The problem was to design and construct the necessary equipment to cut and fasten short stock end to end using finger-joints. The study was divided into five chapters: I contained the introduction to the problem; II was concerned with the design and construction of the equipment; III detailed the operation of the equipment; IV contained the presentation of the data; and V covered the summary and findings. The study concluded that the equipment could be constructed inexpensively, and would perform a useful service. Also, a student using waste wood salvaged through use of this equipment could expect a smaller bill for materials than if he purchased new wood.

The thesis deals with possibilities of using of mobile band saws. An economic analysis of band saw utilization for woodworking was carried out. Further the work evaluates and analyses the technological string of lumber production in a selected area. In the first part there is a study of current state of technological string of saw timber production. The second chapter deals with the evaluation of state in consideration of woodworking in relation to selected location of production facilities. The third part is focused on evaluation of possibilities of mobile band saw utilization that is carried out on Husqvarna SMB - 70. The fourth section describes technological variations and tries to determine criteria for choosing of the best variant. It details opportunities of a small - grower that tries to find the most suitable variant by selling a wood, so as it brings the maximum profit. The work deals with various possibilities of timber production in which the band saw is included. Technical parameters of particular saws are described here. And by means of economic parameters the most suitable technology for sawn wood production is determined. The goal of this thesis is to choose a suitable technology for timber production based on economic analysis and with regard to conditions of the processing plant.