFe2O4 (CFO)/C60/Pt show a reduction in the LSSE signal at room temperature, due to the hybridization between the dz2 orbital in Co and C atoms that results in the increased magnetic anisotropy. Upon decreasing the temperature below 150 K, we have interestingly observed that LSSE signal from CFO/C60/Pt exceeds that of CFO/Pt and increases remarkably with temperature. This finding confirms the important role played by the spin diffusion length of C60 in enhancing the LSSE. A systematic study of SMR, SSE, and HKS on the YIG/Pt system using the same YIG single crystal has revealed a low-temperature peak at the same temperature (~75 K) for all the phenomena. Given the distinct origins of the SSE and SMR, our observation points to the difference in spin states between the bulk and surface of YIG as the main reason for such a low-temperature peak, and suggests that the ‘magnon phonon drag’ theory developed to explain the temperature-dependent SSE behavior should be adjusted to include this important effect. SSE and ANE studies on NSMO films have revealed the dominance of ANE over SSE in this class of perovskite-structured materials. The substrate-dependent study of the films shows that compressive strain developed due to the large lattice mismatch from LAO gives rise to the enhanced ANE signal. On the same substrate, ANE signal strength increases as the thickness increases. A sign change in ANE has been observed at a particular temperature, which explains that the Anomalous Hall effect (AHE) and ANE in these systems arise due to intrinsic scattering mechanisms. Overall, we have performed the SSE and related studies on the three important classes of functional magnetic oxide materials. We demonstrate the important role of magnetic anisotropy in manipulating the SSE in these systems. With this knowledge, we have been able to design the novel YIG/C60/Pt and CFO/C60/Pt heterostructures that exhibit the giant SSEs. The organic semiconductor C60 has been explored for the first time as a means of controlling pure spin current in inorganic magnetic oxide/metal heterostructures, paying the way for future spintronic materials and devices.

Irreversible thermodynamics is a widely-applicable toolset that extends thermodynamics to describe systems undergoing irreversible processes. It is particularly useful for describing macroscopic flow of system components, whether conserved (e.g., particle number) or non-conserved (e.g., spin). We give a general introduction to this toolset and calculate the entropy production due to bulk and interfacial flow. We compare the entropy production and heating rate of bulk and interfacial transport, as well as interfacial charge and spin transport. We then demonstrate the power and applicability of this toolset by applying it to three systems. We first consider metal oxide growth, and discuss inconsistency in previous theory by Mott. We show, however, that Mott's solution is the lowest order of a consistent asymptotic solution, with the ion and electron concentrations and fluxes going as power series in t^-k/2, where k = 1, 2, .... We find that this gives corrections to the "parabolic growth law" that has oxide thickness going as t^1/2; the lowest order correction is logarithmic in t. We then consider the effect on spin of electric currents crossing an interface between a ferromagnet (FM) and non-magnetic material (NM). Previous theories for electrical potential and spin accumulation neglect chemical or magnetic contributions to the energy. We apply irreversible thermodynamics to show that both contributions are pivotal in predicting the spin accumulation, particularly in the NM. We also show that charge screening, not considered in previous theories, causes spin accumulation in the FM, which may be important in ferromagnetic semiconductors. Finally, we apply irreversible thermodynamics to thermal equilibration in a thin-film FM on a substrate. Recent experiments suggest that applying a thermal gradient across the length of the system causes a spin current along the thickness; this spin current is present much farther from the heat sources than expected. We find that, although the interaction between the separate thermal equilibration processes increases the largest equilibration length, thermal equilibration does not predict a length as large as the experimentally measured length; it does predict, however, a thermal gradient along the thickness that has the shape of the measured spin current.

Magnetic oxides have become of interest source for spin transport devices due to their high spin polarization. But the real applications of these oxides remains unsatisfactory up to date, mostly due to the change of properties as a result of nano structuring. Magnetite (Fe3O4) is one such a material. High Curie temperature and the half metallicity of Fe3O4 make it a good potential candidate for spin transport devices. Studies have shown that the nano structuring Fe3O4 changes most of it's important properties. This includes high saturation magnetization and drop of conductivity by a few orders of magnitude in Fe3O4 thin films. In this study, we have successfully grown Fe3O4 by reactive sputtering and studied the effect of transition metal buffer layers on structural, transport, and magnetic properties of Fe3O4. It is shown that the lattice strain created by different buffer layers has major impacts on the properties of Fe3O4 thin films. Also for the first time the magnetic force microscopic measurements were carried out in Fe3O4 thin films through Verwey transition. MFM data with the magnetization data have confirmed that the magnetization of Fe3O4 thin films rotate slightly out of the plane below the Verwey transition. Fe3O4 thin films were also successfully used in fabricating spin valve structures with Chromium and Permalloy. Here, the Fe3O4 was used to generated the spin polarized electrons through reflection instead of direct spin injection. This is a novel method that can be used to inject spins into materials with different conductivities, where the traditional direct spin injection fails. Also the effect of growth field on Fe3O4 and Fe3O4/Cr/Py spin valves were investigated. In Fe3O4 the growth field induced an uni-axial anisotropy while it creates a well defined parallel and anti-parallel states in spin valves. Magneto thermal phenomenon including spin dependent Seebeck effect, Planar Nernst effect, and Anomalous Nernst effect were measured in ferromagnetic thin films and spin valves. Spin dependent Seebeck effect and planar Nernst effect were directly compared with the charge counterpart anisotropic magneto resistance. All the effects exhibited similar behavior indicating the same origin, namely spin dependent scattering.

