An exhaust manifold of a truck engine is subjected to tough conditions. As the truck is started, operated and shut down, it becomes subjected to thermal cycling up to around 800°C. At such high temperatures, corrosion, fatigue and creep are active degradation mechanisms. As can be imagined, the interplay between the three complicates materials selection. It is desired to have a versatile grade of high durability which is not too expensive. At the moment, a ferritic, ductile cast iron designated SiMo51 is used for the application. However, due to the rough conditions, it is considered to be on the verge of its operational limit. As a consequence, there is an ongoing search for candidate materials. In this study, the ductile cast irons SiMo51, SiMo1000, D5S and the cast steel HK30 have been included. In the past, there have been several studies describing corrosion and fatigue of the cast materials used for exhaust manifolds. However, on the subject of creep of cast materials, little is known. The present study aims to reveal creep tendencies of cast materials and to do it in several ways. More precisely, three creep-testing methods were employed: the conventional constant-load creep-test, the “Sequential tensile test (STT)” and “Stress relaxations with thermal cycling (SRTC)”. The first one is the traditional one. It is tedious, usually lasting months or years. The second one is a tensile test in which the strain rate is changed in sequences as specimen deformation proceeds. Here, the idea is that a slow tensile test is not different from a conventional creep test. In the third one, stress relaxations are provoked as a specimen is thermally cycled in a locked state. Since stress relaxations are a consequence of creep deformation, the relaxation data gathered from isothermal holds can be directly compared to results from the isothermal constant-load creep-test and STT. When thermally cycled in a locked state, the materials display a loop character in σ, ε and T which provides extensive information about the mechanical properties over the selected temperature interval. In a logarithmic Norton plot, the creep strain rate is plotted as a function of stress. By plotting STT-data in such Norton plots, it was shown that the creep behaviour of the included materials is well represented by Norton’s law. Furthermore, it was found that the creep strain rates and stress relaxations, measured during isothermal holds in SRTC, in several cases show perfect coincidence with tensile test data obtained through STT. At 700°C, data from all three tests were inserted in the same Norton plot. At higher stress levels, the SRTC-curve follows the STT-curve and at lower stresses, when the creep regime is entered, it bends down and unites with data obtained by the constant-load creep tests. Additionally, it was seen that a relatively high degree of pre-deformation can give a critical stress below which creep deformation stops completely. / <p>The Financier is Scania CV. </p>
Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:kth-228022 |
Date | January 2018 |
Creators | Öberg, Christian |
Publisher | KTH, Materialvetenskap, 8912104273, STOCKHOLM |
Source Sets | DiVA Archive at Upsalla University |
Language | English |
Detected Language | English |
Type | Licentiate thesis, comprehensive summary, info:eu-repo/semantics/masterThesis, text |
Format | application/pdf |
Rights | info:eu-repo/semantics/openAccess |
Relation | TRITA-ITM-AVL ; 2018:22 |
Page generated in 0.0023 seconds