This thesis focuses on development of novel nanomaterials, including semiconductor quantum dots (QDs) and gold nanoparticles (AuNPs), for fabricating white-light emitting devices and assaying thiols in biological and environmental samples. The thesis mainly contains two divisions. One demonstrates synthesis, optical properties and white-light emissions of alloyed quantum dots and their application to light-emitting devices. The other describes to combine functionalized gold nanoparticles with capillary electrophoresis and accomplish high selectivity and ultrasensitive detection for thiols. First, through one-step aqueous synthesis, alloyed ZnxCd1¡VxSe QDs have been successfully prepared at low temperatures by reacting a mixture of Cd(ClO4)2 and Zn(ClO4)2 with NaHSe using 3-mercaptopropionic acid as a surface-stabilizing agent. The optical properties and composition of the alloyed QDs were highly dependent on the molar ratio of Zn2+ to Cd2+. With the increase in Zn content, a systematic blue shift occurred in the first exciton absorption and band edge emission. Moreover, X-ray diffraction peaks of the alloyed QDs systematically shifted to larger angles simultaneously. These systematic shifts indicated the formation of the alloyed QDs. Interestingly, among these alloyed QDs, Zn0.93Cd0.07Se QDs exhibited white-light emission with quantum yields of 12%. In addition, we discovered that we could adjust the relative strength of the band edge and trap state emissions by controlling the reaction time, thereby attain white-light-emitting QDs. Finally, we blended alloyed QDs with ultraviolet-transparent polydimethylsiloxane (PDMS) to develop a white-light, solid-state lighting device by using a 365-nm UV lamp as the pump source. In the other part of this thesis, we proposed a method for selective enrichment of thiols using Tween 20-capped gold nanoparticles (AuNPs) prior to capillary electrophoresis coupled with laser-induced fluorescence (CE-LIF). By forming Au-S bonds, Tween 20-AuNPs can selectively extract thiols from a complicated matrix. A Tween 20 capping layer not only suppresses nonspecific adsorption, but also enables NPs to disperse in a highly-salinity solution. For analyses of aminothiols, after extraction and centrifugation, thioglycollic acid was utilized to remove aminothiols that attached to the NP surfaces. The extracted aminothiols was derivatized with o-phthalaldehyde (OPA) followed by CE-LIF. The use of this nanoprobe provided approximately 11-, 282-, and 21-fold sensitivity improvements for homocysteine (HCys), glutathione (GSH), and £^-glutamylcysteine (GluCys), respectively. Furthermore, the limits of detection (LODs) at a signal-to-noise ratio of 3 for HCys, GSH, and GluCys are 4013, 80, and 383 pM, respectively. A practical analysis of aminothiols in human urine sample has been accomplished by our proposed method. For another application to determining thiol-containing peptides, we use dithiothreitol to remove thiol-containing peptides from the NP surface through ligand exchange. The released peptides are selectively derivatized with OPA to form tricyclic isoindole derivatives. After injecting a large sample volume, the sensitivity of these peptides was improved by stacking them via using polyethylene oxide (PEO) as additive for on-line concentration and separation. As a result, LODs for GSH, GluCys, and phytochelatins (PC2 ~ PC4) were down to 0.1-6 pM. The proposed method has the lowest LODs for five peptides compared to other reported methods, and it also detect dissolve thiols in seawater in practice. Our proposed method is capable of ultrasensitive detection for thiols in biological and environmental samples.