Spelling suggestions: "subject:"tailings bonds""
1 |
Degradation of Naphthenic Acids in Athabasca Oil Sands Process-Affected Water Using OzoneHongjing , Fu Unknown Date
No description available.
|
2 |
Degradation of Naphthenic Acids in Athabasca Oil Sands Process-Affected Water Using OzoneHongjing , Fu 06 1900 (has links)
In order to determine the degradation of Naphthenic Acids (NAs) in oil sands process-affected water (OSPW), a series of semi-batch ozonation experiments have been conducted resulting in a maximum reduction of NAs greater than 99%. Compared to the high NAs removal, the reduction of both COD and DOC was much lower under the same conditions. Following ozone treatments of approx. 80 mg/L, the cBOD5 and cBOD5/COD tripled as compared to original OSPW measurements, suggesting ozone-treated OSPW has a higher biodegradability. The ozone treatments also detoxified the OSPW; with an ozone treatment of approx. 100 mg/L, the treated OSPW showed no toxicity using the Mircotox® bioassay. Additionally, the coke-treated OSPW, treated using a coke/water slurry process, was found to be non-toxic with an ozone treatment of approx. 20 mg/L. The results obtained during this study shows the great potential ozonation may offer as a possible water treatment application for oil sands water management. / Environmental Engineering
|
3 |
Adsorption of Single-ring Model Naphthenic Acid from Oil Sands Tailings Pond Water Using Petroleum Coke-derived Activated CarbonSarkar, Bithun 17 July 2013 (has links)
Petroleum coke-derived activated carbons were prepared and used for the adsorptive removal of a single-ring naphthenic acid (NA) from synthetic oil sands tailings pond water (TPW). The overall adsorption process was found to be intra-particle diffusion-controlled. The Weber-Morris intra-particle diffusion rate constants decreased from 7.43 to 1.23 mg/g min0.5 after activated carbon was post-oxidized with oxygen, suggesting a hindering effect of oxygen surface groups. The Freundlich model fit of the equilibrium adsorption isotherms and the small negative ΔHo pointed to a physisorption-dominated process and the importance of specific surface area. It was estimated that about 2.7 g/L of basic CO2-activated carbon is needed to reduce NA concentration from 120 mg/L to 2.5 mg/L (~98% removal) in synthetic TPW. However, equilibrium adsorption capacity was found to vary significantly after oxygen or nitrogen groups were introduced onto the surface. Therefore, there is a potential for enhanced adsorption by chemical functionalization of carbon.
|
4 |
Adsorption of Single-ring Model Naphthenic Acid from Oil Sands Tailings Pond Water Using Petroleum Coke-derived Activated CarbonSarkar, Bithun 17 July 2013 (has links)
Petroleum coke-derived activated carbons were prepared and used for the adsorptive removal of a single-ring naphthenic acid (NA) from synthetic oil sands tailings pond water (TPW). The overall adsorption process was found to be intra-particle diffusion-controlled. The Weber-Morris intra-particle diffusion rate constants decreased from 7.43 to 1.23 mg/g min0.5 after activated carbon was post-oxidized with oxygen, suggesting a hindering effect of oxygen surface groups. The Freundlich model fit of the equilibrium adsorption isotherms and the small negative ΔHo pointed to a physisorption-dominated process and the importance of specific surface area. It was estimated that about 2.7 g/L of basic CO2-activated carbon is needed to reduce NA concentration from 120 mg/L to 2.5 mg/L (~98% removal) in synthetic TPW. However, equilibrium adsorption capacity was found to vary significantly after oxygen or nitrogen groups were introduced onto the surface. Therefore, there is a potential for enhanced adsorption by chemical functionalization of carbon.
|
Page generated in 0.0927 seconds