Student Number : 0400486V - MSc (Eng) dissertation - School of Electrical and Information Engineering - Faculty of Engineering and the Built Environment / The Voltage Dip Test Facility at the University of the Witwatersrand utilises a resistive load during testing of variable speed drives. This method produces valuable results regarding the performance of drives under dip conditions. It has been shown that load type does influence the performance of drives and this variation cannot be tested under current conditions as only linear loading is attainable with resistive loads. This thesis proposes a programmable load based on the concept of field-oriented control of an induction motor. The concepts involved with field-oriented control are discussed and shown to be suitable for this application. An implementation strategy utilising custom-designed software and an off-the-shelf VSD is developed and executed. The performance of the programmable load is analysed under both steady-state and dynamic conditions.

The doctoral thesis is divided into three main parts with a focus on induction motors. The first part deals with the electromagnetic design and analysis of windings of AC ma-chines. There is introduced the density of conductors, which describes the distribution of the windings in the slots. There is derived general formula for calculation of the total winding factor applicable to any type of winding. The second part of this work deals with the acceleration method of the induction motors torque-speed characteristics measurement. The measured characteristics are used for exact identification of the equivalent circuit parameters of induction motor. The third section is focused on a very precise identification of the equivalent circuit parameters of induction motor in the form of -circuit. The identification is based on mutual comparison of measured and calculated torque-speed and current-speed characteristics.