<p> UV radiation disinfection technology is an advantageous method of wastewater disinfection as it avoids the formation of chemical by-products typically found from chlorination. One challenge with this technology is avoiding fouling on the quartz sleeves in which the UV lamps are housed. In this study, using a model fouling system, the roles in fouling of light, and the constitution of the fouling media, are examined. The systematic determination of fouling by various mixtures of human serum albumin, humic acid, Ca^2+, and Fe^3+ was carried out on quartz slides in the presence and absence of UV (254nm) light. Fouling was assessed by the reduction in transmission of UV light through the quartz slides over time. It was determined that the most important factors were the concentration of..iron and protein, which apparently act synergistically to foul the surface. Other contributing factors to the magnitude of fouling include the flow rate and the age of the fouling solution. Most important was the presence of UV light. In all solutions examined, fouling was observed to a lower degree when the system was exposed to light. On the other hand, XPS analysis has demonstrated differences in the nature of the fouling layer on the surface exposed to UV light compared to that in the dark. </p> <p> It is generally accepted that low energy surfaces are less easily fouled than polar surfaces. Therefore, hydrophobic modification of the quartz by a series of different silane coupling agents was undertaken. Irrespective of the nature of the coating (alkylamine, alkyl, aryl, fluorocarbon, silicone), the rate and magnitude of fouling on the surface were comparable to the unmodified quartz. However, the more hydrophobic surfaces were easier to clean. </p> / Thesis / Master of Science (MSc)