Conversion of biomass to energy does not contribute to the net increase of carbon dioxide in the environment, therefore the use of biomass waste as a clean and renewable fuel source is an attractive alternative to the use of fossil fuels. Biomass can be converted to energy via direct combustion or via thermo-chemical conversion to liquid or gas fuels. This study focuses on employing gasification technology to convert biomass waste to producer gas, which is then cleaned and fed as gaseous fuel into the gas turbine. Since the producer gases are usually low caloric values, the power plants performance under various operating conditions has not yet been proven. In this study, system performance calculations are conducted for a 5MWe and a 20MWe power plants using commercial software ThermoFlow. The power plants considered including simple gas turbine systems, steam turbine systems, combined cycle systems, and steam injection gas turbine systems (STIG) using the producer gas with low caloric values at approximately 30% and 15% of the natural gas heating value. The low caloric value fuels are shown to impose high back compressor pressure and increased power output due to increased fuel flow. Power augmentations under four different weather conditions are also calculated by employing gas turbine inlet fog cooling. Different capacity options for the heat recovery steam generator (HRSG) that provides the steam for STIG are analyzed.
Identifer | oai:union.ndltd.org:uno.edu/oai:scholarworks.uno.edu:td-1210 |
Date | 17 December 2004 |
Creators | Yap, Mun Roy |
Publisher | ScholarWorks@UNO |
Source Sets | University of New Orleans |
Detected Language | English |
Type | text |
Format | application/pdf |
Source | University of New Orleans Theses and Dissertations |
Page generated in 0.0017 seconds