Return to search

Tunable Diode Laser Absorption Spectroscopy Characterization of Impulse Hypervelocity CO2 Flows

Tunable diode laser absorption spectroscopy using an external cavity diode laser operating in the infra-red has been developed to monitor CO2 in the
freestream of the Longshot hypervelocity facility at the Von Karman Institute for Fluid Dynamics. The Longshot facility offers a unique European facility for ground testing and numerical validation applications, however, some of the
traditional data rebuilding aspects are in question. A non-intrusive absorption
sensor could significantly aid in improving the knowledge of freestream static values thereby improving the models used in data rebuilding and numerical simulation. The design of such a sensor also expands the spectroscopic capabilities
of the Von Karman Institute.
The absorption sensor is designed around the single P12 (00001)-(30013) rovibrational
transition near 1.6µm (6218.09cm-1 specifically) which yields relatively weak direct absorption levels at about 3.5% per meter for typical Longshot freestream conditions. However, when handled carefully, adequate signal-to-noise can be acquired to exploit significant flow information. By being able to operate in this range, total sensor cost can be easily an a factor of two or more cheaper than sensors designed for the deeper infrared. All sensor elements were mounted to a compact portable optics bench utilizing single-mode optical fibers to allow for quick installation at different facilities by eliminating tedious optical realigning. Scans at 600Hz were performed over 20ms of the 40ms test time to extract core static temperature, pressure and velocity.
These results are compared with the current state of the Longshot data rebuild method. The non-uniform flow properties of the shear layer and test cabin rested gas accumulation was of an initial concern. The temperature and density gradients along with significant radial velocity components could result in DLAS temperature, pressure and velocity that are significantly different than that of the target freestream inviscid core values. Fortunately, with the proper selection of the P12 rotational number, this effect could be more or less ignored as
the higher temperature and lower density gas of this region is relatively transparent.
Ultimately, acquired temperature and density were moderately accurate when compared to Longshot rebuilt results owing primarily to the baseline extraction which poses issues for such low absorption signals. However, the extracted velocity data are quite accurate. This is a definite puls for the sensor as the freestream enthalpy of cold hypersonic facilities is dictated primarily by the kinetic energy contribution. Being able to compare velocity gives insight to the level of vibration non-equilibrium in the flow. The velocity of the DLAS and the Longshot rebuild are quite close. This adds more weight to the argument that vibrational excitation is very low (if present at all) in the free stream and that the van de derWaals equation of state usage and constant specific heat assumption might be an adequate model for the data rebuild after all.

Identiferoai:union.ndltd.org:BICfB/oai:ulb.ac.be:ETDULB:ULBetd-09102009-104551
Date11 September 2009
CreatorsMeyers, Jason
ContributorsFrank Dubois, Uwe Koch, Ajmal Mohamed, Michel Herman, Doug Fletcher, Gérard Degrez
PublisherUniversite Libre de Bruxelles
Source SetsBibliothèque interuniversitaire de la Communauté française de Belgique
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://theses.ulb.ac.be/ETD-db/collection/available/ULBetd-09102009-104551/
Rightsunrestricted, J'accepte que le texte de la thèse (ci-après l'oeuvre), sous réserve des parties couvertes par la confidentialité, soit publié dans le recueil électronique des thèses ULB. A cette fin, je donne licence à ULB : - le droit de fixer et de reproduire l'oeuvre sur support électronique : logiciel ETD/db - le droit de communiquer l'oeuvre au public Cette licence, gratuite et non exclusive, est valable pour toute la durée de la propriété littéraire et artistique, y compris ses éventuelles prolongations, et pour le monde entier. Je conserve tous les autres droits pour la reproduction et la communication de la thèse, ainsi que le droit de l'utiliser dans de futurs travaux. Je certifie avoir obtenu, conformément à la législation sur le droit d'auteur et aux exigences du droit à l'image, toutes les autorisations nécessaires à la reproduction dans ma thèse d'images, de textes, et/ou de toute oeuvre protégés par le droit d'auteur, et avoir obtenu les autorisations nécessaires à leur communication à des tiers. Au cas où un tiers est titulaire d'un droit de propriété intellectuelle sur tout ou partie de ma thèse, je certifie avoir obtenu son autorisation écrite pour l'exercice des droits mentionnés ci-dessus.

Page generated in 0.0025 seconds