Return to search

The application of the critical path method to aircraft maintenance

The use of expensive and highly specialized equipment in any industry is only advisable if the eost of the equipment can be justified by a sufficiently large output. The greater the output, the smaller will be the cost of the equipment to be borne by each unit. Thus, once such equipment has been purchased, management endeavours to maintain output at a maximum in order to reduce unit costs or to increase profits.
It is for this reason that airline managements continually endeavour to increase the utilization of jet aircraft. By increasing the number of revenue flying hours only one hour each week on one jet aircraft, an airline will realize an additional net contribution to overhead (or profits) of approximately $60,000 per year.
One method of increasing utilization is to decrease the downtime of the aircraft for maintenance purposes. This requires a reduction of the total elapsed time of the maintenance check. The critical path technique has found wide application in solving the general problem of reducing the time required to complete a project which consists of many inter-related jobs. For example, the technique has been used to reduce the time required for constructing a building, for completing the periodic overhaul of a chemical plant, and for completing the Polaris Missile Development Program. It was therefore felt that the critical path technique might be of use in solving this problem of increasing the utilization of jet aircraft.
This thesis, based on the results of a study carried out at Canadian Pacific Air Lines during the months of May through August, 1963, describes the various ways in which the technique can be of use in solving this problem.
It was found that the technique did have a wide applicability. In the initial period of application, it would be of great value as a tool for analyzing the problems of the check. It can be used both to point out the jobs or chains of jobs which prohibit the reduction of the check time and also to direct the revision of the scheduling of these jobs in such a way that the elapsed time is reduced. This reduction of elapsed time will have the effect of increasing the number of jobs which must be completed at the earliest possible time if the check completion time is to be a minimum. As a result there will be a greater need to use the technique both for scheduling and monitoring all the jobs of the check. / Business, Sauder School of / Graduate

Identiferoai:union.ndltd.org:UBC/oai:circle.library.ubc.ca:2429/37114
Date January 1965
CreatorsSummers, Harold Angus Charles
PublisherUniversity of British Columbia
Source SetsUniversity of British Columbia
LanguageEnglish
Detected LanguageEnglish
TypeText, Thesis/Dissertation
RightsFor non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.

Page generated in 0.0019 seconds