Thesis (Ph. D.)--University of Leiden, 1979. / Includes bibliographical references.

The investigations in this dissertation have been 'conducted to investigate the formulation and analysis of a paediatric amoxycillin suppository. The oral administration of antibiotics to young children can at times be roblematic. Compliance is sometimes poor because of a sore throat, nausea, vomiting, a high fever or a dislike for the taste or smell of the medicine:- In-such cases the rectal administration of an antibiotic could provide an alternative route of administration that avoids some of the problems that affect oral administration. Difficulties associated with rectal administration are bioavailability, local irritation, acceptability to patients and rejection of the dosage form. Few data, however, are available on the usefulness in children of suppositories in general, and antibiotic suppositories in particular. The areas of investigation have included the formulation of an amoxycillin suppository in various fatty bases, the quantitation of amoxycillin in both aqueous solution and human serum, assessment of stability of amoxycillin in stored aqueous and biological samples, in vitro drug release testing of suppositories, and bioavailability and pharmacokinetics following administration to human subjects of capsule, suppository, oral suspension and rectal suspension dosage forms. Suppositories containing 250 mg amoxycillin were prepared in theobroma oil and in the semisynthetic bases Witepso[ W35, Suppocire A32, Novata BD and Novata 299. The in vitro release characteristics of amoxycillin from these lipophilic suppository formulations were investigated using the USP rotating basket method. The dissolution of a drug from a solid dosage unit is an important parameter affecting drug bioavialability. High Performance Liquid Chromatography (HPLC) was used as the main analytical technique. An original HPLC method for analysis of amoxycillin in aqueous solution, using ultraviolet detection at 230 nm was develcfped. The validated method was a~plied to the determination of the stability of aqueous amoxycillin solutions, and was utilized to determine the amount of drug released during dissolution testing. Differential scanning calorimetry (DSC) is a technique commonly used in preformulation studies. Dissolution testing was used in conjunction with DSC to select a suppository base suitable for formulation with amoxycillin trihydrate. An HPLC method for analysis of amoxycillin in human serum using UV detection at 230 nm is presented. The method involves a solid phase extraction procedure followed by chromatography on a reversed phase column. The limit of sensitivity of 0.3 ILg/mL in serum is sufficiently sensitive to monitor serum concentrations of amoxycillin in humans after the administration of a single 250 mg oral dose. Pharmacokinetic parameters were calculated from data obtained following the administration of a capsule and oral suspension. These parameters were consistent with previously published results. Following administration of a lipophilic suppository and a rectal suspension, to human volunteers, it was concluded that amoxycillin trihydrate is not readily absorbed from the rectum. Further investigations into the modification of the suppository dosage form with absorption enhancers to improve rectal absorption of amoxycillin, as well as elucidation of the mechanism of absorption of the drug, could assist in improving this formulation so that it is suitable for paediatric use.

Thesis (M.Sc. (Pharmacy)) - Rhodes University, 2006.

The use of the oral route of administration for the treatment of young children with antibiotics can at times be problematic since, factors such as nausea, vomiting, taste and/or smell, in addition to the challenges associated with the administration of suspensions, may contribute to poor patient compliance. In such cases, the use of the rectal route of administration may be appropriate. Therefore, suppositories containing 250 mg azithromycin (AZI) were manufactured and assessed for potential as an antibiotic suppository dosage form. Suppositories, containing AZI dihydrate were manufactured by the fusion method, using different grades of PEG, Witepsol® and Suppocire® bases. The rate and extent of AZI release was evaluated using USP apparatus I, and samples were analyzed using a validated HPLC method. Differences in the rate and extent of AZI release were observed with the greatest amount of AZI being released from PEG formulations. The rate and extent of AZI release from formulations manufactured using fatty bases were influenced by physicochemical properties, such as melting rate and hydroxyl value, of the bases. In addition drug partitioning appeared to favor the lipid phase and had a negative impact on AZI release characteristics. Two different formulation approaches were used in an attempt to increase the rate and extent of AZI release from fatty base formulations. The use of surfactants significantly increased AZI release from formulations manufactured with fatty bases with high hydroxyl values. The use of urea or Povidone K25 in combination with AZI as a physical mixture or solid dispersion did not increase the rate and extent of AZI release from the fatty suppositories, to any significant extent. The mechanism of drug release was evaluated using several mathematical models, including the Higuchi, Korsmeyer- eppas, Zero and, First order models. In addition, in vitro dissolution profiles were characterized by the difference and similarity factors, f1 and f2 and by use of the Gohel similarity factor, Sd. AZI release kinetics were best described by the Higuchi and Korsmeyer-Peppas models and the values of the release exponent, n, revealed that drug release was a consequence of the combined effects of AZI diffusion, rate of melting of the base and partitioning of the drug which can be considered to be anomalous release.