Surface-crack configurations are among the most important crack problems in the aerospace industry. The residual strength of a surface-cracked component is complicated by three-dimensional variation of the stress-intensity factor around the crack front and plastic deformations, which vary from plane stress at the free boundary, to nearly plane-strain behavior in the interior. In 1973, a two-parameter fracture criterion (TPFC) was developed to analyze fracture behavior of surface-crack configurations. Estimates were made around the crack front for fracture initiation—the critical parametric angle. Recently, NASA developed the Tool for Analysis of Surface Cracks (TASC) software that predicts critical location. This thesis is the application of the TPFC with the TASC critical angles using an equation developed from the TASC software. The TPFC was applied to three materials: a brittle titanium alloy, a ductile titanium alloy, and a ductile 301 stainless steel. The TPFC with the TASC critical angles correlated fracture behaviors well.

A two-parameter fracture criterion (TPFC) is used to correlate and predict failure loads on cracked configurations made of ductile materials. The current study was conducted to validate the use of the fracture criterion on more brittle materials, using elastic-plastic finite-element analyses with the critical crack-tip-opening angle (CTOA) failure criterion. Forman generated fracture data on middle-crack tension, M(T), specimens made of thin-sheet 7075-T6 aluminum alloy, which is a quasi-brittle material. The fracture data included a wide range of specimen widths (2w) ranging from 3 to 24 inches. A two-dimensional (2D) finite-element analysis code (ZIP2D) with a ''plane-strain core" option was used to model the fracture process. Fracture simulations were conducted on M(T), single-edge-crack tension, SE(T), and single-edge-crack bend, SE(B), specimens. The results supported the TPFC equation for net-section stresses less than the material proportional limit. However, some discrepancies were observed among the numerical results of the three specimen types. Thus, more research is needed to improve the transferability of the TPFC from the M(T) specimen to both the SE(T) and SE(B) specimens.