No description available.

No description available.

Submitted by Daniella Sodre (daniella.sodre@ufpe.br) on 2015-04-08T12:40:55Z No. of bitstreams: 2 DISSERTAÇÃO Gabriel Fonseca.pdf: 3837074 bytes, checksum: e2c9b20882785e374170658d648ee389 (MD5) license_rdf: 1232 bytes, checksum: 66e71c371cc565284e70f40736c94386 (MD5) / Made available in DSpace on 2015-04-08T12:40:55Z (GMT). No. of bitstreams: 2 DISSERTAÇÃO Gabriel Fonseca.pdf: 3837074 bytes, checksum: e2c9b20882785e374170658d648ee389 (MD5) license_rdf: 1232 bytes, checksum: 66e71c371cc565284e70f40736c94386 (MD5) Previous issue date: 2014-03-10 / Conselho Nacional de Desenvolvimento Científi co e Tecnol ógico; Coordenação de Aperfeiçoamento de Pessoal de Ní vel Superior; Financiadora de Estudos e Projetos; Fundação de Amparo a Ciência e Tecnologia do Estado de Pernambuco. / In this master thesis we study experimentally the longitudinal spin Seebeck effect (LSSE) in bilayers made of a ferromagnetic insulator (FMI) and a metallic layer (M). We also present a theoretical model based on the spin current density ⃗ Js carried by a non-equilibrium magnon distribution, generated by a thermal gradient ∇T across the thickness of the FMI. When ⃗ Js reach the FMI/M interface it is pumped towards the M layer due to conservation of the angular momentum, so, the M layer is essential for the LSSE existence. Here the FMI consists of a Yttrium Iron Garnet (YIG) lm, grown over a Gadolinium Gallium Garnet (GGG) substrate. Different metallic materials were used as the M layer i.e. Pt and Ta that have normal behavior and Py that is a ferromagnetic metal (FMM). The experimental procedure consists of systematic measurements of the electric voltage VISHE, produced by ⃗ Js through the Inverse Spin Hall Effect (ISHE) in the normal metal or (FMM) layer. In YIG/Pt measurements were done in the temperature range from 20 to 300 K. The experimental data are tted to the proposed model for the LSSE and good agreement is obtained. The results shows that the Py and Ta can be used to detect the LSSE with the ISHE. The results of this master thesis have strong interest in the area of spin caloritronics helping to the development of the eld and to raise possibilities of new spintronic devices. ----- Nesta diserta ção e estudado experimentalmente o Efeito Seebeck de Spin Longi- tudinal (LSSE), em bicamadas formadas por um isolante ferromagn etico (FMI) e um lme metalico (M). Tamb em foi desenvolvido um modelo te orico baseado na den- sidade de corrente de spin ⃗ Js que existe quando uma distribui c~ao de m agnons fora do equil brio e gerada por um gradiente t ermico ∇T aplicado na sec ção transversal do FMI. Quando ⃗ Js chega na interface FMI/M e bombeada para a camada M satis- fazendo a conserva ção do momentum angular, assim que a camada NM e essencial para ter um LSSE. Como camada FMI foi utilizada a granada de trio e ferro (YIG) crescida num substrato de (GGG). Diferentes materiais metalicos foram utilizados como camada M, sendo Pt e Ta paramagn eticos e o Py ferromagnetico. O proced- imento experimental consiste na medi c~ao sistem atica da voltagem el etrica VISHE, que e produzida por ⃗ Js por meio do efeito Hall de spin inverso (ISHE) que ocorre na camada M. As medidas em YIG/Pt foram feitas numa faixa ampla de temperatura de 20 a 300 K. Os dados experimentais são fi tados com a teoria proposta para o LSSE encontrando-se boa concordância. Nossos resultados mostram que o Py e o Ta s~ao bons candidatos para detec ção do LSSE. Esta disserta ção e de grande interesse na area da caloritrônica de spin, ajudando no desenvolvimento deste campo e na concep ção de novos dispositivos tecnol ogicos baseados na spintrônica.

No description available.