Introduction
All experimental studies involving charged particle induced nuclear reactions require a precise knowledge of monitor reactions. A number of well described proton induced monitor reactions exist in the lower energy range [1], which is covered by most medical cyclotrons. Concerning proton energies above 20 MeV, however, the accuracy of the monitor reactions declines as cross section data becomes scarcer. Furthermore, the growing interest in precise determination of projectile energies by comparing of ratios of monitor reaction cross sections demands new measurements and evaluations of known data for high threshold monitor radionuclides.
In this work cross section measurements on the formation of 61Cu were done and energy de-pendent radionuclide ratios were calculated.
Material and Methods
For investigation of the natCu(p,x)61Cu reaction copper foils of natural isotopic composition (Goodfellow Ltd.) were irradiated. The targets were of 10 and 20 μm thickness, having a diameter of 15 mm.
Proton bombardments up to 45 MeV incident energy were done in the stacked-foil arrangement at the accelerator JULIC of the Nuclear Physics Institute (IKP) of the Forschungszentrum Jülich. In addition to an internal irradiation possibility the cyclotron is equipped with an external target station which was used for most experiments. It can adapt standard and slanting solid target holders and is equipped with a water cooled four sector collimator and additional helium cooling of the entry foil.
Several irradiations were executed. In each stack, besides copper samples, aluminium absorbers and additional nickel monitor foils were also placed, the latter for the determination of the respective beam current.
The produced radioactivity of 61Cu was analysed non-destructively using HPGe γ-ray detectors (EG&G Ortec).
Results and Conclusion
Reaction cross sections of the natCu(p,x)61Cu process up to 45 MeV were measured and com-pared with existing data from the literature (FIG. 2). Except for the data of Williams et al. our results are in good agreement, showing a maxi-mum of about 165 mbarn at 37.5 MeV proton energy. The overall uncertainty of the new cross section data is between 8 and 10 %.
In FIG. 3, the excitation functions of the relevant monitor reactions on Cu are shown.
In combination with the excitation function of the natCu(p,xn)62Zn reaction, isotope ratios were calculated which can be used for determination of the proton energy within a target stack in the energy range of 22–40 MeV as described by Piel et al. [3]. FIGURE 4 shows the cross section ratio in dependence of the proton energy.
Above this energy, 65Zn could be used to generate isotope ratios for energy determination, although the long half-life (T½ = 244.3 d) of that radionuclide may be a problem.
Additional cross section measurements are planned in order to further strengthen the data base of this potential monitor reaction. The results of this work shall be evaluated in the framework of an ongoing Coordinated Research Project of the IAEA.
Identifer | oai:union.ndltd.org:DRESDEN/oai:qucosa.de:bsz:d120-qucosa-166097 |
Date | 19 May 2015 |
Creators | Kuhn, S., Buchholz, M., Wels, T., Breunig, K., Scholten, B., Spahn, I., Coenen, H. H. |
Contributors | Institute of Neuroscience and Medicine, INM-5: Nuclear Chemistry, Forschungszentrum Jülich, Germany,, Helmholtz-Zentrum Dresden - Rossendorf, |
Publisher | Helmholtz-Zentrum Dresden - Rossendorf |
Source Sets | Hochschulschriftenserver (HSSS) der SLUB Dresden |
Language | English |
Detected Language | English |
Type | doc-type:conferenceObject |
Format | application/pdf |
Source | WTTC15 |
Page generated in 0.0017 seconds