This thesis report describes the modeling procedure for available the wind turbine generator (WTG) technologies. The models are generic in nature and manufacturer independent. These models are implemented on commercially available dynamic simulation software platforms like PSCAD/EMTDC and MATLAB/SIMULINK. A brief introduction to the available WTG types is provided to understand the technological differences and their key features. The related theoretical concepts to the working of a WTG are explained, which acts as an aid for model development and implementation. Using the theoretical concepts as basis, a WTG model is divided into four parts :
1. Aerodynamic model
2. Mechanical drive train model
3. Electrical machine model
4. Controller model
Once the different parts of a WTG are introduced, a groundwork for model implementation on the software platforms is laid. A step-by-step process of implementing a PSCAD or MATLAB model of a WTG is introduced in this thesis. Starting with the most fundamental WTG technology such as fixed-speed also known as direct-connect wind turbine. The model implementation is adanvced to other superior technology like the dynamic rotor resistance control (DRR) and the doubly-fed induction generator (DFIG). To better understand the working of a DFIG, a current-source regulated model (without electrical machine) emulating the DFIG is built on both PSCAD and MATLAB. A full blown converter model of the DFIG with back-to-back converter is then built in PSCAD/EMTDC.
An approach to determine the reactive power capability (Q limits) of a DFIG is described. Rotor current limitation and stator current limitation of the DFIG are considered in determining the minimum and maximum reactive power delievered by the DFIG. Variation in the Q limits of a DFIG for change in wind speed is analysed with two different wind speed scenarios.
1. Wind speed from cut-in to rated i.e. 6 m/s - 14 m/s.
2. Wind speed above rated to cut-out i.e. 14 m/s - 20 m/s.
Such an analysis, is useful in determining the operating mode of the DFIG. At low wind speeds (below rated), the DFIG can be operated as a STATCOM for exporting and importing reactive power (similar to synchronous machines). While above rated wind speeds, the DFIG can be set to produce maximum active power. Using the DFIG current-source model implemented in MATLAB/SIMULINK, laboratory experiments to plot the power profile of the DFIG is explained. Another experiment to perform independent P-Q control of the DFIG is also included in this report. / text
| Identifer | oai:union.ndltd.org:UTEXAS/oai:repositories.lib.utexas.edu:2152/ETD-UT-2010-05-1003 |
| Date | 25 October 2010 |
| Creators | Vyas, Mithunprakash G |
| Source Sets | University of Texas |
| Language | English |
| Detected Language | English |
| Type | thesis |
| Format | application/pdf |
Page generated in 0.0017 seconds