90nm wafer process has been released in production, but the bump pitch released in production is 180um. The major problem is the yield of solder paste printing process below 180um will be less than 80%. It means the cost will be very high. Thus it is difficult to make 150um bump pitch by using printing process in production.
Substrate C4 pad will be bumped by pre-solder, and it will be jointed with wafer bump after re-flow process. The printing process is the most popular process in C4 pad pre-solder due to low cost and high throughput. But the challenge of 150um and even more of the wafer bump pitch shrinkage are the inevitable trend. So, a lot of substrate manufacturers are trying to develop the new process for C4 pro-solder pitch less than 100um.
As soon as the C4 pad pre-solder pitch has been shrunk, the solder volume will be shrunk as well. It means the bump structure will be getting weak, and it may not pass the reliability tests. Thus, to evaluate the workability of bump structure is our purpose.
First, the simulation software is used to compare the fatigue lives of two structures by using solder bump and copper bump substrates during thermal cycling test, and then to proceed the whole FCBGA process and reliability tests.
The result of evaluation confirm the workability of FCBGA product using copper bump substrate, and it can be used with the same parameter and machine in solder bump substrate.
Keyword¡GFCBGA, Substrate, Bump, Cold Joint, Delamination
Identifer | oai:union.ndltd.org:NSYSU/oai:NSYSU:etd-0206107-220927 |
Date | 06 February 2007 |
Creators | Chen, Chien-wen |
Contributors | none, none, none |
Publisher | NSYSU |
Source Sets | NSYSU Electronic Thesis and Dissertation Archive |
Language | Cholon |
Detected Language | English |
Type | text |
Format | application/pdf |
Source | http://etd.lib.nsysu.edu.tw/ETD-db/ETD-search/view_etd?URN=etd-0206107-220927 |
Rights | off_campus_withheld, Copyright information available at source archive |
Page generated in 0.0015 seconds