<p>This report documents the work done by the author to design and implement a 3D graphics system on an FPGA (Field Programmable Gate Array). After a preamble with a background presentation to the project, a very brief introduction in computer graphics techniques and computer graphics theory is given. Then, the hardware available to the project, along with an analysis of general requirements is examined. The following chapter contains the proposed graphics system design for FPGA implementation. A broad approach to separate the design and the eventual implementation was used. Two 3D pipelines are suggested - one fully capable high-end version and one which use minimal resources. The documentation of the effort to implement the minimal graphics system previously discussed then follows. The documentation outlines the work done without going too deep into detail, and is followed by the largest of the tests conducted. Finally, chapter seven concludes the project with the most important project conclusions and some suggestions for future work.</p>
| Identifer | oai:union.ndltd.org:UPSALLA/oai:DiVA.org:liu-2822 |
| Date | January 2005 |
| Creators | Knutsson, Niklas |
| Publisher | Linköping University, Department of Electrical Engineering, Institutionen för systemteknik |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Student thesis, text |
Page generated in 0.0184 seconds