This thesis is a study of the kiln drying of radiata pine with a primary focus on the change in wood colour that occurs during this process. The energy efficiency of the drying process has also been examined using computer modelling. The aim of this work was to develop guidelines for commercial wood dryers who wish to produce high quality appearance grade timber in a competitive commercial environment. The colour change in radiata pine wood during kiln drying is mainly caused by sap compounds accumulating at the wood surface and reacting to form coloured compounds. The initial research involved drying experiments designed to determine the relationship between this colour change and the kiln schedule and also measure the accumulation of colour forming compounds. The kinetics of the colour change reaction were also measured using two methods, one in-vitro and the other using small samples of wood. From these experiments a colour change equation was developed that predicts the rate of colour formation based on the drying conditions and this was incorporated into a kiln stack model along with an energy efficiency model. The combined model was used to simulate the drying process to find schedules optimised for energy use and wood quality. The model was also used to simulate the energy efficiency of different humidity control configurations for wood drying kilns. A kiln micro-sensor system was also developed for use in kiln diagnostics and control with the particular aim of identifying areas in wood drying kilns with adverse drying conditions. The recommendation to kiln operators wishing to reduce colour change is to not exceed 70? and to use lower relative humidity schedules with a wet bulb depression of 15-20?. Operating at lower humidity can increase the energy used by the kiln so it is also recommended that kiln designers incorporate heat recovery into the humidity control mechanisms of the kiln.

Colour and appearance of hardwood are of great importance for the interiorand furniture industry. The widespread use of transparent surface treatmentand a fashion that prescribe light colour on many species, means that deviationfrom the ideal have considerable impact on the industrial operations. Kilndrying is generally regarded as the process that has the greatest impact on thecolour of Nordic hardwood species. The lack of satisfactory explanation modelsfor many types of discoloration, however, complicates the control of the dryingprocess.This thesis is an attempt to increase the knowledge of which factors thatcontrol the appearance of some commonly found discolorations associated withdrying of beech, birch and oak. The main focus is on convection drying but alsothe influence of timber storage, pre-steaming and press drying has beeninvestigated for individual species. The studies have been conducted ascomparative studies based on design of experiments in which the colour wasdetermined using a colorimeter.Results show that reddish and dark discoloration of beech and birch duringconvective drying is mainly dependent on the temperature and time of exposurewhen the local moisture content exceeds the fibre saturation point. Theconversion of naturally occurring substances in birch into coloured compoundsis not due to active precursors created at high moisture content levels duringthe subsequent drying at low moisture content levels. Interior grey stain inbeech is caused by slow initial drying at low temperatures. Log storage in coldwinter and spring climate does not cause discoloration in beech. Birch becomeslighter when press-dried at high temperatures, resulting in a colour comparableto that of traditionally kiln dried wood. Steaming of oak before kiln dryingreduce the presence of brown discoloration, a general darkening of the woodoccurs at temperatures above 50°C.