This research assesses the accuracy of SRTM and AIRSAR DEMs acquired over the mountainous-hillands of Cameron Highlands with DEMs generated from Digital Aerial Photograph (DAP) with a fine (2 m) spatial resolution and height resolution of about 0.5 m. The ground control points used for generating stereo models from the DAP were acquired during field work using GPS which achieved accuracy better than 2 cm in most cases. To overcome the difficulty of overlaying the DEMs with the DAP DEM as no features can be easily identified on both the images, therefore a technique of using transects and contours generated from the DEMs were used to correct the horizontal displacement. For AIRSAR DEM, comparing the accompanying AIRSAR composite images was also employed. These then allowed an analysis of the height accuracy to be undertaken. The height of both the AIRSAR and SRTM DEMs were also corrected by applying Linear Regression Models. These models were produced by comparing pixels obtained from points, profiles and an area. Once again the corrected DEMs were assessed. Finally the extracted profiles and contours from the corrected SRTM and AIRSAR were compared with the reference DEM. From the comparisons, the horizontal errors were found to be about one and the half pixels (138.72 m: for SRTM) to the east and 1 pixel (10 m: for AIRSAR) to the south. The SD of height differences of the SRTM and AIRSAR DEMs using 90% data were 9.2 m and 5.2 m with profiles comparison; 10.4 m and 5.4 m with area comparison; 10.8 m and 2.4 m with GPS GCPs comparison respectively. From the three comparisons, the means of height differences are 5.2 m, 6.1 m and 15.2 m for SRTM and 8.1 m, 8.3 m and 7.9 m for AIRSAR DEM. The results suggest there is height offset in the AIRSAR DEM. When both heights of DEMs were corrected, the generated contours are close to each other and to reference contours. Using contour colours images and height modelling, the corrected DEM was found to have the potential to detect areas that prone to flash floods and mudslides.
| Identifer | oai:union.ndltd.org:ADTP/241718 |
| Date | January 2008 |
| Creators | Ahmad, Baharin Bin, Biological, Earth & Environmental Sciences, Faculty of Science, UNSW |
| Publisher | Publisher:University of New South Wales. Biological, Earth & Environmental Sciences |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://unsworks.unsw.edu.au/copyright, http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0013 seconds