Este trabalho aborda o estudo de pilares preenchidos flexo-comprimidos e algumas ligações viga-pilar preenchido. Para ambos, são realizadas experimentações com modelos físicos e numéricos, sendo que para os pilares preenchidos um amplo estudo paramétrico foi desenvolvido. Ao todo, foram ensaiados 13 pilares preenchidos flexo-comprimidos, cujos valores de força última são comparados com aqueles provenientes da simulação numérica via programa CFT e, os demais resultados, comentados e discutidos. Aferido, o programa CFT foi utilizado no estudo paramétrico com o intuito de avaliar a influência de parâmetros como resistência dos materiais, excentricidade da força axial, eixo de flexão e relação lado/espessura na capacidade resistente do pilar preenchido. Quanto às ligações viga-pilar, foram ensaiadas 4 tipologias de ligação, sendo duas compostas por chapas de extremidade e parafusos passantes e duas soldadas, sendo uma delas enrijecida por cantoneiras soldadas no interior do perfil tubular. Discutem-se os resultados, sobretudo quanto ao comportamento momento-rotação das tipologias investigadas. As ligações também foram investigadas via simulação numérica e os resultados obtidos permitiram elaborar diretrizes para o aprimoramento de tais simulações. Por fim, são apresentadas as conclusões pertinentes a este trabalho e recomendações para novas pesquisas / This research thesis presents a study of concrete filled steel columns subjected to combined bending and compression and beam-column connections. In both cases, tests were conducted on physical and numerical models, resulting in the development of a wide range of parametric studies for the case of the concrete filled steel columns. 13 concrete filled steel columns were tested under combined bending and compression loads whose ultimate values were compared to ultimate forces obtained from numerical simulations using the CFT computer program. After calibration, the computer program was used in the parametric study with the aim of verifying the influence of parameters, such as the material strength, eccentricity of the axial force, bending axis and breadth/thickness relation, on the ultimate load carrying capacity of the concrete filled steel columns. With respect to the beam-column connections, four types of connections were tested, two of them composed of endplate and bolts, while the other two were welded, with one of them stiffened by an angle steel placed inside the steel tube. The obtained results are discussed, giving more emphasis to the bending moment-rotation behaviour of the tested specimens. The beam-column connections were also investigated numerically. The obtained results permit the laying out of important directives for the improvement of such numerical simulation tools as the one employed in the present thesis. Lastly, pertinent conclusions relative to this thesis and recommendations for future research are presented

Direct current motors and stepping motors are very often used for electric drives in cars. The most frequent representatives of direct current motors are electric starter and wind- screen wiper motor. Stepping motors are very often used for electric regulating of outsides driving mirrors and seats. This study is focused on innovation and DC permanent magnet motor. The disadvanage of direct current motors is so called „sliding contact“. A possible compensation of direct current motor are EC (electronically commutator) motors that do not need sliding contact for their work.

In this thesis analysis and inovation of electric machines for cars is discused. There are described principles of basics DC and AC electric machines. In detail this thesis deals with small electric machines used in cars. At least, electro motor for wiper is investigated and possibilities of its inovation in different ways are also mantioned.