The research focused on evaluating the feasibility into Microwave Monolithic Integrated Circuits (MMIC) fabrication capability, in the UK, using novel material type: all ternary In0.52Al0.48As/In0.53Ga0.47As lattice matched to InP substrate double heterojunction bipolar transistor (DHBT) technology; with the potential for providing high speed HBTs. The demonstration of a MMIC capability would follow with the development of a BiFET process that would satisfy SELEX Galileo circuit business needs. The research project complexity is divide into 5 phases: phase 1, the development of a high frequency In0.52Al0.48As / In0.53Ga0.47As lattice matched to InP substrate DHBT technology; phase 2, development of passive components; phase 3, the creation of two VBIC physical models; phase 4, the creation of a Process Development Kit (PDK) and phase 5, the design, simulation and fabrication of a divide-by-2 frequency divider using the technology developed in phase 1. Phase 1, concluded with a DHBT epitaxial design and fabrication that produced devices with a peak high frequency performance f_t = 140GHz and f_max = 95GHz at a current density Jc ≈ 1mA/µm2. This was achieved through the optimisation of the epitaxial design to reduce the base transit time τb through the introduction of a quasi electric field and thinning of base layer. To the best of the author’s knowledge, this is the highest f_t performance for a 1µm emitter width all ternary In0.52Al0.48As / In0.53Ga0.47As DHBT. The design, simulation and fabrication of a divide-by-2 frequency divider were only made possible by the successfully development of passive components (phase 2) and the VBIC model and PDK creation (phase 3 and 4). The divide-by-2 frequency divider design and simulation was done via the use of the PDK. The simulations resulted in a divide-by-2 frequency divider with a maximum operating frequency of 27GHz at a minimum input power of 2dBm. The fabrication of the MMIC resulted in a transistor component yield of 69%, which unfortunately resulted in a divide-by-2 frequency divider circuit yield of 0%. The fabrication of MMIC circuits is not possible with current state of the fabrication environment; however the only obstacle the University of Manchester (UoM) faces is low active component yield. To increase the active component yield to the 95% level required for high circuit yields, large capital investment into the fabrication equipment and human time into setting up the fabrication process to a repeatable and reliable standard is required.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:568568 |
| Date | January 2012 |
| Creators | Knight, Robert John |
| Contributors | Missous, Mohamed |
| Publisher | University of Manchester |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | https://www.research.manchester.ac.uk/portal/en/theses/the-development-of-a-novel-all-ternary-inalasingaas-double-heterojunction-bipolar-transistor-dhbt-for-the-design-simulation-and-fabrication-of-a-static-divideby2-frequency-divider(5b2d74ab-ca13-4c1a-8b79-368687255172).html |
Page generated in 0.0022 seconds