Emulsion explosives have become the preferred choice as blasting agents for numerous industries including mining, agriculture, and construction. One of the most important components in such an emulsion is an emulsifier, which controls the emulsification properties of the explosive. The present study involves the production of one such emulsifier, which is produced by reacting two immiscible liquids, PIBSA (polyisobutylene succinic anhydride) and MEA (monoethanolamine). The study examines the effect of design variable such as the impeller speed, impeller type and the dispersed phase volume fraction on interfacial area. Experiments were carried out in a 0.15 m diameter fully baffled stirred tank using a 6-bladed Rushton turbine impeller and a marine propeller. Drop size was determined using a microscope with a video camera and image processing system. The transient concentration of PIBSA was determined using FTIR analysis and used to estimate the volume fraction of the dispersed phase (Ö). The effective interfacial area was calculated using the Sauter mean drop diameter, d32 and Ö. Impeller speeds ranging from 150 to 600 rpm and dispersed phase volume fractions, Ö ranging from 0.01 to 0.028 were examined in the experimental study. It was found that that the evolution of Sauter mean drop diameter, d32 has four different trends depending on Ö and impeller speed. At high impeller speeds and high Ö, d32 values decrease initially and reach constant values after a long period of time. This trend is consistent with the findings in previous investigations. Under certain operating conditions, d32 values increase initially with stirring time to reach a maximum value and then decrease to reach a steady state value. The presence of these trends has been attributed to the effect of changing physical properties of the system as a result of chemical reaction. Results indicate that, in general, Sauter mean drop diameter d32 decreases with an increase in agitation intensity. However a decrease in the dispersed phase volume fraction is found to increase d32. These trends are found to be the same for both impeller types studied. Comparing the drop size results produced by the two impellers, it appears that low-power number propeller produces s ignificantly smaller drops than the Rushton turbine. It was found that the concentrations of reactants decrease with time for all impeller speeds thereby leading to a decrease in interfacial area with the progress of the reaction. Interfacial area values obtained at higher impeller speeds are found to be lower in spite of lower d32 values at these speeds. Also, these values decrease with time and become zero in a shorter duration indicating the rapid depletion of MEA. The interfacial area values obtained with the propeller at a given impeller speed are lower as compared to those for Rushton turbine. They also decrease and become zero in a shorter duration as compared to those for Rushton turbine suggesting propeller¡¦s performance is better in enhancing the reaction rate.
| Identifer | oai:union.ndltd.org:ADTP/210374 |
| Date | January 2007 |
| Creators | Rajapakse, Achula, s9508428@student.rmit.edu.au |
| Publisher | RMIT University. Civil Environmental and Chemical Engineering |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://www.rmit.edu.au/help/disclaimer, Copyright Achula Rajapakse |
Page generated in 0.0016 seconds