Return to search

HNO3-Induced Atmospheric Corrosion of Copper, Zinc and Carbon Steel

The role of nitric acid (HNO3) on the atmospheric corrosion of metals has so far received little or no attention. However, the last decades of decreasing sulphur dioxide (SO2) levels and unchanged HNO3 levels in many industrialized countries have resulted in an increased interest in possible HNO3-induced atmospheric corrosion effects. In this study a new method was developed for studying the corrosion effects of HNO3 on metals at well-defined laboratory exposure conditions. The method has enabled studies to be performed on the influence of individual exposure parameters, namely HNO3-concentration, air velocity, temperature and relative humidity, as well as comparisons with newly generated field exposure data. The corrosion rate and deposition rate of HNO3 on copper was shown to follow a linear increase with HNO3 concentration. The deposition velocity (Vd) of HNO3 increased up to an air velocity of 11.8 cm s-1. Only at a higher air velocity (35.4 cm s-1) the Vd on copper was lower than the Vd on an ideal absorbent, implying the Vd of HNO3 at lower air velocities to be mass-transport limited. Within the investigated temperature range of 15 to 35 ÂșC only a minor decrease in the HNO3-induced copper corrosion rate could be observed. The effect of relative humidity (RH) was more evident. Already at 20 % RH a significant corrosion rate could be measured and at 65 % RH the Vd of HNO3 on copper, zinc and carbon steel reached maximum and nearly ideal absorption conditions. During identical exposure conditions in HNO3-containing atmosphere, the corrosion rate of carbon steel was nearly three times higher than that of copper and zinc. The HNO3-induced corrosion effect of copper, zinc and steel turned out to be significantly higher than that induced by SO2 alone or in combination with either NO2 or O3. This is mainly attributed to the much higher water solubility and reactivity of HNO3 compared to SO2, NO2 and O3. Relative to SO2, zinc exhibits the highest sensitivity to HNO3, followed by copper, and carbon steel with the lowest sensitivity. Extrapolation of laboratory data to an assumed average outdoor wind velocity of 3.6 m s-1 enabled a good comparison with field data. Despite the fact that ambient SO2 levels are still much higher than HNO3 levels, the results show that HNO3 plays a significant role for the atmospheric corrosion of copper and zinc, but not for carbon steel. The results generated within this doctoral study emphasize the importance of further research on the influence of HNO3 on degradation of other materials, e.g. stone and glass, as well as of other metals.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:kth-4194
Date January 2006
CreatorsSamie, Farid
PublisherKTH, Kemi, Stockholm : Kemi
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeDoctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess

Page generated in 0.0021 seconds